Search results for "Alloy"

Chemical Identification at the Solid–Liquid Interface

2017

Solid-liquid interfaces are decisive for a wide range of natural and technological processes, including fields as diverse as geochemistry and environmental science as well as catalysis and corrosion protection. Dynamic atomic force microscopy nowadays provides unparalleled structural insights into solid-liquid interfaces, including the solvation structure above the surface. In contrast, chemical identification of individual interfacial atoms still remains a considerable challenge. So far, an identification of chemically alike atoms in a surface alloy has only been demonstrated under well-controlled ultrahigh vacuum conditions. In liquids, the recent advent of three-dimensional force mapping…

Cadmium Recovery from Spent Ni-Cd Batteries: A Brief Review

2021

The significant increase in the demand for efficient electric energy storage during the past decade has promoted an increase in the production and use of Cd-containing batteries. On the one hand, the amount of toxic Cd-containing used batteries is growing, while on the other hand, Cd is on a list of critical raw materials (for Europe). Both of these factors call for the development of effective technology for Cd recovery from spent batteries. The present paper is aimed at providing a short review of the recent progress in Cd recovery from spent batteries. Statistical data from the past decade on the source of Cd, its global production, and Ni-Cd battery recycling are given in the introducti…

Stable amorphous calcium oxalate: synthesis and potential intermediate in biomineralization.

2014

Amorphous calcium oxalate nanoparticles with sizes of 10–30 nm were synthesized at room temperature by the hydrolysis of a dimethyl oxalate from ethanol solution.

Paper consolidation with Halloysite nanotubes. TGA, DMA and contact angle investigations

2013

Origin of clay minerals in soils on pyroclastic deposits in the island of Lipari (Italy)

2005

The island of Lipari (Italy) is characterized by calc-alkaline to potassic volcanism and a Mediterranean-type climate. The mineralogical and chemical features of two different soil profiles with ages of 92,000 and 10,000–40,000 y, respectively, have been investigated. There were no Andisols, but Vitric and Vertic Cambisols have developed at both sites. Although the morphology of the soils was similar, remarkable differences in the clay mineralogy between the two sites were observed. The site with the Vitric Cambisol was associated with the weathering sequence: glass → halloysite → kaolinite or interstratified kaolinite-2:1 clay minerals. Both sites had smectite in the clay fraction and, to …

Detection of gas trace of hydrofluoric acid using microcantilever

2004

Abstract Microcantilevers have been used as a gas sensor in order to detect Hydrofluoric acid (HF) in the concentration range of 0.26–13 ppm. Silicon derived elements (Si 3 N 4 , SiO x ) were chosen to serve as chemical sensitive layer. Cantilever deflection and frequency shift were analyzed and compared as a function of the flow rate and the concentration of the HF molecules. The stoichiometry and roughness of the sensitive layer were found to be of major importance. Results show that the most appropriate signal at the lowest concentration ( x surface by HF. The frequency shift that is mainly governed by the loss in cantilever mass can be used at higher concentration.

Real-time microfluorescence studies of Langmuir-Blodgett deposition: Monolayer adsorption and desorption

1990

Abstract Observations of the meniscus region in a typical Langmuir-Blodgett configuration are obtained using fluorescence microscopy. Studies of the meniscus position as a function of pH demonstrate that the meniscus height increases upon charging the monolayer owing to the repulsive interaction between monolayer and substrate surfaces. Through the correspondence between meniscus height and contact angle the adhesion forces between monolayer and substrate as a function of monolayer charge are assessed. The phenomenon of desorption upon resubmerging a deposited film is described and it is shown that the meniscus height at the onset of the desorption is greater for higher pH.

Manganese carbonyl terpyridyl complexes: their synthesis, characterization and potential application as CO-release molecules

2014

MnI carbonyl terpyridyl complexes have been synthesized and characterized. The tricarbonyl derivative exhibits interesting behaviors for controlled CO-release by both thermal and photosynthetic pathways.

Reversible switching of the electronic ground state in a pentacoordinated Cu(ii) complex.

2013

International audience; An easy reversible switching of the electronic ground state in a pentacoordinated copper(ii) complex is reported for the first time. The simple protonation of a carboxylic group in a Cu(ii) complex with a {dx(2)-y(2)}(1) electronic configuration leads to a flip of the ground electronic configuration from {dx(2)-y(2)}(1) to {dz(2)}(1) in the metal ion.

Phenotypic redifferentiation and cell cluster formation of cultured human articular chondrocytes in a three-dimensional oriented gelatin scaffold in …

2013

Modern tissue engineering strategies comprise three elemental parameters: cells, scaffolds and growth factors. Articular cartilage represents a highly specialized tissue which allows frictionless gliding of corresponding articulating surfaces. As the regenerative potential of cartilage is low, tissue engineering-based strategies for cartilage regeneration represent a huge challenge. Prostaglandins function as regulators in cartilage development and metabolism, especially in growth plate chondrocytes. In this study, it was analyzed if prostaglandin E2 (PGE2) has an effect on the phenotypic differentiation of human chondrocytes cultured in a three-dimensional (3D) gelatin-based scaffold made …