Search results for "Applied Physics"
showing 10 items of 1226 documents
Charge injection and trapping at perovskite interfaces with organic hole transporting materials of different ionization energies
2019
The extraction of photogenerated holes from CH3NH3PbI3 is crucial in perovskite solar cells. Understanding the main parameters that influence this process is essential to design materials and devices with improved efficiency. A series of vacuum deposited hole transporting materials (HTMs) of different ionization energies, used in efficient photovoltaic devices, are studied here by means of femtosecond transient absorption spectroscopy. We find that ultrafast charge injection from the perovskite into the different HTMs (<100 fs) competes with carrier thermalization and occurs independently of their ionization energy. Our results prove that injection takes place from hot states in the valence…
Characterization of the defect density states in MoOx for c-Si solar cell applications
2021
Thin layers of MoOx have been deposited by thermal evaporation followed by post-deposition annealing. The density of states distributions of the MoOx films were extracted deconvoluting the absorption spectra, measured by a photothermal deflection spectroscopy setup, including the small polaron contribution. Results revealed a sub-band defect distribution centered 1.1 eV below the conduction band; the amplitude of this distribution was found to increase with post-deposition annealing temperature and film thickness.
Analysis of the electromagnetic radiation generated by a multipactor discharge occurring within a microwave passive component
2010
International audience; Multipactoring is a non-linear phenomenon that appears in highpower microwave equipments operating under vacuum conditions and causes several undesirable effects. In this manuscript, a theoretical and experimental study of the RF spectrum radiated by a multipactor discharge, occurring within a realistic microwave component based on rectangular waveguides, is reported. The electromagnetic coupling of a multipactor current to the fundamental propagative mode of a uniform waveguide has been analyzed in the context of the microwave network theory. The discharge produced under a single-carrier RF voltage regime has been approached as a shunt current source exciting such a…
Low-frequency band gap in cross-like holey phononic crystal strip
2018
International audience; A silicon-based cross-like holey phononic crystal (PnC) strip is proposed for the control of elastic waves in the field of micro-electro-mechanical systems (MEMS). The goal is to obtain a broad bandgap at low frequencies with a lightweight structure. In this respect, the effects of varying the in-plane and the out-of-plane geometry parameters are discussed. After design, a gap-to-midgap ratio of 47% is obtained with an intermediate filling fraction of the solid material and a small thickness of the strip. The band gap can be moved to an extremely low frequency range while keeping the strip significantly smaller than previously reported PnC strips. The transmission pr…
Effects of 5 MeV electron irradiation on deep traps and electroluminescence from near-UV InGaN/GaN single quantum well light-emitting diodes with and…
2020
The electrical properties, electroluminescence (EL) power output and deep trap spectra were studied before and after 5 MeV electron irradiation of near-UV single-quantum-well (SQW) light-emitting diodes (LED) structures differing by the presence or absence of InAlN superlattice underlayers (InAlN SL UL). The presence of the underlayer is found to remarkably increase the EL output power and the radiation tolerance of LEDs, which correlates with a much lower and more slowly changing density of deep traps in the QW region with radiation dose, and the higher lifetime of charge carriers, manifested by higher short-circuit current and open-circuit voltage in current–voltage characteristics under …
Characterization of Different Cable Ferrite Materials to Reduce the Electromagnetic Noise in the 2–150 kHz Frequency Range
2018
The gap of standardization for conducted and field coupled electromagnetic interferences (EMI) in the 2–150 kHz frequency range can lead to Electromagnetic Compatibility (EMC) problems. This is caused by power systems such as Pulse Width Modulation (PWM) controlled rectifiers, photovoltaic inverters or charging battery units in electric vehicles. This is a very important frequency spectral due to interferences generated in a wide range of devices and, specifically, communication problems in the new technologies and devices incorporated to the traditional grid to convert it into a Smart Grid. Consequently, it is necessary to provide new solutions to attenuate this kind of interference, which…
Laser ultrasonics for defect evaluation on coated railway axles
2020
Abstract This scientific paper focuses on the application of an advanced non-destructive technique for an effective inspection of railway axles. The method pertains to ultrasonic techniques, which are widely used in the railway field. The experimental investigation was carried out on simulated defects tooled near the cross section reduction of the axle, in order to simulate fatigue cracks which, due to notch effect, can trigger crack propagation and axle failure. The aim of this research activity is to evaluate how efficiently the proposed technique detects defects and to verify its applicability to axles with a black coating for protection. In view of the experimental setup, comprising a p…
Positron annihilation probing of crystallization effects in TAS-235 glass affected by Ga additions
2014
Abstract Crystallization effects in Te20As30Se50 glass known also as TAS-235 affected by Ga additions to Ga2Te20As28Se50 and Ga5Te20As25Se50 compositions are probed with positron annihilation spectroscopy in the measuring modes exploring positron lifetimes and Doppler broadening of annihilation line. Occurring of cubic-phase Ga2Se3 droplets with character nanoscale sizes in partially-crystallized Ga2Te20As28Se50 alloy is shown to be associated with agglomeration of intrinsic free-volume voids, this process being enhanced over microcrystalline scale in Ga5Te20As25Se50 alloy. Crystallization changes in the void structure of TAS-235 glass are considered in terms of free-volume evolution under …
Study of magnesium and aluminum alloys absorption coefficient during Nd:YAG laser interaction
2007
International audience; In laser processes, the absorption factor of laser Nd:YAG by metals plays a very important role. In order to model laser welding, we need to know its evolution during the process. The theoretical calculation does not enable the prediction of the absorption factor in the case of a keyhole mode. It is difficult to predict the effect of plasma and recoil pressure on the shape of the keyhole. In this paper, an integrating sphere is used to determine the absorption factor during the laser process, which is carried out on two types of magnesium alloys (WE43 and RZ5) and an aluminum alloy. We obtain the evolution in time of the absorption factor according to different steps…
Thermostimulated luminescence of plasma electrolytic oxidation coatings on 6082 aluminium surface
2019
Financial support provided by Scientific Research Project for Students and Young Researchers Nr. SJZ/2016/12 realized at the Institute of Solid State Physics, University of Latvia is greatly acknowledged. Authors are grateful to R. Ignatans for measurements and analysis of XRD spectra and ElGoo Tech ltd. for providing PEO equipment.