Search results for " Infrared Spectroscopy"
showing 10 items of 438 documents
Improvement of the photo-stability of polystyrene-block-polybutadiene-block-polystyrene through carbon nanotubes
2015
Abstract The photo-stability of Polystyrene-Polybutadiene-Polystyrene (SBS) based nanocomposites containing bare multi-walled carbon nanotubes (CNTs) and carbon nanotubes bearing carboxylic functional groups (CNTs-COOH) in comparison to that of pristine SBS has been studied. The photo-oxidation of pristine SBS occurs through crosslinking reactions and oxidized species formation and both these processes begin at early stage of exposure. The formation of crosslinking, formerly in polybutadiene phase, assessed by spectroscopical (FTIR), mechanical, dynamic mechanical and rheological analysis, leads to occurrence of internal mechanical stresses in the solid state and the SBS samples become prem…
On-line sample treatment and FT-IR determination of doxylamine succinate in pharmaceuticals
2005
Abstract A low solvent consumption method for Fourier transform infrared spectroscopy (FT-IR) determination of doxylamine succinate in pharmaceuticals has been developed. The analyte was continuous and selectively extracted with a 13% (v/v) ethanol:chloroform solvent mixture, recirculating the solvent through the sample and monitoring the process by FT-IR. Doxylamine succinate was determined by on-line standard addition measuring the peak area in the regions 1730–1710 and 1485–1462 cm −1 corrected with a two-point baseline established between 2000 and 1800 cm −1 . This new method implies low volumes of chloroformic solvent mixture, only 2.6 mL per sample, in front of classical batch FT-IR m…
Methods for the Identification of Tainting Terpenoids and other Compounds from Algae
1992
Off-flavour compounds produced by algae in freshwater ecosystems were studied for their structure using integrated sensory and spectroscopic methods: mass spectrometry (MS), nuclear magnetic resonance (NMR) and Fourier transform infrared (FTIR). Both solvent extraction and thermal desorption were used to isolate and to introduce the compounds into gas chromatography/mass spectrometry (GC/MS) and gas chromatography/Fourier transform infrared (GC/FTIR) systems. Ten ng of a terpenoid compound gave a readable IR spectrum. For 1H NMR studies the compounds were collected directly into NMR solvent by preparative gas chromatography. About 5 µg of a monoterpenoid compound was needed for a reliable 1…
Design, characterization and evaluation of hydroxyethylcellulose based novel regenerable supersorbent for heavy metal ions uptake and competitive ads…
2017
Abstract Hydroxyethylcellulose succinate-Na (HEC-Suc-Na) was designed and evaluated for removal of some heavy metal ions from aqueous solution. Pristine sorbent HEC-Suc-Na was thoroughly characterized by FTIR and solid-state CP/MAS 13C NMR spectroscopy, SEM-EDS and zero point charge analyses. Langmuir isotherm, pseudo second order kinetic and ion exchange models provided best fit to the experimental data of sorption of metal ions. Maximum sorption capacities of supersorbent HEC-Suc-Na for sorption of heavy metal ions from aqueous solution as calculated by Langmuir isotherm model were found to be 1000, 909.09, 666.6, 588 and 500 mg g−1 for Pb(II), Cr(VI), Co(II), Cu(II) and Ni(II), respectiv…
Towards minimization of chlorinated solvents consume in Fourier transform infrared spectroscopy determination of Propamocarb in pesticide formulation…
2008
Abstract A method has been developed for Fourier transform infrared (FTIR) spectroscopy determination of Propamocarb in emulsifiable pesticide concentrate formulations. Five microliter sample was directly injected without any pretreatment in a CHCl 3 stream at 2 mL min −1 into a closed system and the FTIR spectra of sample and standard solutions were obtained using a nominal resolution of 4 cm −1 from 4000 to 900 cm −1 spectral region and accumulating 2 scans per spectrum. Propamocarb determination was based on the measurement of flow injection analysis (FIA) recording height established from FTIR peak area measurements from 1713 to 1703 cm −1 corrected using a baseline defined at 2000 cm −…
From a fixed bed Ag–alumina catalyst to a modified reactor design: how to enhance the crucial heterogeneous–homogeneous reactions in HC-SCR
2004
Abstract A highly active Ag/alumina catalyst for continuous reduction of NO to nitrogen with n-octane under lean conditions was prepared. It was observed in the reactor set-up experiments for optimization of the converter, that surface generated gas phase species are crucial for obtaining high conversion. EPR and matrix isolated FTIR studies at low temperature (10–18 K) were performed for identification of the radicals. Experimental data, observed at steady state conditions in the temperature range 300–550 °C, was used to produce an artificial neural network model of the catalytic converter with four catalyst beds.
