0000000000289190
AUTHOR
Isabel Vázquez
Deep oxidation of volatile organic compounds using ordered cobalt oxides prepared by a nanocasting route
Ordered Co3O4 with high surface area (until 173 m2/g) has been successfully obtained through a nanocasting route using mesoporous KIT-6 silica as a hard template and tested in the deep oxidation of a series of representative volatile organic compounds (VOCs): propane as a model of short chain alkane and toluene as a model of monoaromatic hydrocarbon. It has been demonstrated that the catalytic activity for VOC deep oxidation is very elevated and its catalytic stability at moderate temperatures very good. However, the role of the ordered structure in the catalytic performance does not seem to be beneficial. The enhanced catalytic activity has been explained in terms of both the high surface …
Promoting the activity and selectivity of high surface area Ni–Ce–O mixed oxides by gold deposition for VOC catalytic combustion
Gold supported on nickel cerium oxide catalysts (Ni–Ce–O) have been studied for the total oxidation of propane, as a model for hydrocarbon volatile organic compound emission control. High surface area Ni–Ce–O catalysts were synthesized using a very simple evaporation method, where cerium and nickel salts were evaporated in the presence of a mixture of methanol and oxalic acid. Gold catalysts were prepared following a deposition–precipitation method. A very efficient catalyst for the oxidation of propane, in terms of both activity and selectivity, was obtained. This high activity has been related to the high surface area of the catalyst (and therefore to the presence of more active sites ava…
Enhanced NiO Dispersion on a High Surface Area Pillared Heterostructure Covered by Niobium Leads to Optimal Behaviour in the Oxidative Dehydrogenation of Ethane
[EN] A Nb-containing siliceous porous clay heterostructure (PCH) with Nb contents from 0 to 30 wt %) was prepared from a bentonite and used as support in the preparation of supported NiO catalysts with NiO loading from 15 to 80 wt %. Supports and NiO-containing catalysts were characterised by several physicochemical techniques and tested in the oxidative dehydrogenation (ODH) of ethane. The characterisation studies on Nb-containing supports showed the presence of well-anchored Nb(5+)species without the formation of Nb(2)O(5)crystals. High dispersion of nickel oxide with low crystallinity was observed for the Nb-containing PCH supports. In addition, when NiO is supported on these Nb-containi…
Total oxidation of naphthalene using bulk manganese oxide catalysts
Several Mn2O3 catalysts have been synthesized using different preparation methods and tested for the total oxidation of naphthalene, a model polycyclic aromatic compound. The catalysts have been characterized by several physico-chemical techniques such as XRD, TPR, XPS, EDX and TEM. The surface area of the catalyst seems to be of paramount importance, since the mass normalized activity of catalysts increases as the surface area of the Mn2O3 catalysts increases. Consequently, a high surface area ordered mesoporous Mn2O3 catalyst, obtained through a nanocasting route using mesoporous KIT-6 silica as a hard template, was the most efficient catalyst for the deep oxidation of naphthalene. In add…
Oxidative dehydrogenation of propane and n-butane on V-Mg based catalysts
Abstract The catalytic properties of vanadium supported catalysts for the oxidative dehydrogenation of propane and n-butane has been studied. Natural Sepiolite and magnesium oxalate were used as starting support materials. Large differences in the type of crystalline phases were detected on the calcined catalysts depending on the vanadium content and nature of the support. The active and selective sites for the oxidative dehydrogenation of propane and n-butane, are related with isolated V 5+ with atetrahedral coordination. The presence of vanadium species with coordination higher than 4 negatively influence the selectivity to dehydrogenation products.
Kinetic Study of the Oxidation of n-Butane on Vanadium Oxide Supported on Al/Mg Mixed Oxide
The reaction kinetics of the oxidative dehydrogenation (ODH) of n-butane over vanadia supported on a heat-treated Mg/Al hydrotalcite (37.3 wt % of V2O5) was investigated by both linear and nonlinear regression techniques. A reaction network including the formation of butenes (1-, 2-cis-, and 2-trans-butene), butadiene, and carbon oxides by parallel and consecutive reactions, at low and high n-butane conversions, has been proposed. Langmuir−Hinshelwood (LH) models can be used as suitable models which allows reproduction of the global kinetic behavior, although differences between oxydehydrogenation and deep oxidation reactions have been observed. Thus, the formation of oxydehydrogenation pro…
Total oxidation of propane using nanocrystalline cobalt oxide and supported cobalt oxide catalysts
Abstract Supported and unsupported nanocrystalline cobalt oxides have been shown to be extremely efficient catalysts for the total oxidation of propane. Total conversion with a high stability has been achieved at reaction temperatures as low as 250 °C. In the present work, a comparison between the catalytic performance of bulk and alumina-supported nanocrystalline cobalt oxide catalysts has been made. The influence of crystallite size, nature of the support (alpha, gamma and mesoporous alumina) and cobalt loading, has been probed. Unsupported cobalt oxide catalysts were more active than any supported cobalt oxide catalysts. The catalytic activity was mainly dependent on the crystallite size…
Easy Method for the Transformation of Levulinic Acid into Gamma-Valerolactone Using a Nickel Catalyst Derived from Nanocasted Nickel Oxide
Different nickel catalysts have been tested for the transformation of levulinic acid into &gamma
Stable anchoring of dispersed gold nanoparticles on hierarchic porous silica-based materials
The nanometric organization of MOx (M = Co, Zn, Ni) domains partially embedded inside the mesoporous silica walls but accessible to the pore voids, which is achieved through a simple one-pot surfactant-assisted procedure, define optimal anchors for the nucleation and growth of gold nanoparticles, which in turn favours an exceptional thermal stability for the final Au-supported materials. As silica support we have selected a UVM-7 silica having a highly accessible architecture defined by two hierarchic pore systems. The combination of nanometric pore length, tortuous mesopores and MOx inorganic anchors favours the stability of the final Au/CoOx-UVM-7 nanocomposites.
