Search results for " Coating."
showing 10 items of 2558 documents
Dissociative adsorption of water on Au/MgO/Ag(001) from first principles calculations
2015
Abstract The molecular and dissociative adsorption of water on a Ag-supported 1 ML, 2 ML and 3 ML-a six atomic layer-thick MgO films with a single Au adatom is investigated using density functional theory calculations. The obtained results are compared to a bulk MgO(001) surface with an Au atom. On thin films the negatively charged Au strengthens the binding of the polar water molecule due to the attractive Au–H interaction. The adsorption energy trends of OH and H with respect to the film thickness depend on an adsorption site. In the case OH or H binds atop Au on MgO/Ag(001), the adsorption becomes more exothermic with the increasing film thickness, while the reverse trend is seen when th…
Structural properties of the quaternary Heusler alloy Co2Cr1−xFexAl
2007
The quarternary substitutional series Co2Cr1?xFexAl was investigated by means of surface and bulk sensitive techniques in order to exploit its structural and compositional properties. Both bulk and powder samples of the alloy series were investigated to obtain specific information about this material.The long range order was determined by means of x-ray diffraction and neutron diffraction, while the site specific (short range) order was proved by extended x-ray absorption fine structure spectroscopy. The magnetic structure was investigated by M?ssbauer spectroscopy in transmission and scattering modes in order to compare and separate powder and bulk properties. The chemical composition was …
Surface spectroscopic study of the corrosion of ultrathin57Fe-evaporated and Langmuir-Blodgett films in humid SO2 environments
2000
Integral conversion electron Mossbauer spectroscopy (ICEMS), x-ray photoelectron spectroscopy (XPS), Auger electron spectroscopy (AES) and scanning electron microscopy (SEM) have been used to carry out a comparative study of the corrosion resistance against humid SO2-aggressive environments of ultrathin 57Fe films. These films, having a thickness ≤ 2.5 nm, have been prepared by evaporation of 57Fe under vacuum and by 57Fe coating by a Langmuir–Blodgett (LB) technique on SiO2/Si wafers. The results have shown that the corrosion resistance of the evaporated films is similar to that of massive Fe. However, the LB films show a remarkably higher corrosion resistance. Thus, although the Fe films …
Iron deposition on TiO2(110): effect of the surface stoichiometry and roughness
1999
Abstract Characterizations of ultra-thin iron films deposited on TiO 2 (110) surfaces with different stoichiometries, roughnesses and crystallinities have been carried out by X-ray photoelectron spectroscopy (XPS) and Auger electron spectroscopy (AES). For a high initial roughness of the substrate, a 2D growth mode is observed up to three monolayers. But, if the initial roughness is low, clusters grow on the TiO 2 surface. Whatever the initial surface stoichiometry, electronic exchanges occur between titanium and iron leading to a reduction of titanium and an oxidation of iron. This interaction between iron and titanium dioxide surface takes place only at the interface between the metal and…
Relationships between strain, microstructure and oxide growth at the nano- and microscale
2008
In the present article, the relationships between oxidation processes, surface strains and the microstructure of duplex stainless steels were investigated. Specimens were oxidized at 500 °C under secondary vacuum for 1 h to form a thin oxide film (thickness in the range of 20-50 nm). Such specimens were considered as the model system for developing novel methods of analysis in understanding the behavior of passive films. The interfacial strain field after oxidation was measured experimentally at the microscale using the point grid method. On the other hand, the chemical composition of the oxide film was determined at the submicroscopic scale by means of local scanning Auger spectroscopy (wi…
Angular-resolved electron spectroscopy from (110) surfaces of ternary Ce-based intermetallics: CePd2Si2 and CeNi2Ge2
1997
Investigations of electronic properties were carried out for the ternary Ce-based intermetallic systems CeT2X2 (T = Ni, Pd; X = Ge, Si). To produce well-ordered and atomically clean surfaces, preparation is carried out in UHV. The polycrystalline substance was evaporated on a W(110) substrate with subsequent annealing. The single-crystalline layers obtained are characterised by MEED (thickness), AES (surface stoichiometry), LEED and SEM (surface structure). For electron-spectroscopic investigations, ARUPS (angle-resolved photoemission spectroscopy) was used. In the photoemission spectra, dispersion effects could be detected by variation of the detection angle.
Preparation by radio-frequency magnetron co-sputtering and characterization of thin films of lanthanum–strontium ferromanganites
2005
Abstract (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ films with y = 0, 0.2, 0.5, 0.8 and 1, a few hundred nanometers thick, were deposited onto polycrystalline yttria-stabilized zirconia YSZ by a magnetron co-sputtering technique using individual targets of La 0.8 Sr 0.2 MnO 3 and La 0.8 Sr 0.2 FeO 3 . The deposition parameters, substrate temperature and gas pressure, were studied by scanning electron microscopy, energy dispersive X-ray spectrometry, X-ray diffraction and interferential microscopy for their effects on the morphological, chemical, topographic and crystallographic properties of films and YSZ-film interfaces. (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ thin films were found to be …
Effect of the surface stoichiometry on the interaction of Mo with TiO2 (110)
2000
Abstract Molydenum has been deposited at room temperature on (110) TiO2 surfaces with different stoichiometries, roughnesses and crystallinities. Whatever the substrate preparation is, in-situ Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS) studies as well as ex-situ atomic force microscopy (AFM) and reflexion high-energy electron diffraction (RHEED) studies reveal a Stranski–Krastanov growth mode: the completion of three monolayers followed by islands growth is observed in every case. The three monolayers are always composed of amorphous molybdenum oxide with an oxidation state of molybdenum less than IV. The oxidation of the molybdenum layers generates Ti3+ an…
Initial chemical transport of reducing elements and chemical reactions in oxide cathode base metal
2002
Abstract In the present work, the formation of compounds associated to the diffusion of reducing elements (Mg and Al) to the nickel surface of a one-piece oxide cathode has been studied. Those compounds have been evidenced after the annealing steps at high temperature performed on cathode base metal prior to the emitting coating deposition. Therefore, they form the “initial” interface between the nickel and the coating, in other words, the interface existing at the beginning of cathode life. Extensive analysis to characterize the nickel base prior to coating deposition has been performed by means of scanning electron microscopy (SEM) coupled with energy dispersive X-ray spectroscopy (EDX), …
Aurophilicity as a cofactor in crystal engineering. Dicyanoaurate(I) anion as a building block in a novel Co(II)–Au(I) bimetallic assembly
2002
A 2D grid-shaped cyanide-bridged Co(II)–Au(I) bimetallic coordination polymer, [Co(DMF)2{Au(CN)2}2], has been prepared from the [Au(CN)2]2 building block; sheets associate pair-wise by aurophilic interactions and the compound exhibits zeolite-like properties. Lloret Pastor, Francisco, Francisco.Lloret@uv.es