Search results for "CALORIMETER"
showing 10 items of 197 documents
Scintillators for photon detection at medium energies—a comparative study of BaF2, CeF3 and PbWO4
2002
Abstract In a comparative study, the performance of sub-arrays consisting of large CeF 3 and PbWO 4 crystals has been investigated with high-energy photons below 1 GeV. Energy and time resolutions are determined and compared with the corresponding values for BaF 2 based on the experience of operating the electromagnetic calorimeter Taps .
The isospin structure of photoproduction of πη pairs from the nucleon in the threshold region
2015
Abstract Photoproduction of πη-pairs from nucleons has been investigated from threshold up to incident photon energies of ≈ 1.4 GeV. The quasi-free reactions γ p → p π 0 η , γ n → n π 0 η , γ p → n π + η , and γ n → p π − η were for the first time measured from nucleons bound in the deuteron. The corresponding reactions from a free-proton target were also studied to investigate final-state interaction effects (for neutral pions the free-proton results could be compared to previous measurements; the γ p → n π + η reaction was measured for the first time). For the π 0 η final state coherent production via the γ d → d π 0 η reaction was also investigated. The experiments were performed at the …
Point-to-point readout for the ALICE EMCal detector
2014
Abstract It is anticipated that the LHC will deliver Pb+Pb collisions at a minimum bias interaction rate of about 50 kHz after the second long shutdown of the LHC in 2018. This will be roughly two orders of magnitude greater than the current data recording rate capability of the ALICE experiment. Therefore a major upgrade of the ALICE detector is planned for the next shutdown to enable ALICE to record data at the full Pb+Pb minimum bias interaction rate delivered by the LHC. A new point-to-point readout system for the electromagnetic calorimeter (EMCal) of ALICE has been developed, to replace the legacy readout bus, that essentially accomplishes this goal, and is being installed during the …
Testbeam studies of production modules of the ATLAS Tile Calorimeter
2009
We report test beam studies of {11\,\%} of the production ATLAS Tile Calorimeter modules. The modules were equipped with production front-end electronics and all the calibration systems planned for the final detector. The studies used muon, electron and hadron beams ranging in energy from 3~GeV to 350~GeV. Two independent studies showed that the light yield of the calorimeter was $\sim 70$~pe/GeV, exceeding the design goal by {40\,\%}. Electron beams provided a calibration of the modules at the electromagnetic energy scale. Over 200~calorimeter cells the variation of the response was {2.4\,\%}. The linearity with energy was also measured. Muon beams provided an intercalibration of the respo…
Performance of the ATLAS Hadronic End-Cap Calorimeter in Beam Tests
2001
Abstract Modules of the ATLAS liquid argon Hadronic End-cap Calorimeter (HEC) were exposed to beams of electrons, muons and pions in the energy range 6⩽ E ⩽200 GeV at the CERN SPS. A description of the HEC and of the beam test setup are given. Results on the energy response and resolution are presented and compared with simulations. The ATLAS energy resolution for jets in the end-cap region is inferred and meets the ATLAS requirements.
Results of prototype studies for a spaghetti calorimeter
1990
In the framework of the LAA project, prototypes for a new type of calorimeter, intended for the detection of both electromagnetic (e.m.) and hadronic showers, muons and missing energy (e.g. neutrinos) at high-luminosity multi-TeV pp colliders, were tested. The detector consists of scintillating plastic fibres embedded in a lead matrix at a volume ratio 1:4, such as to achieve compensation. The optimization of the construction of the detector modules is described, as well as the performance concerning e.m. shower and muon detection and e/π separation. We used electron, pion and muon beams in the energy range 10–150 GeV for this purpose. For the energy resolution of electrons we found 13%/trE…
Electromagnetic calorimetry with PbWO/sub 4/ in the energy regime below 1 GeV
2003
The study of the performance and application of PbWO/sub 4/ in electromagnetic calorimetry at energies far below 1 GeV has been continued. The significantly improved optical and scintillation properties of 15 cm long Nb/La-doped crystals, optimized for the ECAL/CMS calorimeter, are documented. The lineshape, energy and time response of a 5/spl times/5 matrix are tested with monoenergetic photons up to 790 MeV energy and compared to previous measurements. First attempts have been made to enhance the scintillation yield by suitable dopants (Mo,Tb) for applications at very low photon energies. As a first large scale project at medium energies, the proposed concept for a compact photon spectrom…
The ATLAS tile calorimeter ROD injector and multiplexer board
2011
Abstract The ATLAS Tile Calorimeter is a sampling detector composed by cells made of iron-scintillator tiles. The calorimeter cell signals are digitized in the front-end electronics and transmitted to the Read-Out Drivers (RODs) at the first level trigger rate. The ROD receives triggered data from up to 9856 channels and provides the energy, phase and quality factor of the signals to the second level trigger. The back-end electronics is divided into four partitions containing eight RODs each. Therefore, a total of 32 RODs are used to process and transmit the data of the TileCal detector. In order to emulate the detector signals in the production and commissioning of ROD modules a board call…
Electron-pion discrimination with a scintillating fiber calorimeter
1990
Abstract We report on an experimental study of a variety of techniques for discriminating between (isolated) electrons and pions in a lead and scintillating fiber calorimeter without longitudinal segmentation. Using information from the lateral shower development, from a pre-shower detector, from the time structure of the signals, or from a combination of these we measure pion rejection factors of up to several thousand while maintaining electron efficiencies of 95% or higher.
First measurement of the rate K0L → πμνγ
1998
Abstract In a preliminary version of the NA48 experiment at the CERN SPS, in which an iron-scintillator sandwich calorimeter was used as a photon detector, the ratio of K L → πμνγ and K L → πμν decays was measured. The branching ratio BR(K L →πμνγ, E γ ∗ ≥30 MeV )/(K L → πμν ) is found to be (2.08±0.17 +0.16 −0.21 )×10 −3 , where the first error is statistical and the second systematic. The result is in agreement with theoretical predictions.