0000000000312154
AUTHOR
John A. Pojman
The apparently anomalous effects of surfactants on interfacial tension in the IBA/water system near its upper critical solution temperature
We studied the effect of anionic, cationic, and nonionic surfactants on the interfacial tension between the two phases of the isobutyric acid/water system using spinning drop tensiometry. It has been found that interfacial tension decreases with increasing concentration of the surfactant in the case of sodium dodecyl sulfate (SDS) and of dodecyltrimethylammonium chloride (DTAC). However, in the case of Triton X-100 an increase of surfactant concentration leads to an increase of the interfacial tension. Such results are consistent with the upper critical solution temperature (UCST) in the presence of these surfactants: the UCST decreases with increasing SDS and DTAC concentrations while it i…
Evidence for the Existence of an Effective Interfacial Tension between Miscible Fluids: Isobutyric Acid-Water and 1-Butanol-Water in a Spinning-Drop Tensiometer
We report definitive evidence for an effective interfacial tension between two types of miscible fluids using spinning-drop tensiometry (SDT). Isobutyric acid (IBA) and water have an upper critical solution temperature (UCST) of 26.3 degrees C. We created a drop of the IBA-rich phase in the water-rich phase below the UCST and then increased the temperature above it. Long after the fluids have reached thermal equilibrium, the drop persists. By plotting the inverse of the drop radius cubed (r(-)(3)) vs the rotation rate squared (omega(2)), we confirmed that an interfacial tension exists and estimated its value. The transition between the miscible fluids remained sharp instead of becoming more…
Thermal frontal polymerization with a thermally released redox catalyst
ABSTRACT: We studied thermal frontal polymerization using a re-dox systeminan attempt to lower the temperature of thefrontallypolymerizable system while increasing the front velocity so as toobtain a self-sustaining front in a thinner layer than without theredox components. A cobalt-containing polymer with a meltingpoint of 63 C (Intelimer 6050X11) and cumene hydroperoxidewere used with a triacrylate. The use of the Intelimer decreasedthe front velocity but allowed fronts to propagate in thinner layersand with more filler while still having a pot life of days. Nonplanarmodes of propagation occurred. Fronts propagated faster when6-O-palmitoyl- L -ascorbic acid was used as a reductant. Intere…
Effect of pseudo-gravitational acceleration on the dissolution rate of miscible drops
The effect of pseudo-gravitational acceleration on the dissolution process of two phase miscible systems has been investigated at high acceleration values using a spinning drop tensiometer with three systems: 1-butanol/water, isobutyric acid/water, and triethylamine/water. We concluded that the dissolution process involves at least three different transport phenomena: diffusion, barodiffusion, and gravitational (buoyancy-driven) convection. The last two phenomena are significantly affected by the centrifugal acceleration acting at the interface between the two fluids, and the coupling with the geometry of the dissolving drop leads to a change of the mass flux during the course of the dissol…