Search results for "vapor"

Biological and chemical characterization of new isolated halophilic microorganisms from saltern ponds of Trapani, Sicily

2021

Abstract Halophilic microorganisms inhabiting hypersaline environments such as salt lakes, Dead Sea, or salt evaporation ponds, have acquired specific cell adaptation to grow within stressful conditions. In this study, we isolated heterotrophic and autotrophic microorganisms from several saltern ponds located at the Natural Reserve “Saline di Trapani e Paceco”, Sicily, Italy. The aim of the study was to investigate the biotechnological potential of new microbial strains from saltern ponds, by capturing their biological and chemical diversity. After the isolation and identification of the sampled strains, their growth capacity was determined under low and high salinity conditions. The metabo…

Influence d'humidité de l'air sur le séchage d'une goutte déposée sur une surface solide et sur la destruction microbienne.

2017

International audience; This study was carried out in order to develop experimental methodology using a camera to monitor the evolution of the surface of a liquid droplet deposited on a solid surface composed of polypropylene. The droplet was exposed to various ambient relative humidity conditions (11.3%, 43.2%, 68.9% and 75.5%). Two types of liquid were investigated: distilled water and water containing nutritive substances (salmon “juice”). At 11.3% relative humidity, it takes 40% longer to evaporate a water droplet (initial weight 0.36 g, volume 360 μL, radius 6.5 × 10−3 m) than a salmon “juice” droplet (3.66 h for distilled water, 2.83 h for salmon “juice”). In the case of the distilled…

2020

Abstract. Cirrus clouds and their potential formation regions, so-called ice supersaturated regions (ISSRs), with values of relative humidity with respect to ice exceeding 100 %, occur frequently in the tropopause region. It is assumed that ISSRs and cirrus clouds can change the tropopause structure by diabatic processes, driven by latent heating due to phase transition and interaction with radiation. For many research questions, a three-dimensional picture including a sufficient temporal resolution of the water vapour fields in the tropopause region is required. This requirement is fulfilled nowadays by reanalysis products such as the European Centre for Medium-Range Weather Forecasts (ECM…

Modeling of biomass smoke injection into the lower stratosphere by a large forest fire (Part II): Sensitivity studies

2006

Abstract. The Chisholm forest fire that burned in Alberta, Canada, in May 2001 resulted in injection of substantial amounts of smoke into the lower stratosphere. We used the cloud-resolving plume model ATHAM (Active Tracer High resolution Atmospheric Model) to investigate the importance of different contributing factors to the severe intensification of the convection induced by the Chisholm fire and the subsequent injection of biomass smoke into the lower stratosphere. The simulations show strong sensitivity of the pyro-convection to background meteorology. This explains the observed coincidence of the convective blow-up of the fire plume and the passage of a synoptic cold front. Furthermor…

Experimental characterization of electronic, structural and optical properties of individual carbon nanotubes

2014

Towards large‐scale steady‐state enhanced nuclear magnetization with in situ detection

2021

Magnetic resonance in chemistry 59(12), 1208 - 1215 (2021). doi:10.1002/mrc.5161

Design, characterization, and first field deployment of a novel aircraft-based aerosol mass spectrometer combining the laser ablation and flash vapor…

2021

In this paper, we present the design, development, and characteristics of the novel aerosol mass spectrometer ERICA (ERC Instrument for Chemical composition of Aerosols; ERC – European Research Council) and selected results from the first airborne field deployment. The instrument combines two well-established methods of real-time in situ measurements of fine particle chemical composition. The first method is the laser desorption and ionization technique, or laser ablation technique, for single-particle mass spectrometry (here with a frequency-quadrupled Nd:YAG laser at λ = 266 nm). The second method is a combination of thermal particle desorption, also called flash vaporization, and electro…

An alternative conception of PM10 concentration changes after short-term precipitation in urban environment

2018

Abstract In the article, a linear model is presented which describes a reduction of PM10 mass concentration in relation to the type of precipitation and water vapour content in the air. The model was built using covariance analysis. In studies of PM10 concentration changes, the results of 247 observations were used, which were carried out in the urban area. Concentration changes were archived during short-term (30 min) convection and large-scale rainfalls. For the determination of PM10 mass concentration, the reference method was used. To describe changes in PM10 concentration in the air after precipitation, a series of linear models were created, in which the explanatory variables were: th…

Monte Carlo simulations of the solid-liquid transition in hard spheres and colloid-polymer mixtures

2010

Monte Carlo simulations at constant pressure are performed to study coexistence and interfacial properties of the liquid-solid transition in hard spheres and in colloid-polymer mixtures. The latter system is described as a one-component Asakura-Oosawa (AO) model where the polymer's degrees of freedom are incorporated via an attractive part in the effective potential for the colloid-colloid interactions. For the considered AO model, the polymer reservoir packing fraction is eta_p^r=0.1 and the colloid-polymer size ratio is q=sigma_p/\sigma=0.15 (with sigma_p and sigma the diameter of polymers and colloids, respectively). Inhomogeneous solid-liquid systems are prepared by placing the solid fc…

Fabrication and characterization of vacuum deposited fluorescein thin films

2011

Simple vacuum evaporation technique for deposition of dyes on various solid surfaces has been developed. The method is compatible with conventional solvent-free nanofabrication processing enabling fabrication of nanoscale optoelectronic devices. Thin films of fluorescein were deposited on glass, fluorine-tin-oxide (FTO) coated glass with and without atomically layer deposited (ALD) nanocrystalline 20 nm thick anatase TiO2 coating. Surface topology, absorption and emission spectra of the films depends on their thickness and the material of supporting substrate. On a smooth glass surface the dye initially formes islands before merging into a uniform layer after 5 to 10 monolayers. On FTO cove…