0000000000291593
AUTHOR
Francois Buy
Kinetics of Sigma Phase Precipitation in Niobium-Stabilized Austenitic Stainless Steel and Effect on the Mechanical Properties
Stabilized austenitic stainless steels are widely used in nuclear and oil industries. The 316 Nb steel grade presented in this study holds a small amount of delta ferrite in the austenitic matrix which tends to transform into sigma phase during prolonged exposures in the temperature range of 600-1000°C. Sigma phase is promoted by ferritic elements such as chromium, molybdenum, niobium and silicon. Time-Temperature-Transformation (TTT) diagram of the δ-ferrite evolution is established thanks to DSC experiments and quantitative metallographic analysis. It is observed that the highest sigma phase formation rate occurs between 800 and 900°C, and that the transformation of ferrite begins after a…
Study of the Hydrogen Embrittlement Sensitivity of an X4CrNiMo 16.5.1 Stainless Steel and the Associated Electron Beam Weld
X4CrNiMo 16.5.1 steel (commercial name APX4) is a low carbon martensitic stainless steel known for its remarkable mechanical characteristics and its good resistance to corrosion. The use of APX4 in the manufacture of high pressure gas vessels requires a thorough understanding of its resistance to Hydrogen Embrittlement (HE) as the gas can contain traces of hydrogen, and martensitic steels, and their welds, are generally very sensitive to HE. This paper deals with the first part of this study, involving the characterization of the microstructure and the mechanical properties of each zone of the electron beam weld (melted zone and four different heat affected zones), and the investigation of …
Understanding sigma-phase precipitation in a stabilized austenitic stainless steel (316Nb) through complementary CALPHAD-based and experimental investigations
Abstract Sigma-phase precipitation in a 316Nb “stabilized” austenitic stainless steel was studied through complementary CALPHAD-based and dedicated experimental investigations. Thermokinetic calculations performed using Thermo-Calc (with the DICTRA module) and MatCalc software showed that the sigma phase (σ) precipitated directly at γ-austenite grain boundaries (GB) via a common solid-state reaction when carbon and nitrogen contents fell below a critical threshold. Residual δ ferrite was found to be more susceptible to σ-phase precipitation; this type of precipitation occurred via two mechanisms that depended on the concentration profiles of δ-ferrite stabilizing elements induced by previou…