0000000000557665
AUTHOR
S. I. Ravelo Arias
showing 4 related works from this author
Analog isolated electronic dynamometer based on a magnetoresistive current sensor.
2017
In this work, an electronic system is presented to measure the force applied by a solenoid. The originality of the work is focused on the use of a magnetoresistive current sensor to provide the isolation barrier needed in the actual industrial plant where the solenoids are working. The design of the electronic system is presented as well as experimental measurements as a result of a calibration process showing a negligible hysteresis with that specific sensor. The magnetoresistive current sensor is used to develop transmission functions rather than playing its usual sensing roles.
Ru-Based Thin Film Temperature Sensor for Space Environments: Microfabrication and Characterization under Total Ionizing Dose
2016
The paper shows the microfabrication processes of a Ruthenium-based resistance temperature detector and its behavior in response to irradiation at ambient temperature. The radiation test was done in a public hospital facility and followed the procedures based on the ESA specification ESCC 22900. The instrumentation system used for the test is detailed in the work describing the sensors resistance evolution before, during, and after the exposure. A total irradiation dose of 43 krad with 36 krad/h dose rate was applied and a subsequent characterization was performed once the Ru sensors were submitted to an 80°C annealing process during a period of 168 h. The experimental measurements have sho…
Note: A non-invasive electronic measurement technique to measure the embedded four resistive elements in a Wheatstone bridge sensor
2015
The work shows a measurement technique to obtain the correct value of the four elements in a resistive Wheatstone bridge without the need to separate the physical connections existing between them. Two electronic solutions are presented, based on a source-and-measure unit and using discrete electronic components. The proposed technique brings the possibility to know the mismatching or the tolerance between the bridge resistive elements and then to pass or reject it in terms of its related common-mode rejection. Experimental results were taken in various Wheatstone resistive bridges (discrete and magnetoresistive integrated bridges) validating the proposed measurement technique specially whe…
A tunnel magnetoresistive effect wattmeters-based wireless sensors network
2017
Abstract In the present work a wireless sensors network (WSN) for smart energy metering is presented using the ZigBee protocol as the communication link. Each network node process the electrical power by means of a Wheatstone bridge sensor based on the tunnel magnetoresistive (TMR) effect working as analogue multiplier. The electrical power is acquired and processed by a digital signal processor that extracts various parameters of interest like current and voltage load, active power and power factor by means of Fourier analysis. All the obtained electrical parameters at each node are served and shown in a web page that can be easily accessed by authorized users.