Search results for "Detector"
showing 10 items of 3491 documents
The TRAPSENSOR facility: an open-ring 7 tesla Penning trap for laserbased precision experiments
2019
APenning-trap facility for high-precision mass spectrometry based on a novel detection method has been built. This method consists in measuring motional frequencies of singly-charged ions trapped in strong magnetic fields through the fluorescence photons from laser-cooled 40Ca+ ions, to overcome limitations faced in electronic single-ion detection techniques. The key element of this facility is an open-ring Penning trap coupled upstream to a preparation Penning trap similar to those used at Radioactive Ion Beam facilities. Here we present a full characterization of the trap and demonstrate motional frequency measurements of trapped ions stored by applying external radiofrequency fields in r…
Development of a New Clusterization Method for the GEM-TPC Detector
2022
The Facility for Antiproton and Ion Research FAIR, in Darmstadt Germany, will be one of the largest accelerator laboratories worldwide. The Superconducting FRagment Separator (Super-FRS)* is one of its main components. The Super-FRS can produce, separate and deliver high-energy radioactive beams with intensities up to 1e11 ions/s, covering projectiles from protons up to uranium and it can be used as an independent experimental device. The Gas Electron Multiplier-based Time Projection Chambers (GEM-TPC) in twin configuration is a newly developed beam tracking detector capable of providing spatial resolution of less than 1 mm with a tracking efficiency close to 100% at 1 MHz counting rate. Th…
A Composite Phononic Crystal Design for Quasiparticle Lifetime Enhancement in Kinetic Inductance Detectors
2020
A nanoscale phononic crystal filter (reflector) is designed for a kinetic inductance detector where the reflection band is matched to the quasiparticle recombination phonons with the aim to increase quasiparticle lifetime in the superconducting resonator. The inductor is enclosed by a 1-μm-wide phononic crystal membrane section with two simple hole patterns that each contain a partial spectral gap for various high-frequency phonon modes. The phononic crystal is narrow enough for low-frequency thermal phonons to propagate unimpeded. With 3D phonon scattering simulation over a 40 dB attenuation in transmitted power is found for the crystal, which is estimated to give a lifetime enhancement of…
Design and development of a continuous wave functional near infrared spectroscopy system
2014
Functional Near InfraRed Spectroscopy uses light sources and optical detectors for human brain monitoring. In this paper, a portable, low cost, battery-operated, multi-channel, continuous wave fNIRS embedded system, hosting up to 64 LED sources and 128 Silicon PhotoMultiplier optical detectors, is reported on. The designed system is based on a scalable architecture, in which each probe consists of 8 modular and flexible stands, able to host 4 bi-color LEDs as light sources, 16 silicon photomultipliers as photodetectors and a temperature sensor. The hardware structure allows to easily set up several relevant parameters: the timing of the LEDs, the optical power emitted by the LEDs; the acqui…
Design of a Multichannel Continuous Wave fNIRS System implemented with SiPM
2013
Development of a CW-fNIRS System for brain monitoring
2014
Progettazione e realizzazione di un sistema Continuous Wave fNIRS basato su tecnologia SiPM
2014
Progettazione e realizzazione di un sistema Continuous Wave fNIRS basato su tecnologia SiPM
Optical techniques represent a suitable tool for in vivo and non-invasive diagnosis of human brain and tissues. Functional Near InfraRed Spectroscopy (fNIRS) is revealing as an emerging neuroimaging technology, since it is safe, relatively inexpensive and little cumbersome. fNIRS relies on the measurement of the oxygen concentration in the blood by means of light beams impinging on the tissues under test. Haemoglobin concentration variations (oxygenated/deoxygenated) can provide very important information on brain activity and allow to discriminate the main brain area involved during tests. Herein, we present the design and development of an innovative solution for a portable continuous wav…
The Large Hadron–Electron Collider at the HL-LHC
2021
The Large Hadron-Electron Collider (LHeC) is designed to move the field of deep inelastic scattering (DIS) to the energy and intensity frontier of particle physics. Exploiting energy-recovery technology, it collides a novel, intense electron beam with a proton or ion beam from the High-Luminosity Large Hadron Collider (HL-LHC). The accelerator and interaction region are designed for concurrent electron-proton and proton-proton operations. This report represents an update to the LHeC's conceptual design report (CDR), published in 2012. It comprises new results on the parton structure of the proton and heavier nuclei, QCD dynamics, and electroweak and top-quark physics. It is shown how the LH…
Window-Based Energy Selecting X-ray Imaging and Charge Sharing in Cadmium Zinc Telluride Linear Array Detectors for Contaminant Detection
2023
The spectroscopic and imaging performance of energy-resolved photon counting detectors, based on new sub-millimetre boron oxide encapsulated vertical Bridgman cadmium zinc telluride linear arrays, are presented in this work. The activities are in the framework of the AVATAR X project, planning the development of X-ray scanners for contaminant detection in food industry. The detectors, characterized by high spatial (250 µm) and energy (<3 keV) resolution, allow spectral X-ray imaging with interesting image quality improvements. The effects of charge sharing and energy-resolved techniques on contrast-to-noise ratio (CNR) enhancements are investigated. The benefits of a new energy-resolved …