Search results for "theoretical"
showing 10 items of 11439 documents
Thermodynamic Characterization Of Two Layers Of CO2 On A Graphite Surface
2014
We find by examination of density profiles that carbon dioxide adsorbs on graphite in two distinct layers. We report the activity coefficient, entropy and enthalpy for CO2 in each layer using a convenient computational method, the Small System Method, thereby extending this method to surfaces. This opens up the possibility to study thermodynamic properties for a wide range of surface phenomena. © 2014 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/3.0/).
Effect of the reference solution in the measurement of ion activity coefficients using cells with transference at T=298.15K
2010
Abstract This work reports individual activity coefficients of ions at T = 298.15 K in aqueous solutions obtained from voltage values of the respective half-cell ion-selective-electrode and a single-junction Ag–AgCl reference electrode, filled with different reference solutions at different concentrations. For potassium and chloride ions in KCl aqueous solutions, reference solutions of KCl, NaCl, or CsCl were used. For sodium and chloride ions in aqueous NaCl solutions, reference solutions of CsCl were used. Experimental runs were performed at molalities (1, 2, and 3) m of the reference solution. The concentration of the sample solution was increased, starting from around 1 · 10−3 m, up to …
Energetics of sodium dodecylsulfate-dodecyldimethylamine oxide mixed micelle formation
1994
Enthalpies of dilution and osmotic coefficients of the sodium dodecyl-sulfate (NaDS)-dodecyldimethylamine oxide (DDAO) mixtures in water have been measured at 25 and 37°C, respectively. From the enthalpies of dilution the apparent molar relative enthalpies LΦ were calculated. The change of the LΦ vs. total molality mt profiles with the mole fraction reflects the variation of the ionic character of the mixed micelles. From the osmotic coefficients the nonideal free energy G2ni were calculated. By combining G2ni with the partial molar relative enthalpies, the nonideal entropies TS2ni were determined. At a given mole fraction, G2ni and TS2ni values are decreasing and increasing respectively, t…
Thermodynamic properties of N-octyl- and N-dodecylnicotinamide chlorides in water
1990
Densities, heat capacities and enthalpies of dilution at 25°C and osmotic coefficients at 37°C were measured for N-octyl- and N-dodecylnicotinamide chlorides in water over an extended concentration region. Partial molar volumes, heat capacities, relative enthalpies and nonideal free energies and entropies at 25°C were derived as a function of the surfactant concentration. For both surfactants, plots of volumes, enthalpies and free energies vs. concentration are regular whereas those of heat capacities and entropies present anomalies at about 0.8 and 0.1m for the octyl and dodecyl compounds, respectively. Changes in the slope of a plot of osmotic coefficients times molality vs. molality were…
Prediction of Maxwell – Stefan diffusion coefficients in polymer – multicomponent fluid systems
2014
Abstract Calculations of mass fluxes in multicomponent fluids based on the system of generalized Maxwell–Stefan equations (GMSE) is preferably used because Maxwell–Stefan (M–S) diffusion coefficients are symmetrical and have a clear physical meaning, as they reflect the binary friction forces between compounds in the system. For the calculation of the mass transport of a multicomponent fluid in the polymer basing on GMSE, it is necessary to have M–S diffusion coefficients. This paper proposes a method that allows their calculation using widely available self-diffusion coefficients and binary diffusion coefficients for infinitely diluted mixtures. The proposed method was compared with the me…
Calculations of organic-solvent dispersions of single-wall carbon nanotubes
2005
The aqueous solubility Sw and 1-octanol–(Po), cyclohexane–(Pch), and chloroform–(Pcf) water partition coefficients are calculated. The properties of single-wall carbon nanotubes (SWNT) are related to the indices (n, m) designating the chiral vector. SWNTs are classified in zigzag (n, 0), armchair (n, n), and chiral (n, m). These properties permit classifying SWNTs according to (n, m). Correlations between (n2 + nm + m2)1/2, log Sw, log Po, log Pch, and log Pcf show that (n, m) are adequate indices. The (10,10) is the most abundant SWNT, presenting consistency between great kinetic stability, small Sw, and great {Po, Pch, Pcf}. The room temperature solubility of SWNTs is investigated in a va…
Phase equilibrium for the systems diisopropyl ether, isopropyl alcohol+2,2,4-trimethylpentane and +n-heptane at 101.3kPa
2010
Abstract Consistent vapour–liquid equilibrium data for the ternary systems diisopropyl ether + isopropyl alcohol + 2,2,4-trimethylpentane and diisopropyl ether + isopropyl alcohol + n-heptane are reported at 101.3 kPa. The vapour–liquid equilibrium data have been correlated by Wilson, NRTL and UNIQUAC equations. The ternary systems do not present ternary azeotropes.
Phase equilibria in the ternary system isobutyl alcohol+isobutyl acetate+1-hexanol and the binary systems isobutyl alcohol+1-hexanol, isobutyl acetat…
2005
Abstract Consistent vapor–liquid equilibrium (VLE) data at 101.3 kPa have been determined for the ternary system isobutyl alcohol (IBA) + isobutyl acetate (IBAc) + 1-hexanol and two constituent binary systems: IBA + 1-hexanol and IBAc + 1-hexanol. The IBA + 1-hexanol system exhibits no deviation from ideal behaviour and IBAc + 1-hexanol system show lightly positive deviation from Raoult's law. The activity coefficients of the solutions were correlated with its composition by the Wilson, NRTL, UNIQUAC models. The ternary system is well predicted from binary interaction parameters. 1-Hexanol eliminates the IBA–IBAc binary azeotrope. However, the change of phase equilibria behaviour is small t…
Phase equilibria in the systems isobutyl alcohol+N,N-dimethylformamide, isobutyl acetate+N,N-dimethylformamide and isobutyl alcohol+isobutyl acetate+…
2005
Abstract Consistent vapor–liquid equilibria (VLE) were determined for the ternary system isobutyl alcohol (IBA) + isobutyl acetate (IBAc) + N,N-dimethylformamide (DMF) and two constituent binary systems at 101.3 kPa. The IBA + DMF system exhibits negative deviation from ideal behaviour and IBAc + DMF system deviates positively from ideal behaviour. The activity coefficients of the solutions were correlated with its composition by the Wilson, NRTL and UNIQUAC models. The ternary system is well predicted from binary interaction parameters.
Isobaric vapor–liquid equilibria for the binary systems 1-propyl alcohol+dipropyl ether and 1-butyl alcohol+dibutyl ether at 20 and 101.3kPa
2006
Abstract Isobaric vapor–liquid equilibrium measurements for the binary systems 1-propyl alcohol + dipropyl ether and 1-butyl alcohol + dibutyl ether are reported at 20 and 101.3 kPa. Both systems, which deviate positively from ideal behavior present a minimum boiling point azeotrope at both pressures, showing the azeotropic compositions a strong dependency on pressure. The activity coefficients and boiling points of the solutions were correlated with its composition by the Wilson, UNIQUAC, NRTL, and Wisniak–Tamir equations.