Search results for "tecnica"
showing 10 items of 2886 documents
Modelling load-transmission mechanisms in axially loaded RC columns retrofitted with steel jackets
2018
The use of steel jacketing technique is a common practice for retrofitting existing reinforced concrete (RC) columns, as it allows increasing load-carrying capacity and ductility of the member. When the external jacket has no-end connections – i.e. the jacket is indirectly loaded- the load sustained by the column is transferred from the inner RC core to the external jacket through shear stresses along the contact surface. The assessment of this mechanism is quite complex, due to the marked non-linear behaviour of constituent materials and to the calibration of a proper shear stress-relative slip constitutive law of the concrete-to-steel interface. In this paper, a step-by-step analytical ap…
The bearing capacity of footings on sand with a weak layer
2017
Minor details of the ground, such as thin weak layers, shear bands and slickensided surfaces, can substantially affect the behaviour of soil–footing and other geotechnical systems, despite their seeming insignificance. In this paper, the influence of the presence of a thin horizontal weak layer on the ultimate bearing capacity of a strip footing on dense sand is investigated by single-gravity tests on small-scale physical models of the soil–footing system. The test results show that the weak layer strongly influences both the failure mechanism and the ultimate bearing capacity if its depth is lower than about four times the footing width. It is found that the presence of a thin weak layer …
A risk assessment proposal for underground cavities in Hard Soils-Soft Rocks
2018
Abstract Underground calcarenite quarries in Marsala (Sicily) have been involved in a number of collapses that have, seriously damaged numerous buildings. The stability conditions were therefore examined in order to assess risk conditions within the historical centre of the town and the surrounding areas, which are subject to urban expansion. Starting with an extensive collection of historical information, the research was carried out through surveys of the cavities, systematic sampling of material, petrographic analysis and geotechnical testing. The results of laboratory tests and in situ investigations provided a geotechnical characterization of both the intact material and the rock mass.…
On the reactivation of a large landslide induced by rainfall in highly fissured clays
2018
Abstract The paper discusses the field investigations, geotechnical characterization and time evolution of horizontal displacements in a wide landslide. The latter, triggered by an earthquake occurring in September 2002, is located in Sicily and involves a thick body of stiff and highly fissured clays belonging to a Varicoloured Clay formation. In order to characterise the reactivation of landslide mechanisms induced by rainfall, a three-year monitoring programme (2008–2011) was implemented to measure rain, pore water pressures, and deep and superficial displacements. The monitoring data made it possible to recognize three distinct landslides, which evolve at variable rates in different dir…
Role of particle characteristics in the compression behaviour of gap-graded sands
2019
Abstract The compression in gap-graded mixtures of sands with combined mineralogy has been investigated in recent research, focusing on the key factors that might imply the occurrence of convergent or non-convergent paths in compression (i.e., transitional or non-transitional behaviour). From previous work, the mineralogy of a matrix composed of larger grains seems to determine the possibility of the occurrence of transitional behaviour. Hence, if there is a strong and stiff matrix made of quartz sand particles, which are either larger than or at least of similar size to the other component, then non-convergent compression paths (i.e., transitional behaviour) are likely to occur. As a furth…
Seismic behavior of structures equipped with variable friction dissipative (VFD) systems
2021
Usually, to mitigate the stresses in framed structures, different strategies are used. Among them, base isolation, viscous/friction/metallic yielding dampers and tuned mass dumpers have been widely investigated. Fluid Viscous Dampers (FVD) probably result the most diffused for the simplicity in the applications. However, these type of dampers request limited interstorey drifts to avoid dangerous effects. Further, they have an elevate cost. On the contrary, friction dampers are not so expensive but request high interstorey drifts to give a significant contribute in the dissipation of energy during an earthquake. In this paper an approach for the energy dissipation by friction, modified with …
Microbial Activation of Wooden Vats Used for Traditional Cheese Production and Evolution of Neoformed Biofilms.
2016
ABSTRACT Three Lactococcus lactis subsp. cremoris strains were used to develop ad hoc biofilms on the surfaces of virgin wooden vats used for cheese production. Two vats (TZ) were tested under controlled conditions (pilot plant), and two vats (TA) were tested under uncontrolled conditions (industrial plant). In each plant, one vat (TA1 and TZ1) was used for the control, traditional production of PDO Vastedda della Valle del Belìce (Vastedda) cheese, and one (TA2 and TZ2) was used for experimental production performed after lactococcal biofilm activation and the daily addition of a natural whey starter culture (NWSC). Microbiological and scanning electron microscopy analyses showed differenc…
Valorization of indigenous dairy cattle breed through salami production
2016
The aim of the research was to produce salami manufactured with meat of three different commercial categories of bovine breed: cow on retirement, beef and young bull. A total of six experimental productions, at small-scale plant, were carried out with and without starter culture inoculums. The evolution of physico-chemical parameters in all trials followed the trend already registered for other fermented meat products. Several LAB species were found during process with different levels of species diversity and frequency of isolation among inoculated (mainly Pediococcus pentosaceus and Staphylococcus xylosus) and uninoculated (mainly Enterococcus devriesei, Lactobacillus curvatus and Lactoba…
Refining the genetic structure and relationships of European cattle breeds through meta-analysis of worldwide genomic SNP data, focusing on Italian c…
2020
AbstractThe availability of genotyping assays has allowed the detailed evaluation of cattle genetic diversity worldwide. However, these comprehensive studies did not include some local European populations, including autochthonous Italian cattle. In this study, we assembled a large-scale, genome-wide dataset of single nucleotide polymorphisms scored in 3,283 individuals from 205 cattle populations worldwide to assess genome-wide autozygosity and understand better the genetic relationships among these populations. We prioritized European cattle, with a special focus on Italian breeds. Moderate differences in estimates of molecular inbreeding calculated from runs of homozygosity (FROH) were o…
Fifteen Shades of Grey: Combined Analysis of Genome-Wide SNP Data in Steppe and Mediterranean Grey Cattle Sheds New Light on the Molecular Basis of C…
2020
Coat color is among the most distinctive phenotypes in cattle. Worldwide, several breeds share peculiar coat color features such as the presence of a fawn pigmentation of the calf at birth, turning over time to grey, and sexual dichromatism. The aim of this study was to search for polymorphisms under differential selection by contrasting grey cattle breeds displaying the above phenotype with non-grey cattle breeds, and to identify the underlying genes. Using medium-density SNP array genotype data, a multi-cohort FST-outlier approach was adopted for a total of 60 pair-wise comparisons of the 15 grey with 4 non-grey cattle breeds (Angus, Limousin, Charolais, and Holstein), with the latter sel…