Search results for "Alum"

Determination of aluminum at the parts per billion level by solvent extraction and flame atomic emission spectrometry

1991

A new method for the determination of aluminum at the parts per billion level, by N 2 O/ C 2 H 2 flame emission spectrometry with prior solvent extraction with acetylacetone or 8-hydroxyquinoline in 4-methylpentan-2-one, has been performed. The influence of extraction conditions and instrumental parameters on the sensitivity, precision, and dynamic range of the emission calibration curves have been studied. The limit of detection is between 5 and 10 ppb for both ligands, the variation coefficient being 0.2 and 3% at levels of 75 and 25 ppb, respectively. The method has been applied to the determination of Al in water and the results obtained are compared with those found by the standard add…

Preparation of Hg2+ selective fluorescent chemosensors based on surface modified core–shell aluminosilicate nanoparticles

2010

A synthetic procedure for the preparation of functional structured inorganic–organic hybrid materials consisting of boehmite-silica core–shell nanoparticles and anthracene-containing amines covalently attached to the nanoparticles surface is reported. The system functionalised with the monoamine chain shows a very high sensing performance for Hg2+ detection in pure water reaching a detection limit of 0.2 ppb. Two additional advantages of these systems are their stability over a wide pH window and the feasibility to be recovered by a simple procedure.

Chromium speciation using activated alumina microcolumns and sequential injection analysis-flame atomic absorption spectrometry

2001

Abstract A new procedure has been developed for chromium speciation in water by sequential injection analysis and flame atomic absorption spectrometry. The method involves the online retention of Cr(VI) anionic species and Cr(III) cationic species on alumina microcolumns, prepared by packing activated alumina in polytetrafluoroethylene tubes, followed by selective elution of Cr(VI) with 2 mol l −1 NH 4 OH and of Cr(III) with 0.2 mol l −1 HNO 3 . Studies were carried out on the effect of retention and elution conditions for both Cr species. The limit of detection values, established as the concentration corresponding to three times the standard deviation of blank measurements divided by the …

Simultaneous clean up of fish fat containing low levels of residues and separation of PCB from chlorinated pesticides by thin-layer chromatography

1974

Halloysite nanotubes for efficient loading, stabilization and controlled release of insulin

2018

Hypothesis: Oral insulin administration is not actually effective due to insulin rapid degradation, inactivation and digestion by proteolytic enzymes which results in low bioavailability. Moreover insulin is poorly permeable and lack of lipophilicity. These limits can be overcome by the loading of protein in some nanostructured carrier such as halloysite nanotubes (HNTs). Experiments: Herein we propose an easy strategy to obtain HNT hybrid materials for the delivery of insulin. We report a detailed description on the thermal behavior and stability of insulin loaded and released from the HNTs hybrid by the combination of several techniques. Findings: Release experiments of insulin from the H…

Exploración de las características del razonamiento visual en alumnos con talento matemático

2013

La investigación que se presenta en esta memoria tiene por finalidad el estudio de los procesos de visualización de alumnos con talento matemático, en particular en el contexto del aprendizaje de algunos conceptos de Geometría. La elección del tema viene motivada por la necesidad de atender de manera diferenciada a los alumnos con talento matemático. Los estudiantes con talento matemático requieren un tipo de atención individualizada. En la actualidad, su consideración por el sistema educativo como alumnos con necesidades educativas especiales lleva a diseñar metodologías y usar unos recursos particulares que den respuesta a sus características propias. Es importante resaltar que una falta …

Propyl substituted 4-arylimino-1,2,3-trihydroacridylnickel complexes: Their synthesis, characterization and catalytic behavior toward ethylene

2015

Propyl substituted 4-arylimino-1,2,3-trihydroacridylnickel dihalide complexes were designed and prepared by metal-induced template reaction with NiCl2 center dot 6H(2)O or (DME)NiBr2. They were characterized by infrared spectroscopy and elemental analysis. Single crystal X-ray crystallography of representative complex Ni3 revealed a distorted trigonal bipyramidal geometry around nickel. The catalytic activities of the title nickel complexes were negatively affected by propyl substituent on their backbone when comparing with the results by unsubstituted ones. With the activation of diethylaluminium chloride, all nickel complexes exhibited moderate activity (up to 5.10 x 10(5) g mol(-1)(Ni) h…

Achieving branched polyethylene waxes by aryliminocycloocta[b]pyridylnickel precatalysts: Synthesis, characterization, and ethylene polymerization

2017

Cycloocta[b]pyridin-10-one was prepared to form the corresponding imino derivatives, which then reacted with (DME)NiBr2 to form 10-aryliminocycloocta[b]pyridylnickel bromides (Ni1–Ni5). The new compounds were characterized by means of FT-IR spectroscopy as well as elemental analysis and the organic ligands were also analyzed by the NMR measurements. Furthermore, the molecular structure of a representative complex Ni3 was determined by the single crystal X-ray diffraction, indicating the distorted tetrahedral geometry around the nickel atom. Upon the activation with either methylaluminoxane (MAO) or diethylaluminium chloride (Et2AlCl), the title nickel complexes exhibited high activity in et…

Evaluation of 2,3-epoxypropyl groups and functionalization yield in glycidyl methacrylate monoliths using gas chromatography

2014

Abstract Poly(glycidyl methacrylate- co -ethylene dimethacrylate) (poly(GMA- co -EDMA)) is most frequently used as parent monolith to obtain stationary phases with a variety of surface chemistries for liquid chromatography and capillary electrochromatography. Functionalization is performed by opening the accessible 2,3-epoxypropyl groups of the monolith with a suitable reagent. The number of 2,3-epoxypropyl groups which are accessible before and after the functionalization reaction, and the grafting yield, are important parameters, required both to optimize functionalization and to interpret the chromatographic performance of functionalized monoliths. In this work, a method capable of provi…

Melting of tantalum at high pressure determined by angle dispersive x-ray diffraction in a double-sided laser-heated diamond-anvil cell

2003

The high pressure and high temperature phase diagram of Ta has been studied in a laser-heated diamond-anvil cell (DAC) using x-ray diffraction measurements up to 52 GPa and 3800 K. The melting was observed at nine different pressures, being the melting temperature in good agreement with previous laser-heated DAC experiments, but in contradiction with several theoretical calculations and previous piston-cylinder apparatus experiments. A small slope for the melting curve of Ta is estimated (dTm/dP = 24 K/GPa at 1 bar) and a possible explanation for this behaviour is given. Finally, a P-V-T equation of states is obtained, being the temperature dependence of the thermal expansion coefficient an…