6533b821fe1ef96bd127c04d

RESEARCH PRODUCT

A multi-model assessment of the efficacy of sea spray geoengineering

subject

description

Abstract. Artificially increasing the albedo of marine clouds by the mechanical emission of sea spray aerosol has been proposed as a geoengineering technique to slow the warming caused by anthropogenic greenhouse gases. A previous global model study found that only modest increases and sometimes even decreases in cloud drop number (CDN) concentrations would result from plausible emission scenarios. Here we extend that work to examine the conditions under which decreases in CDN can occur, and use three independent global models to quantify maximum achievable CDN changes. We find that decreases in CDN can occur when at least three of the following conditions are met: the injected particle number is <100 cm−3, the injected diameter is >250–300 nm, the background aerosol loading is large (≥150 cm−3) and the in-cloud updraught velocity is low (<0.2 ms−1). With lower background loadings and/or increased updraught velocity, significant increases in CDN can be achieved. None of the global models predict a decrease in CDN as a result of geoengineering, although there is considerable diversity in the calculated efficiency of geoengineering, which arises from the diversity in the simulated background aerosol distributions. All three models show a small dependence of geoengineering efficiency on the injected particle size and the geometric standard deviation of the injected mode. However, the achievability of significant cloud drop enhancements is strongly dependent on the cloud updraught speed. With an updraught speed of 0.1 ms−1 a global mean CDN of 375 cm−3 (previously estimated to cancel the forcing caused by CO2 doubling) is achievable in only about 50 % of cloudy grid boxes irrespective of the amount of aerosol injected. But at 0.2 ms−1 a CDN of 375−3 becomes achievable everywhere. Updraught speeds of less than 0.2 ms−1 are common in low-level clouds. Thus, a cloud drop concentration of 375 cm−3 cannot be attained uniformly, regardless of the number of injected particles.