Search results for "Dispersion."
showing 10 items of 1094 documents
Strong coupling between surface plasmon polaritons and Sulforhodamine 101 dye
2011
We demonstrate a strong coupling between surface plasmon polaritons and Sulforhodamine 101 dye molecules. Dispersion curves for surface plasmon polaritons on samples with a thin layer of silver covered with Sulforhodamine 101 molecules embedded in SU-8 polymer are obtained experimentally by reflectometry measurements and compared to the dispersion of samples without molecules. Clear Rabi splittings, with energies up to 360 and 190 meV, are observed at the positions of the dye absorption maxima. The split energies are dependent on the number of Sulforhodamine 101 molecules involved in the coupling process. Transfer matrix and coupled oscillator methods are used to model the studied multilaye…
Impact of the inclusion of hydrotalcite on the morphological and electrical characteristics of an epoxy-based CNT nanocomposite
2012
The experimental results concerning the correlation between morphological and electrical characteristics of a MWCNT/epoxy based composites are presented. The impact of a nanoclay filler is investigated on the DC conductivity of a matrix loaded with different concentrations of MWCNT in order to evaluate the improvements on the dispersion of CNT inside the epoxy matrix. The dispersion is deemed to be very influencing on the electrical conductivity of the nanocomposite. A detailed morphological and structural characterization allows to interpret the electrical behaviour of the nanocomposites. © 2012 IEEE.
Novel non-destructive evaluation technique for the detection of poor dispersion of carbon nanotubes in nanocomposites
2019
Abstract A wide use of advanced carbon nanotube polymer composites can be boosted by new non-destructive evaluation (NDE) techniques that can test the quality of the products to ensure that their specifications are met. It is well known in literature that the parameter that far more than others can affect the enhancing capabilities of the carbon nanotubes is their dispersion. Here we have presented a novel NDE technique based on infrared thermography able to evaluate the dispersion of the added nanoparticles in polymer nanocomposites. The NDE technique was used to compare pairs of samples whose difference is represented only by the level of dispersion. It was found a significant difference …
Preparation and characterization of polyamide 6/polyethylene blend-clay nanocomposites in the presence of compatibilisers and stabilizing system
2010
Abstract Several compatibilising systems were added to high-density polyethylene (HDPE) and polyamide 6 (PA6) blends in the presence of an organically modified montmorillonite (OMM). All the blends were prepared by using a co-rotating twin-screw extruder and characterized by SEM, TEM and XRD analyses. In addition, the rheological behaviour and the mechanical properties – tensile and impact – were evaluated. The presence of OMM affects the dimensions of the polymeric phases in the blend but not their mutual adhesion, granted only by the compatibilisers. TEM, SEM and XRD analyses indicated that there is a strict correlation between the compatibilisation level and the final interlayer distance…
Exploiting the Colloidal Stability and Solubilization Ability of Clay Nanotubes/Ionic Surfactant Hybrid Nanomaterials
2012
Halloysite clay nanotubes are functionalized by exploiting the different charges between the inner positive and the outer negative surfaces; accordingly, a selective adsorption is pursued by employing anionic and cationic surfactants. The obtained hybrid materials dispersed in aqueous phase are studied from the physicochemical viewpoint to investigate the colloidal stability that is a crucial parameter for applications. It is demonstrated that the adsorption of anionic surfactant into the HNTs lumen increases the net negative charge of the nanotubes enhancing the electrostatic repulsions and consequently the dispersion stability. The solubilization capability of these functionalized nanotub…
Seeded intermodal four-wave mixing in a highly multimode fiber
2018
International audience; We experimentally and theoretically investigate the process of seeded intermodal four-wave mixing in a graded-index multimode fiber, pumped in the normal dispersion regime. By using a fiber with a 100-mu m core diameter, we generate a parametric sideband in the C-band (1530-1565 nm), hence allowing the use of an erbium-based laser to seed the mixing process. To limit nonlinear coupling between the pump and the seed to low-order fiber modes, the waist diameter of the pump beam is properly adjusted. We observe that the superimposed seed stimulates the generation of new spectral sidebands. A detailed characterization of the spectral and spatial properties of these sideb…
Octave-spanning ultraflat supercontinuum with soft-glass photonic crystal fibers
2009
We theoretically identify some photonic-crystal-fiber structures, made up of soft glass, that generate ultrawide (over an octave) and very smooth supercontinuum spectra when illuminated with femtosecond pulsed light. The design of the fiber geometry in order to reach a nearly ultraflattened normal dispersion behavior is crucial to accomplish the above goal. Our numerical simulations reveal that these supercontinuum sources show high stability and no significant changes are detected even for fairly large variations of the incident pulse. Ministerio de Ciencia e Innovación (TEC2008-05490) and Generalitat Valenciana (GV/2007/043).
Dispersion managed self-similar parabolic pulses
2008
International audience; We describe the propagation of a parabolic self-similar pulse in an anomalous dispersive nonlinear fibre. Given the capacity of a linearly chirped parabolic pulse to retain its typical shape over a short propagation distance, we introduce the concept of dispersion managed self-similar pulses and outline potential benefits in terms of spectral broadening enhancement.
Continuous Broadband MWP True-Time Delay with PbS-PMMA and -SU8 waveguides
2016
[EN] A new microwave true-time delay (TTD) photonic unit based on the dispersion of PbS colloidal quantum dots (QDs) in a Polymethyl methacrylate (PMMA) and the SU8 photoresist is presented. With this aim, the PbS-PMMA and PbS-SU8 nanocomposites are integrated on a silicon platform in the form of a planar and ridge waveguides, respectively. When PbS QDs on those structures are pumped below their band-gap, a phase shift and a temporal delay in an optically conveyed (at 1550 nm) microwave signal is performed. The results of these devices show potential benefits over current TTD technologies, since the proposed photonic waveguide structures allows real-time adjustment of the temporal delay by …
Widely Tunable Polarization Modulation Instability in D2O-Filled Microstructured Optical Fiber
2021
Polarization modulation instability (PMI) is a nonlinear effect in which two pump photons with identical polarization propagating in a nonlinear medium give rise to two new photons of different frequency and orthogonal polarization with respect to the pump photons [1] . In this work, we report the experimental demonstration of broad spectral tuning of PMI generated in solid-core microstructured optical fibers (MOF) that were previously infiltrated with heavy water (D 2 O). MOFs were designed and fabricated with the appropriate dispersion characteristics to produce widely spaced PMI spectral bands when they were filled with D 2 O and pumped at 1064 nm. Heavy water was chosen due to suitable …