Search results for "solu"

PNIPAM Copolymers Containing Light-Responsive Chromophores: A Method Toward Molecular Logic Gates

2010

A series of thermo-responsive PNIPAM copolymers containing different amounts of fulgimide moieties has been synthesized via a polymer analogous reaction of poly(pentafluorophenyl acrylate). All copolymers were designed to exhibit a lower critical solution temperature (LCST) in water, which was only weakly dependent on the amount of incorporated chromophoric fulgimide groups. The copolymers showed a photocyclization of the fulgimide side groups upon irradiation with UV-light accompanied with a color change. The closed form of the chromophore had a halftime of 136 min for the visible reisomerization and did not affect the LCST of the polymer. This led to the realization of a logic "NOT A" for…

Temperature- and Light-Responsive Polyacrylamides Prepared by a Double Polymer Analogous Reaction of Activated Ester Polymers

2009

Two different series of polyacrylamides containing different amounts of salicylideneaniline moieties have been synthesized via a double polymer analogous reaction of poly(pentafluorophenyl acrylate) (PPFPA). All copolymers were designed to exhibit a lower critical solution temperature (LCST) in aqueous solution, which was dependent on (i) the amount of incorporated chromophoric salicylideneaniline groups and (ii) the isomerization state of the respective salicylideneaniline group. Higher LCST values were measured for UV-irradiated solutions of the copolymers in comparison to the nonirradiated copolymer solutions. A maximum difference in the LCST of up to 13 °C was found for poly(N-cycloprop…

1978

The phenomenon of co-nonsolvency, i.e. the formation of nonsolvents by mixing two solvents, was studied for the system N,N-dimethylformamide/cyclohexane/polystyrene (DMF/CH/PS) which is characterized by the fact that the components of the mixed solvent are only incompletely miscible below 48,6°C. A number of quasibinary sections (stepwise addition of the second solvent to given solutions of the polymer in the first solvent) for a sample (M = 110000) of high molecular uniformity yielded a cloud point surface which gives “island curves” (closed solubility gaps) for constant temperatures between the critical temperature of DMF/CH and the top of the cloud point surface (51,3°C). The attainment …

Lattice fluid model generalized for specific interactions: An application to ternary polymer solutions

2011

Abstract The phase diagram of the Poly- l -Lactic-Acid (PLLA), dioxane and water system was derived by using the lattice fluid model generalized for specific interactions. A qualitative analysis of Hansen solubility parameters together with empirical observations were adopted to reduce the number of adjustable parameters. The as-selected model parameters were derived by fitting a set of cloud point curves; consequently, the complete phase diagram of the system was computed. The use of specific interactions between species gave out a quantitative agreement with a set of experimental data, whereas changing the polymer polydispersity the agreement is only qualitative. In principle, the present…

The effect of pressure on the liquid–liquid phase equilibrium of two polydisperse polyalkylsiloxane blends

2002

The effect of pressure-induced immiscibility in polymer blends is investigated by experimental and theoretical methods. Experimental data of cloud point curves and critical points are obtained by turbidity measurements. The chosen system is a mixture of polydimethylsiloxane and polyhexylmethylsiloxane which is one of the very few polymer blends exhibiting pressure-induced immiscibility. This unusual behaviour is related to a critical temperature minimum of the critical curve and cloud point isopleths at positive pressure in the temperature–pressure diagram. The effect of the chain length on the critical temperature minimum is investigated here based on theoretical models. The effect of diff…

Quick and reliable routes to phase diagrams for polyethersulfone and polysulfone membrane formation

2000

Phase diagrams were measured and calculated for the ternary membrane forming systems DMF/water/polysulfone and DMF/water/polyethersulfone at different temperatures. Customary experiments yielded cloud point curves, tie lines, and critical compositions. The theoretical computation starts from the Flory-Huggins theory and employs binary interaction parameters g ij that vary with the composition. This information was mainly obtained by means of Headspace-Gas Chromatography (HSGC, yielding the partial pressures of the volatile components); these data were complemented by light scattering and swelling experiments. The calculation of binodals, spinodals, tie lines, and critical points avoids the …

Polydispersity effects on the phase diagram of the system chloroform/poly-l-(lactic acid)/poly(methyl methacrylate) and morphology of PLA/PMMA films

2000

Abstract Cloud point curve, critical composition and several critical coexistence curves were measured at 25°C for the ternary system poly- l -(lactic acid) (PLA), poly(methyl methacrylate) (PMMA) — where both polymers exhibit broad molecular weight distributions — and the common solvent chloroform. In contrast to the situation encountered in the absence of the second polymer both branches of the critical coexistence curves are located without any doubt inside the miscibility gap as defined by the cloud point curve. This unexpected experimental finding is corroborated by model calculations on the basis of continuous thermodynamics. The removal of solvent from the ternary mixtures yields fil…

Shear Effects on the Phase Diagrams of Solutions of Highly Incompatible Polymers in a Common Solvent. 1. Equilibrium Behavior and Rheological Propert…

1997

Phase diagrams (cloud points, tie lines, critical compositions) and viscosities of homogeneous solutions were determined at temperatures ranging from 20 to 100 °C for three representatives of the ternary system cyclohexanone/polystyrene/poly(n-butyl methacrylate) [CHO/PS/PBMA] in preparation of a study on shear influences. An only moderate increase of the two-phase region observed upon heating (LCST behavior) witnesses little heat effects upon mixing. Tie lines which are nearly parallel to the PS/PBMA edge of the Gibbs phase triangle indicate comparable solvent quality of CHO for both polymers. The quantitative mathematical description of the equilibrium behavior-required for a theoretical …

Amphiphilic derivatives of a polyaspartamide: their aggregation and solubilization ability

2006

Abstract The self-aggregation and solubilization capability of a series of amphiphilic copolymers obtained by derivatisation of polymeric chain of α,β-poly(N-2-hydroxyethyl)- dl -aspartamide (PHEA) with polyethylene glycols (PEG, being different molecular weight 2000 or 5000 Da, PEG2000 and PEG5000, respectively) and/or hexadecylamine alkyl chain (C16), namely PHEA–PEG2000, PHEA–PEG5000, PHEA–C16, PHEA–PEG2000–C16 and PHEA–PEG5000–C16, have been evidenced by performing systematic tensiometric and spectrophotometric studies. All measurements have been performed at 25.0 °C over a wide copolymer concentration range. The tensiometric results have shown that, for all copolymers studied, the surf…

α,ω-Functionalized poly-N-isopropylacrylamides: controlling the surface activity for vesicle adsorption by temperature

2003

The synthesis of alpha,omega-end-functionalized copolymers of N-isopropylacrylamide and N-(3-dimethylaminopropyl)acrylamide was performed. Monomer ratios of 100:0, 96:4, and 81:19 were investigated. The lower critical solution temperature (LCST) of these polymers was determined by cloud-point measurements and by microcalorimetric measurements. The LCST increased from 32 over 37 to 47 degrees C as the hydrophobicity increased with increasing amount of comonomer N-(3-dimethylaminopropyl)acrylamide. The polymers could successfully be adsorbed onto gold surfaces. Finally, vesicle adsorption onto these self-assembled polymer films on flat gold surfaces was investigated as the vesicle solution te…