Investigation on a low environmental impact solvent mixture applied to a wooden painted slab
2016
Cleaning is one of the most complex and delicate step in a restoration project, often due to the manufacturing techniques of the artifacts and their advanced state of decay. Eco-friendly solvents can permit to execute the cleaning operations with a reduced health impact for the restorers and for the environment. In this work, the performance of the 1,3- dioxolane/methylal (DIOX-MET) solvent mixture is evaluated over a wooden painted slab that had been covered with a thin layer of a protective varnish, probably during a previous conservation work performed in the Sixties. Removal of this varnish has been considered on behalf of its yellowing degradation process, which caused chromatic change…
Syntheses, spectroscopic and structural properties of phenoxysilyl compounds : X-ray structures, FT-IR and DFT calculations
2013
Abstract The reaction of silicon disulfide with alkylphenols yields tetraphenoxysilane, cyclodisilthiane and silanethiol. The outcome of the reaction depends on the presence of the steric hindrance in the ortho position on the reacting phenol. New products of the reaction of silicon disulfide with phenols are characterized by FT-IR, NMR, X-ray diffraction and DFT calculations. The intramolecular interactions in the compounds are mainly XH---π (X = C, S) whereas the intermolecular interactions are either very weak CH---π/CH---O contacts found in aryloxysilane or electrostatic dipole–dipole attraction in cyclodisilthiane and silanethiol. The S–H---π interactions in the obtained silanethiol ar…
Reactive Surface Coatings Based on Polysilsesquioxanes: Controlled Functionalization for Specific Protein Immobilization
2009
The key designing in reliable biosensors is the preparation of thin films in which biomolecular functions may be immobilized and addressed in a controlled and reproducible manner. This requires the controlled preparation of specific binding sites on planar surfaces. Poly(methylsilsesquioxane)-poly(pentafluorophenyl acrylates) (PMSSQ-PFPA) are promising materials to produce stable and adherent thin reactive coatings on various substrates. Those reactive surface coatings could be applied onto various materials, for example, gold, polycarbonate (PC), poly(tetrafluoroethylene) (PTFE), and glass. By dipping those substrates in a solution of a desired amine, specific binding sites for protein ads…
Self-assembled aggregates of amphiphilic perylene diimide-based semiconductor molecules: effect of morphology on conductivity.
2011
Abstract Two amphiphilic perylenetetracarboxylic diimide derivatives modified with different side chains at imide nitrogen, N- n -hexyl-N′-(2-hydroxyethyl)-1,7-di(4′-t-butyl)phenoxy-perylene-3,4:9,10-tetracarboxylic diimide ( PDI 1 ) and N,N′-di(2-hydroxyethyl)-1,7-di(4′-t-butyl)phenoxy-perylene-3,4:9,10-tetracarboxylic diimide ( PDI 2 ), were fabricated into organic nanostructures via solution-phase self-assembly. Their self-assembling properties in methanol and n -hexane have been comparatively studied by electronic absorption, fluorescence, and Fourier transform infrared spectroscopy (FT-IR). The morphologies and structures of the self-assemblies were examined by scanning electronic micr…