Search results for "Construction"
showing 10 items of 2670 documents
Software zur automatischen Quantifizierung von Belüftungszuständen bei akutem Lungenversagen in dynamischen CT-Aufnahmen der Lunge1
2001
Purpose: Density measurements in dynamic CT image series of the lungs allow one to quantify ventilated, hyperinflated, and atelectatic pulmonary compartments with high temporal resolution. Fast automatic segmentation of lung parenchyma and a subsequent evaluation of it's respective density values are a prerequisite for any clinical application of this technique. Material and Methods: For automatic lung segmentation in thoracic CT scans, an algorithm was developed which uses (a) different density masks, and (b) anatomic knowledge to differentiate heart, diaphragm and chest wall from ventilated and atelectatic lung parenchyma. With Animal Care Committee approval, the automated technique was t…
Abdominal wall reconstruction by a regionally distinct biocomposite of extracellular matrix digest and a biodegradable elastomer.
2013
Current extracellular matrix (ECM) derived scaffolds offer promising regenerative responses in many settings, however in some applications there may be a desire for more robust and long lasting mechanical properties. A biohybrid composite material that offers both strength and bioactivity for optimal healing towards native tissue behavior may offer a solution to this problem. A regionally distinct biocomposite scaffold composed of a biodegradable elastomer (poly(ester urethane)urea) and porcine dermal ECM gel was generated to meet this need by a concurrent polymer electrospinning/ECM gel electrospraying technique where the electrosprayed component was varied temporally during the processing…
On the variations of acoustic absorption peak with particle velocity in micro-perforated panels at high level of excitation.
2010
The acoustic behavior of micro-perforated panels (MPP) is studied theoretically and experimentally at high level of pressure excitation. A model based on Forcheimer's regime of flow velocity in the perforations is proposed. This model is valid at relatively high Reynolds numbers and low Mach numbers. The experimental method consists in measuring the acoustical pressure at three different positions in an impedance tube, the two measurement positions usually considered in an impedance tube and one measurement in the vicinity of the rear surface of the MPP. The impedance tube is equipped with a pressure driver instead of the usual loudspeaker and capable of delivering a high sound pressure lev…
Landfill gas upgrading with pilot-scale water scrubber: Performance assessment with absorption water recycling
2012
Abstract A pilot-scale counter current absorption process for upgrading municipal solid waste (MSW) landfill gas to produce vehicle fuel was studied using absorption, desorption and drying units and water as an absorbent. Continuous water recycling was used without adding new water to the system. The process parameters were defined by a previous study made with this pilot system. The effect of pressure (20–25 bar), temperature (10–25 °C) and water flow speed (5.5–11 l/min) on the upgrading performance, trace compounds (siloxanes, halogenated compounds) and water quality were investigated. Raw landfill gas flow was kept constant at 7.41 Nm3/h. Methane (CH4) and carbon dioxide (CO2) contents …
Promoting children’s participation: the role of teachers in preschool and primary school learning sessions
2010
The aim of this study is to provide insights into the social construction of participation in joint activities in Finnish preschool and primary school classrooms. The article deals with two issues: How do teachers promote participation in a preschool classroom as compared with a primary school classroom? What similarities and differences are found? It also considers the question of how the similarities contribute to the continuity from preschool to primary school in terms of participation. Based on observation data insights are provided into the interactions between teachers and children by using extracts from teacher‐led learning sessions. The teachers used a diversity of strategies to pro…
Feasibility of using more polishable aggregates in dense-graded asphalt surface mixture: Case study of dolomite
2022
This study aimed to evaluate the feasibility of using more dolomite aggregates in asphalt surface mixtures that are typically used by West Virginia Division of Highways (WVDOH). The laboratory test results indicated that increasing dolomite content in asphalt surface mixtures resulted in a faster deterioration rate at the early polishing stage. In addition, asphalt surface mixtures containing more than 50% dolomite coarse aggregates would significantly reduce roadway safety. The field test results validated that dolomite shall not exceed 50% of coarse aggregate in asphalt surface mixture if the projected traffic volume is greater than 3.0 million equivalent single axle loads (ESALs).
Technical Note: Prediction Models of Airborne Sound Insulation of Multilayer Materials with Viscoelastic Thin Sheets
2008
The growing introduction of new insulation materials in building acoustics has caused an increase of the importance of the prediction tools. Appropriate simulations allow strictly necessary laboratory measurements to be identified. In this way, costs are reduced. The demands of new legislation has resulted in the appearance of various software designed to facilitate prediction. The prediction models are based on different hypotheses: adaptation of impedances, spatial behaviour of spectral components, statistical energy distribution, the Finite Element Method (FEM), etc. Each of these models and methods offer advantages and contain limitations. In this paper, different models for prediction…
Tinkering with the two-to-one interview: Reflections on the use of two interviewers in qualitative constructionist inquiry
2021
Abstract Typically, qualitative interviews implicate a single interviewer. In this article, we consider an alternative comprising the simultaneous, active involvement of two interviewers. We base our considerations on experiences using the two-to-one interview in a nationwide research project on disability and physical activity. In addition to untapping and developing a qualitative interview method, the article provides an example in action of tinkering in qualitative inquiry. Tinkering entails a constant questioning of what to do, what is best, and what is appropriate within each moment of the research. Echoing social constructionist scholars, we argue that this flexible approach is useful…
Novel solutions for closed-loop Reverse Electrodialysis: thermodynamic characterisation and perspective analysis
2019
Abstract Closed-loop Reverse Electrodialysis is a novel technology to directly convert low-grade heat into electricity. It consists of a reverse electrodialysis (RED) unit where electricity is produced exploiting the salinity gradient between two salt-water solutions, coupled with a regeneration unit where waste-heat is used to treat the solutions exiting from the RED unit and restore their initial composition. One of the most important advantages of closed-loop systems compared to the open systems is the possibility to select ad-hoc salt solutions to achieve high efficiencies. Therefore, the properties of the salt solutions are essential to assess the performance of the energy generation a…
Data-based modeling of vehicle crash using adaptive neural-fuzzy inference system
2014
Vehicle crashes are considered to be events that are extremely complex to be analyzed from the mathematical point of view. In order to establish a mathematical model of a vehicle crash, one needs to consider various areas of research. For this reason, to simplify the analysis and improve the modeling process, in this paper, a novel adaptive neurofuzzy inference system (ANFIS-based) approach to reconstruct kinematics of colliding vehicles is presented. A typical five-layered ANFIS structure is trained to reproduce kinematics (acceleration, velocity, and displacement) of a vehicle involved in an oblique barrier collision. Subsequently, the same ANFIS structure is applied to simulate different…