Search results for "Anodizing"
showing 10 items of 116 documents
Enhancement of photoelectrochemical activity for water splitting by controlling hydrodynamic conditions on titanium anodization
2015
This work studies the electrochemical and photoelectrochemical properties of a new type of TiO2 nanostructure (nanosponge) obtained by means of anodization in a glycerol/water/NH4F electrolyte under controlled hydrodynamic conditions. For this purpose different techniques such as Scanning Electronic Microscopy (SEM), Raman Spectroscopy, Electrochemical Impedance Spectroscopy (EIS) measurements, Mott–Schottky (M−S) analysis and photoelectrochemical water splitting tests under standard AM 1.5 conditions are carried out. The obtained results show that electron–hole separation is facilitated in the TiO2 nanosponge if compared with highly ordered TiO2 nanotube arrays. As a result, nanosponges en…
Electrochemically prepared oxides for resistive switching devices
2018
Redox-based resistive switching memories (ReRAM) based on metal oxides are considered as the next generation non-volatile memories and building units for neuromorphic computing. Using different deposition techniques results however in different structural and electric properties, modulating the device performance. In this study HfO2 and Nb2O5 were prepared electrochemically by anodizing sputtering-deposited Hf and Nb in borate buffer solution. Photoelectrochemical measurements were used to study the solid state properties of the anodic oxides, such as band gap and flat band potential. In the case of anodic HfO2, detected photocurrent is ascribed to optical transitions between localized (gen…
Anodized Ti-Si Alloy as Gate Oxide of Electrochemically-Fabricated Organic Field-Effect Transistors
2013
Organic field-effect transistors were fabricated using an electrochemical route. The dielectric oxide was grown by anodization of a Ti:Si alloy, while 3,4-polyethylenedioxythiophene has been employed as a semiconducting polymer. OutputI-Vcharacteristics showed a transistor effect dependent on dielectric thickness. Fitting between I-V measurements and theoretical simulations in the triode region confirmed the presence of a conduction path through the polymer which degrades the electrical characteristics of the devices.
Electrochemical fabrication of metal/oxide/conducting polymer junction
2011
After discovery of conducting polymers and the possibility to modify their electrical properties from insulating to metallic like behavior by doping and a careful choice of the processing conditions, a large amount of research effort has been devoted to the theoretical understanding of their solid state properties as well as to exploit the possible application of conducting polymers in many technological fields including large area organic electronics, polymer photovoltaic cell, and sensors. 1-4 Organic thin film transistors appear very promising devices for the development of low cost, flexible, and disposable plastic electronics. In order to reduce the operating voltage it has been sugges…
Effect of Composition on the Photoelectrochemical Behavior of Anodic Oxides on Binary Aluminum Alloys
2006
The photoelectrochemical behavior of anodic films on Al alloys, containing titanium, tantalum, and tungsten (valve metals), has been studied as a function of alloy composition and anodizing conditions. Photocurrent spectroscopy has been used to get information on bandgap and the flatband potential values of different mixed oxides. Both insulator-like and semiconducting behavior has been observed for anodic oxides grown on Al-W and Al-Ti alloys dependent on alloy initial composition. Optical bandgap values, E opt g , of different oxides are in accordance with predictions based on the correlation between E opt g and the difference of electronegativities of the oxide constituents, indicating p…
Red Shift in the Light Absorption Threshold of Anodic TiO2 Films Induced by Nitrogen Incorporation
2014
Abstract Titanium foils were anodized in ammonium containing and ammonium free solutions in order to check the possibility of inducing nitrogen incorporation into anodic TiO 2 films. XPS spectra confirmed the presence of O-Ti-N bonds on the surface of the anodic films prepared in ammonium biborate electrolytes. In order to evidence the effect of nitrogen incorporation on the light absorption threshold, photoelectrochemical behavior of as-anodized and high temperature annealed films as a function of the anodizing electrolyte composition were investigated. A photocurrent tail at energies lower than the mobility gap of TiO 2 appeared for those films prepared in ammonium containing electrolytes…
Synergistic effect between hydrodynamic conditions during Ti anodization and acidic treatment on the photoelectric properties of TiO2 nanotubes
2015
In the present work, the combined influence of controlled hydrodynamic conditions during Ti anodization and the acidic treatment with HClO4 on the photoelectric properties of mixed anatase/rutile TiO2 nanotubes has been studied. Anodized samples were analyzed by means of Field Emission Scanning Electronic Microscopy (FE-SEM), Confocal Raman Microscopy, electrochemical measurements (electrochemical impedance spectroscopy and Mott-Schottky analysis) and photoelectrochemical measurements. It has been observed that the use of hydrodynamic conditions increases the surface area of nanotubes, while acidic treatment enhances their conductivity. Besides, there is a clear synergistic effect between t…
Control on the morphology and photoelectrocatalytic properties of ZnO nanostructures by simple anodization varying electrolyte composition
2021
Abstract Zinc oxide nanostructured electrodes were successfully synthesized by a simple method of anodization in different aqueous bicarbonate electrolytes. The influence of the anodization electrolyte composition (by adding ethanol or glycerol) on the morphology and the photoelectrocatalytic properties of the zinc oxide electrodes was studied, as well as the combined effect of anodizing under controlled hydrodynamic conditions. Field Emission Scanning Electron Microscope (FE-SEM) images of the ZnO electrodes showed that the addition of ethanol or glycerol to the anodization electrolyte resulted in changes in size and morphology of the nanostructures. Thus, ZnO nanowires, nanotubes, nanospo…
The influence of nitrogen incorporation on the optical properties of anodic Ta2O5
2012
Abstract Anodic oxides were grown on sputter-deposited Ta in different aqueous solutions. A photoelectrochemical investigation was performed in order to estimate the band gap of the films as a function of the anodizing bath composition and formation voltage, i.e. thickness. Photoelectrochemical results provided evidence of sub-band gap photocurrent for films formed in a bath containing ammonium ions at pH 9. Elemental depth profiles obtained by glow discharge optical emission spectroscopy revealed the presence of nitrogen species in the outer part of the anodic films, which is bonded to Ta according to XPS analysis. A mechanism of nitrogen incorporation is proposed in order to account for t…
The influence of surface treatment on the anodizing of magnesium in alkaline solution
2011
Abstract The mechanism of magnesium anodizing after mechanical polishing or HF pickling was studied. X-ray Photoelectron Spectroscopy and Photocurrent Spectroscopy were employed to characterize both the initial films formed on Mg soon after surface treatments and the anodic films grown in strongly alkaline solutions. Electrochemical and capacitance measurements were performed in order to study the oxidation process and to check if the kinetic of growth fits the Mott–Cabrera high field model. From Tafel plots it was possible to estimate the activation distance, while the simulation of the barrier layer growth as a function of the potential at high scan rate allowed to estimate the other kine…