Search results for "tunne"

Recent Experimental Results with the PSTM: - Observation of a Step on a Quartz Surface. - Spatial Spectroscopy of Microwaveguides

1993

The Photon Scanning Tunneling Microscope (PSTM) is based on the frustration of the total internal reflected beam by the end of an optical fiber. Till today it has been used to obtain topographic information generally for smooth samples. In this paper we report two different kinds of experimental results. First, when the sample is in the form of a step, our measurements demonstrate how the images, obtained in the constant intensity mode, depend on the orientation of the incident beam of light with respect to the step. Next, we show that the first derivative of the collected intensity with respect to the probe-sample distance at each point of the sample yields to a new kind of image named her…

Determination of the spatial extension of the surface-plasmon evanescent field of a silver film with a photon scanning tunneling microscope.

1993

A photon scanning tunneling microscope is employed to probe the surface-plasmon field in the evanes- cent region of a silver film for p (parallel to the plane of incidence) and s (perpendicular to the plane of incidence) polarizations of the light beam at several angles of incidence near the critical angle. The in- teraction between the field and the probe is measured and compared to theoretical calculations involving a single four-media model. A systematic analysis of images obtained for several positions of the optical fiber above the film is presented and it is shown that, for tip-to-sample distances smaller than half the wavelength of the incoming light, the collected intensity curves a…

Resolution of the photon scanning tunneling microscope: influence of physical parameters

1992

Abstract The photon scanning tunneling microscope (PSTM) is the photon analogue of the electron scanning tunneling microscope (ESTM). It uses the evanescent field due to total internal reflection (TIR) of a light beam in a prism modulated by a sample placed on the base of the prism. Our experimental results shown details which present a lateral size as small as 200 A. The PSTM axial resolution is more difficult to evaluate. It is a function of the roughness of the sample. For very smooth samples, images shown an axial resolution of about 10 A. At last we discuss how both lateral and axial resolution can be affected by several parameters such as the tip surface distance and the roughness of …

Fractional Modeling of the AC Large-Signal Frequency Response in Magnetoresistive Current Sensors

2013

Fractional calculus is considered when derivatives and integrals of non-integer order are applied over a specific function. In the electrical and electronic domain, the transfer function dependence of a fractional filter not only by the filter order n, but additionally, of the fractional order α is an example of a great number of systems where its input-output behavior could be more exactly modeled by a fractional behavior. Following this aim, the present work shows the experimental ac large-signal frequency response of a family of electrical current sensors based in different spintronic conduction mechanisms. Using an ac characterization set-up the sensor transimpedance function  is obtain…

Coulomb blockade thermometry

1996

One dimensional arrays of normal metal tunnel junctions have been found to exhibit properties which are very suitable for primary and secondary thermometry in a lithographically adjustable temperature range which extends over about two decades. The thermometer is remarkably insensitive to nonuniformities in the actual pattern and to even strong magnetic fields. We also discuss the behaviour of this device at very low temperatures where the hot electron effect due to poor electron phonon coupling ultimately takes over and at very high temperatures where the finite tunnel barrier effects appear. Short arrays, and especially single tunnel junctions show interesting deviations from the universa…

Magnetic nanoparticles between electrodes of tunnel junction: anomalous tunnel conductance

2002

Abstract Magnetic particles of microscopic size can be created in the process of Ni, Fe and Co mechanically controllable break junctions fabrication and trapped between the electrodes by magnetic dipole forces. Tunneling between the protruding nanoparticle and the sample electrode shows clear distinctions from the usual junctions: heavy deviation of the current–distance I(z) dependence from the expected exponential behavior at electrode separations z below 4.0– 4.5 A and on numerous occasions a sudden jump-like decrease of the tunnel current at z≈1.5– 2.0 A . Possible mechanisms behind observed anomalies including the short-range magnetic exchange coupling are discussed.

Nanosession: Spin Tunneling Systems

2013

SAMs Based Device Fabrication and Characterization

2015

Despite the high potentiality of SAMs for spintronics, not many results exist at the moment in the literature. This lack of results is mainly due to the difficulty to fabricate the devices. The two main technological problems consist in the ferromagnetic electrodes compatibility issues with wet chemistry and the short-circuit formation during top electrode deposition. A part of this thesis has been committed to overcome these technological problems. This chapter will explain the steps that led us to the development of SAMs-based magnetic tunnel nanojunctions.

Probing the electronic states of high-TMR off-stoichiometric Co2MnSi thin films by hard x-ray photoelectron spectroscopy

2014

The tunnel magnetoresistance ratio (TMR) of fully epitaxial magnetic tunnel junctions with an off-stoichiometric Co${}_{2}$MnSi Heusler alloy has been shown to exhibit a systematic dependence on Mn content, reaching 1135% at 4.2 K for Co${}_{2}$Mn${}_{1.29}$Si. In this paper, we explain the behavior of the observed TMR ratio using ab initio calculations and hard x-ray photoelectron spectroscopy (HAXPES). For the Mn-deficient samples, we show that the the drop of the TMR is caused by Co antisite atoms, which impose extra states into the minority-spin band gap. On the other hand, Mn-excess composition shows nearly half-metallic behavior. This result can be intuitively understood since both Co…

Introduction to Self-Assembled Monolayers

2015

One of the most exciting targets of molecular spintronics field is to go towards multifunctional devices where the properties can be accurately controlled and actively changed. Spin dependent hybridization at the metal/molecule interface could thus be used in the tailoring of the resistive and magnetoresistive response of spintronic devices exploiting chemistry versatility. In this new direction, Self-Assembled Monolayers (SAMs) appear as highly promising candidates since each part and function of this system can be modulated independently (like a molecular LEGO building unit). Despite highly promising, they are still scarcely investigated in the literature probably due to the difficulties …