The different catalytic behaviour in the propane total oxidation of cobalt and manganese oxides prepared by a wet combustion procedure
Abstract Cobalt oxide and manganese oxide catalysts have been prepared through aqueous synthesis using a wet combustion procedure. These materials have been tested as catalysts for the total oxidation of propane. It has been observed a different catalytic behaviour between cobalt and manganese oxides although for both oxides a very high catalytic activity has been obtained. Cobalt oxides prepared by the wet combustion procedure are less reactive than a simple cobalt oxide prepared without the addition of organic acids. However, in the case of manganese oxide the use of organic acids highly increases the catalytic activity. The different catalytic behaviour has been related to the variation …
Ferric sludge derived from the process of water purification as an efficient catalyst and/or support for the removal of volatile organic compounds
Ferric chloride solutions are used as coagulants or flocculants in water treatment operations for human consumption. This treatment produces large amounts of clay-type solids formed mainly of montmorillonite with iron oxides and humic substances. This ferric sludge can be used as an efficient catalyst for the removal of volatile organic compounds (VOCs) by total oxidation. This waste isolated in the purification process has been activated by calcinations in air, characterized by several physicochemical techniques and employed as a catalyst for the removal by total oxidation of representative VOCs: toluene, propane and mixtures of toluene/propane with or without water. This ferric sludge has…
Total oxidation of naphthalene with high selectivity using a ceria catalyst prepared by a combustion method employing ethylene glycol.
Abstract During the catalytic combustion of naphthalene, compounds other than CO 2 are often obtained. These products, as polymerized polycyclic aromatic hydrocarbons, oxygenated aromatic compounds and benzene derivate compounds, are usually more toxic than naphthalene. At the present work it is shown a nanocrystalline cerium oxide prepared by a combustion method employing a proper ethylene glycol concentration that exhibits very high activity in the decomposition of naphthalene in the presence of air and, most importantly, a selectivity value towards CO 2 of 100% for any range of conversions and/or temperatures used. In addition, it has been demonstrated that the amount of ethylene glycol …
Oxidative dehydrogenation of ethane: A study over the structure and robustness of Ni–W–O catalysts
[EN] The robustness of one selected Ni-W-O catalyst has been studied in the oxidative dehydrogenation of ethane. This catalyst initially deactivates for the first 10 h online decreasing 15% of its catalytic activity compared to its initial stable catalytic activity. However from 10 to 60 h online the catalytic activity keeps almost stable. On the other hand, it has been shown that the Ni-W-O catalyst cannot tolerate an oxygen-free atmosphere (C-2 and He) as nickel oxide is transformed into metallic nickel. Methane and hydrogen as well as abundant coke were formed on the surface of the catalyst in these O-free conditions. However a re-calcination in air leads to the removal of coke, the cata…
Total oxidation of VOCs on Au nanoparticles anchored on Co doped mesoporous UVM-7 silica
Abstract Gold deposited on a cobalt containing siliceous mesoporous structure, UVM-7, presents a good catalytic performance in the total oxidation of propane and toluene. The presence of both gold and cobalt is necessary as bimetallic Au/Co-UVM-7 catalysts are remarkably more active than monometallic Au/UVM-7 or Co-UVM-7 catalysts. The improved activity of the bimetallic AuCo-samples if compared to gold free cobalt catalysts can be explained on the basis of the enhanced reducibility of some cobalt species in the presence of gold, which facilitates the redox cycle. This high reducibility of cobalt species in the bimetallic samples is probably due to the formation of Co 3 O 4 domains at the g…
Total oxidation of propane in vanadia-promoted platinum-alumina catalysts: Influence of the order of impregnation
Differently prepared vanadium promoted Pt/alumina catalysts have been prepared, characterized and tested for propane total oxidation. V-promoted Pt/Al2O3 catalysts have shown remarkably higher catalytic activity than V-free Pt/Al2O3 catalyst. Among V-promoted Pt catalysts that prepared by coimpregnation gave the highest alkane conversions in the whole range of reaction temperatures studied. Factors such as Pt particle size or the oxidation state of platinum do not seem to be the responsible for the enhanced performance. Modification of the redox properties of the catalyst (i.e. high reducibility of vanadium species) likely provoked by the close contact between platinum particles and vanadiu…