Search results for "Dig"
showing 10 items of 9604 documents
Silicon dosimeters based on Floating Gate Sensor: design, implementation and characterization
2020
A rad-hard monolithic dosimeter has been implemented and characterized in a standard 180 nm CMOS technology. The radiation sensor (C-sensor) is based on a Floating Gate (FG) MOS discharge principle. The output current is processed by a current-to-voltage (I/V) interface and then converted by a 5-bit flash ADC. The dosimeter is re-usable (FG can be recharged) and can detect a dose up to 1krad (Si) with a resolution of 30rad (Si) typical over temperature 0 to 85°C range. The ADC allows easy further signal processing for calibration and averaging, etc. The power consumption of C-sensor plus I/V interface is < 2mW from a 5 V power supply. The overall layout area is less than 0.25mm2. The Rad…
Low complexity digital background calibration algorithm for the correction of timing mismatch in time-interleaved ADCs
2019
Abstract A low-complexity post-processing algorithm to estimate and compensate for timing skew error in a four-channel time-interleaved analog to digital converter (TIADC) is presented in this paper, together with its hardware implementation. The Lagrange interpolator is used as the reconstruction filter which alleviates online interpolator redesign by using a simplified representation of coefficients. Simulation results show that the proposed algorithm can suppress error tones for input signal frequency from 0 to 0.4 f s . The proposed structure has, at least, 41% reduction in the number of required multipliers. Implementation of the algorithm, for a four-channel 10-bit TIADC, show that, f…
Real-time signal processing in embedded systems
2016
International audience
N,N′-Disubstituted Indigos as Readily Available Red-Light Photoswitches with Tunable Thermal Half-Lives
2017
Some rare indigo derivatives have been known for a long time to be photochromic upon irradiation with red light, which should be advantageous for many applications. However, the absence of strategies to tune their thermal half-lives by modular molecular design as well as the lack of proper synthetic methods to prepare a variety of such molecules from the parent indigo dye have so far precluded their use. In this work, several synthetic protocols for N-functionalization have been developed, and a variety of N-alkyl and N-aryl indigo derivatives have been prepared. By installation of electron-withdrawing substituents on the N-aryl moieties, the thermal stability of the Z-isomers could be enha…
Modeling Rain Isotopic Composition under Orographic Control: A Landscape Approach for Hydrogeological Applications
2021
Oxygen isotopic composition is useful for individuating recharge areas of groundwater bodies by the comparison with those of local rainfalls. While on a global scale general relationships, such as the isotopic vertical gradient or continentality effects, efficiently describe spatial variations of the isotopic signature, hydrogeological applications need spatial models that are more focused on the effects of local topographic structures and/or subsoil geology. This work presents a case study in northeastern Sicily (Italy) characterized by complex geological and orographic structures, in which isotopic composition of rainfalls is governed by orographic effects and the varying initial composit…
Digital thermal monitoring of the Amazon forest: an intercomparison of satellite and reanalysis products
2015
Remote sensing and climate digital products have become increasingly available in recent years. Access to these products has favored a variety of Digital Earth studies, such as the analysis of the impact of global warming over different biomes. The study of the Amazon forest response to drought has recently received particular attention from the scientific community due to the occurrence of extreme droughts and anomalous warming over the last decade. This paper focuses on the differences observed between surface thermal anomalies obtained from remote sensing moderate resolution imaging spectroradiometer (MODIS) and climatic (ERA-Interim) monthly products over the Amazon forest. With a few e…
Measuring rill erosion using structure from motion: A plot experiment
2017
Abstract In this paper the results of a plot experiment on rill erosion are reported. The rill network, manually incised on the soil and further shaped by a clear inflow discharge, was surveyed using the three-dimensional photo-reconstruction (3D-PR) technique which allows to obtain a digital terrain model (DTM) by a large series of oblique images of the channel from consumer un-calibrated and non-metric cameras. The three-dimensional (3D) DTM and the quasi-tridimensional (2.5D) model were generated by Agisoft Photoscan software. For a single rill channel, the reliability of the 3D image-based ground measurements of morphological and hydraulic variables was positively tested by the correspo…
A novel comprehensive procedure for estimating greenhouse gas emissions from water resource recovery facilities
2017
The emissions of the major greenhouse gases (GHGs), i.e. carbon dioxide (CO2), methane (CH4), and nitrous oxide (N2O) from water resource recovery facilities (WRRFs) are of increasing concern in the water industry. In order to produce useful and comparable information for monitoring, assessing, and reporting GHG emissions from WRRFs, there is a need for a generally accepted methodology for their quantification. This paper aims at proposing the first protocol for monitoring and accounting for GHG emissions from WRRFs, taking into account both direct and indirect internal emissions and focusing the attention on plant sections known to be primarily responsible for GHG emissions (i.e. oxidation…
The global forest above-ground biomass pool for 2010 estimated from high-resolution satellite observations
2021
Funding Information: We are thankful to the GlobBiomass project team and Frank Martin Seifert (ESA) for valuable suggestions and stimulating scientific discussions. We are thankful to Takeo Tadono (JAXA EORC), Masato Hayashi, (JAXA EORC), Kazufumi Kobayashi (RESTEC), Åke Rosenqvist (soloEO), and Josef Kellndorfer (EBD) for support with the use and interpretation of the ALOS PALSAR mosaics. Support by the CCI Land Cover project team, in particular Sophie Bontemps (UCL), is greatly acknowledged. The help from Martin Jung (MPI-BGC) in feature selection and Ulrich Weber (MPI-BGC) for data processing for the GSV-to-AGB conversions is greatly acknowledged. Forest inventory data for the validation…
The joint sets on the Lilstock Benches, UK. Observations based on mapping a full resolution UAV-based image
2021
Outcrop studies of fracture networks are important to understand fractured reservoirs in the subsurface, but complete maps of all fractures in large outcrops are rare due to limitations of outcrop and image resolution. We manually mapped the first full-resolution UAV-based, Gigapixel dataset and DEM of the wave-cut Lilstock Benches in the southern Bristol Channel basin, a classic outcrop of layer-bound fracture networks in limestones. We present a map of the patterns and age relationships of successive sets of joints in dm-thick limestone layers separated by claystone beds. Using interpretation criteria based on crosscutting relationships, abutting and joint length, up to eight successive s…