Search results for "Biot"

Artificial Biosystems by Printing Biology

2020

The continuous progress of printing technologies over the past 20 years has fueled the development of a plethora of applications in materials sciences, flexible electronics, and biotechnologies. More recently, printing methodologies have started up to explore the world of Artificial Biology, offering new paradigms in the direct assembly of Artificial Biosystems (small condensates, compartments, networks, tissues, and organs) by mimicking the result of the evolution of living systems and also by redesigning natural biological systems, taking inspiration from them. This recent progress is reported in terms of a new field here defined as Printing Biology, resulting from the intersection betwee…

Impact of accumulated dust particles' charge on the photovoltaic module performance

2016

Abstract This work is focused on analysing effect of accumulated dust particles' charge on PV module performance. In the Dundee University's laboratory, dust particles have been created through epoxy powder and charged by using corona and tribo-electric charging methods by varying the charge levels of the accumulated dust particles. The PV module output has analysed for finding a relation between charge levels of the accumulated dust particles and its output voltage. Obtained experimental results have shown that charge level of accumulated dust particles on PV module's have significant impact on its output and dust particle accumulations are not associated with panel tilt angle.

Metal distribution in the process of lignocellulosic ethanol production from heavy metal contaminated sorghum biomass

2016

Effect of high hydrostatic pressure on extraction of B-phycoerythrin from Porphyridium cruentum: Use of confocal microscopy and image processing

2019

International audience; The aim of the study was to extract B-phycoerythrin from Porphyridium cruentum while preserving its structure. The high hydrostatic pressure treatments were chosen as extraction technology. Different methods have been used to observe the effects of the treatment: spectrophotometry and confocal laser scanning microscopy followed by image processing analysis. Image processing led to the generation of masks used for the identification of three clusters: intra, extra and intercellular. All methods showed that high hydrostatic pressure treatments between 50 and 500 MPa failed to extract B-phycoerythrin from Porphyridium cruentum cells. The fluorescence emission was negati…

Sea water desalination and energy consumption: A case study of wave energy converters (WEC) to desalination applications in sicily

2016

Recent studies about interactions among energy and water are considered as a new field of research. As almost all energy generation processes require significant amounts of water, and water requires energy for treatment and transport, so these two resources are inextricably linked. The main aim of this work is a presentation of the use of renewable energy for desalination plants in Sicily: in particular exploitation of wave energy into electrical energy necessary for water treatment. Desalination is the most energy intensive water treatment technology but it could be solution for many problems in water supply for areas with chronic debt of water. The aim of this work is a description of a s…

Optimization of 3-DOF Parallel Motion Devices for Low-Cost Vehicle Simulators

2017

Motion generation systems are becoming increasingly important in certain Virtual Reality (VR) applications, such as vehicle simulators. This paper deals with the analysis of the Inverse Kinematics (IK) and the reachable workspace of a three-degrees-of-freedom (3-DOF) parallel manipulator, proposing different transformations and optimizations in order to simplify its use with Motion Cueing Algorithms (MCA) for self-motion generation in VR simulators. The proposed analysis and improvements are performed on a 3-DOF heave-pitch-roll manipulator with rotational motors, commonly used for low-cost motion-based commercial simulators. The analysis has been empirically validated against a real 3-DOF …

Experimental study and numerical simulation of inclined rectangular weirs

2018

Inclined rectangular weirs, also named pivot weirs, are used both to adjust the upstream water level and to increase the flow capacity compared with that of normal rectangular weirs. However, the experimental studies available in the literature present contradictory conclusions for the inclined weir discharge capacity. In this paper, new experimental runs and numerical simulations were performed to investigate the effect of the rectangular weir inclination angle on the stage-discharge formula. The experiments were carried out using inclination angles ranging from 30° to 90°. Buckingham's theorem of dimensional analysis was used to obtain an equation for the flow magnification ratio (the dis…

Flow measurement using circular portable flume

2018

Abstract The circular portable flume is a simple device to measure discharge in circular drainage networks. Since the unit can be easily installed and removed, it is helpful in water distribution measurement and management. First in this paper the available studies are reviewed for highlighting the effect of both the contraction ratio and the flume slope on the stage-discharge relationship. Then the Buckingham's Theorem of the dimensional analysis and the self-similarity theory are used to deduce the stage-discharge curve of the circular flume. The new theoretical stage-discharge equation is calibrated by the literature available experimental data and those obtained in this experimental inv…

A new strategy to maximize organic matter valorization in municipalities: combination of urban wastewater with kitchen food waste and its treatment w…

2017

[EN] The aim of this study was to evaluate the feasibility of treating the kitchen food waste (FW) jointly with urban wastewater (WW) in a wastewater treatment plant (WWTP) by anaerobic membrane technology (AnMBR). The experience was carried out in six different periods in an AnMBR pilot-plant for a total of 536 days, varying the SRT, HRT and the food waste penetration factor (PF) of food waste disposers. The results showed increased methane production of up to 190% at 70 days SRT, 24 hours HRT and 80% PF, compared with WW treatment only. FW COD and biodegradability were higher than in WW, so that the incorporation of FW into the treatment increases the organic load and the methane producti…

A comprehensive comparison between halophilic granular and flocculent sludge in withstanding short and long-term salinity fluctuations

2018

The effects of salinity fluctuations on the activity of autochthonous halophilic bacteria in aerobic granular sludge (AGS) and flocculent activated sludge (FAS) reactors were investigated. The response of nitrifiers and denitrifiers activity to drastic and moderate salinity shocks in the short-term (ST) and long-term (LT) was examined. The BOD5removal efficiency decreased only in the reactors subjected to the drastic LT salinity increase. Nevertheless, stable performances were achieved 18 days after the shock in the AGS-R1 (90%), whereas after 27 days in the FAS-R1 (82%). The loss in nitritation efficiency was higher in the FAS reactors and was proportional to the shock intensity. Nitritati…