Search results for "Electrical resistivity and conductivity"
showing 10 items of 317 documents
Delamination Detection in Carbon Fibre Reinforced Composites Using Electrical Resistance Measurement
2016
In the present study 2-D numerical analysis of strip-type laminated composite specimens with and without damage is considered and numerical investigation is carried out by using a finite element method. The surface and oblique resistances are numerically calculated according to the two-probe and four-probe methods. The electrical conductivity of the composite laminate in the longitudinal direction is constant, while the electrical conductivity in the through-thickness direction is used as a variable in the parametric study. The resistance change due to delamination for each case is estimated by comparing the obtained resistance with the corresponding resistance of the specimen without delam…
Vortex dynamics in Bi2Sr2CaCu2O8-thin films in the presence of columnar defects
1996
With heavy ion irradiation we create continous amorphous columnar defects in Bi2Sr2CaCu2O8-thin films. With regard to a reliable comparison of irradiation effects three of four identical striplines on the same samples were exposed to different irradiation procedures. We performed irradiations as well parallel as under different angles with respect to the film $$\vec c$$ -axis. Beside an enlarged normal state resistivity after irradiation the films suffer a Tc-reduction proportional to the volume of the damaged material. The activation energy ascertained from resistive transitions shows best enhancement for magnetic field values close to the matching field. Measurements of the transport crit…
Control of flow separation using electromagnetic forces
2003
Introduction If a fluid is electrically conductive, its flow may be controlled using electromagnetic forces. Meanwhile, this technique is a recognized tool even on an industrial scale for handling highly conductive materials like liquid metals. However, also fluids of low electrical conductivity as considered in the present study, like sea--water and other electrolytes, permit electromagnetic flow control. Experimental results on the prevention of flow separation by means of a streamwise, wall parallel Lorentz force acting on the suction side of inclined flat plates and hydrofoils will be presented. Force Configuration The stripwise arrangement of permanent magnets and electrodes of alterna…
Correlated effects of fluorine and hydrogen in fluorinated tin oxide (FTO) transparent electrodes deposited by sputtering at room temperature
2021
The optical and electrical properties of fluorinated tin oxide (FTO) films deposited at room temperature by sputtering have been investigated varying the fluorine content and the hydrogen atmosphere. The complex behavior of the obtained films is disclosed using a wide set of characterization techniques that reveals the combined effects of these two parameters on the generated defects. These defects control the electrical transport (carrier density, mobility and conductivity), the optical properties (band gap and defects-related absorption and photoluminescence) and finally promote the amorphization of the samples. H2 in the sputtering gas does not modify the H content in the films but induc…
Plasma-Enhanced Atomic Layer Deposition of Silver Thin Films
2011
Thermal properties of various silver precursors known in the literature were evaluated in order to discover which precursor is the most suitable one for plasma-enhanced atomic layer deposition (PEALD) of silver thin films. Ag(fod)(PEt3) (fod = 2,2-dimethyl-6,6,7,7,8,8,8-heptafluorooctane-3,5-dionato) was found to be the best choice. Using Ag(fod)(PEt3) together with plasma-activated hydrogen, silver thin films were deposited at growth temperatures of 120–150 °C, and ALD-type saturative growth was achieved at 120–140 °C. At 120 °C, the growth rate was 0.03 nm per cycle. The plasma exposure time had also an effect on the growth rate: with shorter exposure times, the growth rate was lower over…
LABORATORY INSTRUMENTATION TO STUDY CHANGES OF ELECTRICAL CONDUCTIVITY OF ROCKS WITH CHANGES OF FREQUENCY, TEMPERATURE AND PRESSURE*
1983
A laboratory instrument was developed to investigate the electrical properties of rock samples with respect to changes of frequency, temperature and pressure. The instrument can be used to obtain general trends and typical values for geological media. It should be of particular interest in geothermal studies and research in the geophysical properties of rocks. The design intervals for quantities under investigation were 20–300°C, 10 5 -4 × 10 7 Pa and 5 × 10 −4 -10 3 Hz. Certain limitations exist on the simultaneous use of the highest values of temperature and pressure. The main features of the instrument are: analog electrical outputs recorded by an x-y recorder or observed on a scope with…
Permanent photodoping of plasmonic gallium-ZnO nanocrystals
2020
This work was supported by the Latvian Council of Science in the framework of FLPP (Plasmonic oxide quantum dots for energy saving smart windows, lzp-2018/1-0187). Tanel Käämbre acknowledges financial support for the XPS instrumentation maintenance from the Estonian Centre of Excellence in Research project “Advanced materials and high- technology devices for sustainable energetics, sensorics and nanoelectronics” (TK141).
Laser direct writing of gold conductors from metallorganic inks
1993
Laser deposition of gold lines from spin-on metallorganic (MO) precursors has been studied. A readily available and relatively low-cost commercial MO ink has been used to write gold interconnects on different substrates. The physical properties of the ink, its laser-firing process on oxidised silicon substrates and its electrical characterisation are presented here, together with the experimental procedure needed for obtaining low-resistivity deposits.
Structural and electrical properties in tungsten/tungsten oxide multilayers
2014
International audience; Tungsten and tungsten oxide periodic nanometric multilayers have been deposited by DC reactive sputtering using the reactive gas pulsing process. Different pulsing periods have been used for each deposition to produce metal-oxide periodic alternations ranging from 3.3 to 71.5 nm. The morphology, crystallinity and chemical composition of these films have been investigated by transmission electron microscopy and energy-dispersive X-ray spectroscopy techniques. The produced multilayers exhibited an amorphous structure and the composition stability of WO3 sub-layers has been pointed out. Moreover, electrical properties have also been studied by the van der Pauw technique…
Kinetic Ionic Permeation and Interfacial Doping of Supported Graphene
2019
Due to its outstanding electrical properties and chemical stability, graphene finds widespread use in various electrochemical applications. Although the presence of electrolytes strongly affects its electrical conductivity, the underlying mechanism has remained elusive. Here, we employ terahertz spectroscopy as a contact-free means to investigate the impact of ubiquitous cations (Li+, Na+, K+, and Ca2+) in aqueous solution on the electronic properties of SiO2-supported graphene. We find that, without applying any external potential, cations can shift the Fermi energy of initially hole-doped graphene by ∼200 meV up to the Dirac point, thus counteracting the initial substrate-induced hole dop…