Search results for "Applied Physics"
showing 10 items of 1226 documents
Design of EMI Filters Using Multi-Objective Optimization
2018
A multi-objective design procedure for EMI filters in power converters is proposed. In a first step, the results obtained by an automatic design of EMI filters for power electronic converters oriented to satisfy the electromagnetic compatibility standards and the power density constraint which impose the minimization of the filter volume and/or weight, are evaluated. In a second step, the power losses and the cost related to the EMI filter configurations are estimated. By using the dominance concept, the EMI filter designs which are part of the Pareto front are selected among a discrete set of feasible configurations. Therefore, the configurations of the Pareto front take into consideration…
Study of voltage decrease in organic light emitting diodes during the initial stage of lifetime
2016
Abstract We report the results of lifetime DC testing at constant current of not-encapsulated organic light emitting diodes (OLEDs) based on Tris (8 idroxyquinoline) aluminum (Alq3) as emitting material. In particular, a voltage decrease during the initial stage of the lifetime test is observed. The cause of this behavior is also discussed, mainly linked to initial Joule self-heating of the device, rising its temperature above room temperature until thermal equilibrium is reached at steady state.
Kinetic Monte Carlo modeling of Y2O3 nano-cluster formation in radiation resistant matrices
2018
This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014-2018 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission.
Sputtered cuprous oxide thin films and nitrogen doping by ion implantation
2016
Abstract The structural, optical and electrical properties of sputtered cuprous oxide thin films have been optimized through post-deposition thermal treatments. Moreover we have studied the effects of nitrogen doping introduced by ion implantation followed by the optimized oxidant thermal annealing. Three concentrations have been used, 0.6 N%, 1.2 N%, and 2.5 N%. Along with the preservation of the Cu 2 O phase, a slight optical band gap narrowing and a significant conductivity enhancement has been observed with respect to the undoped samples. These results can be justified by the absence of further oxygen vacancies promoted by dopant introduction and by the substitution of O atoms by N ones…
Dielectric properties of barium strontium titanate / non ferroelectric oxide ceramic composites
2001
International audience; Barium strontium titanate ceramics present high dielectric permittivity and tunability. In order to reduce their permettivity and loss tangent while keeping tunability, various composites of barium strontium titanate oxide...
Ozone-Based Atomic Layer Deposition of Al2O3 from Dimethylaluminum Chloride and Its Impact on Silicon Surface Passivation
2017
Dimethylaluminum chloride (DMACl) as an aluminum source has shown promising potential to replace more expensive and commonly used trimethylaluminum in the semiconductor industry for atomic layer deposited (ALD) thin films. Here, the Al2O3 DMACl-process is modified by replacing the common ALD oxidant, water, by ozone that offers several benefits including shorter purge time, layer-by-layer growth, and improved film adhesion. It is shown that the introduction of the ozone instead of water increases carbon and chlorine content in the Al2O3, while long ozone pulses increase the amount of interfacial hydrogen at silicon surface. These are found to be beneficial effects regarding the surface pass…
Surface investigation of plasma HMDSO membranes post-treated by CF4/Ar plasma
2002
Fluorination treatment has been performed on polysiloxane membranes using a plasma glow discharge of a gases mixture CF4 and argon (plasma enhanced chemical vapor deposition). Atomic force microscopy, XPS analyses and contact angle measurements have been undertaken to explain the surface transformation and behavior, which strongly depend on the morphology, the composition and the hydrophilic/hydrophobic character of the plasma-polymerized initial membranes. Main result is that fluorination, which leads to hydrophobic membranes, has a more relevant effect on amorphous silica-like membranes than on polymer-like ones, according to their chemical composition whereas the plasma surface reaction …
Erosion and screening of tungsten during inter/intra-ELM periods in the JET-ILW divertor
2020
Abstract Intra-ELM tungsten sources, which dominate the total W source, are quantified in the inner and outer divertor of JET-ILW. The amount of the sputtered W atoms for individual ELMs demonstrates a clear dependence on the ELM frequency. It decreases when the pedestal temperature is lower and, correspondingly, the ELM frequency is higher. Nevertheless, the entire gross erosion W source (the number of eroded W atoms per second due to ELMs) increases initially with ELM frequency and reaches its maximum at fELM ≈ 50–55 Hz followed by its reduction in the high frequency range. The in/out asymmetry of the intra-ELM W sources during ELMs is a critical issue and is investigated in this contribu…
Experimental quantification of useful and parasitic absorption of light in plasmon-enhanced thin silicon films for solar cells application
2016
AbstractA combination of photocurrent and photothermal spectroscopic techniques is applied to experimentally quantify the useful and parasitic absorption of light in thin hydrogenated microcrystalline silicon (μc-Si:H) films incorporating optimized metal nanoparticle arrays, located at the rear surface, for improved light trapping via resonant plasmonic scattering. The photothermal technique accounts for the total absorptance and the photocurrent signal accounts only for the photons absorbed in the μc-Si:H layer (useful absorptance); therefore, the method allows for independent quantification of the useful and parasitic absorptance of the plasmonic (or any other) light trapping structure. W…
Emergence of the stripe-domain phase in patterned permalloy films
2016
The occurrence of stripe domains in ferromagnetic Permalloy (Py=Fe$_{20}$Ni$_{80}$) is a well known phenomenon which has been extensively observed and characterized. This peculiar magnetic configuration appears only in films with a thickness above a critical value ($d_{cr}$), which is strongly determined by the sputtering conditions (i.e. deposition rate, temperature, magnetic field). So far, $d_{cr}$ has usually been presented as the boundary between the homogeneous (H) and stripe-domains (SD) regime, respectively below and above $d_{cr}$. In this work we study the transition from the H to the SD regime in thin films and microstructured bridges of Py with different thicknesses. We find the…