Search results for "Energy conversion"
showing 10 items of 134 documents
Lead acetate precursor based p-i-n perovskite solar cells with enhanced reproducibility and low hysteresis
2015
A low temperature approach for the fabrication of p-i-n perovskite solar cells is presented. Using lead acetate-based precursors, flat and homogeneous CH3NH3PbI3 films, compatible with the use of thin organic charge transport layers, can be obtained. The corresponding solar cells showed power conversion efficiency up to 12.5%, with remarkable reproducibility and very low hysteresis.
Broadband stimulated Raman backscattering
2016
International audience; Broadband amplification employing stimulated Raman backscattering is demonstrated. Using seed pulses with a bandwidth of about 200 nm, we study the amplification in a wide spectral range in a single laser shot. With chirped pump pulses and a Ne gas jet, we observed under optimized conditions, amplification in a range of about 80 nm, which is sufficient to support the amplification of sub-20 fs pulses. This broad amplification range is also in excellent agreement with PIC simulations. The conversion efficiency is at certain wavelengths as high as 1.2% and was measured to be better than 6×10 −3 on average.
An optimum design of the magnetic circuit of a PM linear electrical generator for the exploitation of sea waves.
2006
In this paper an approach to the optimization of the magnetic design of a Permanent Magnet (PM) linear generator for the exploitation of the energy contained in sea waves is presented. This approach consists of a two step procedure: the first one takes into account the stochastic features of the sea wave motion and describe the working condition of the machine under this motion by adopting a lumped parameter model. In this step the objective function is the energy production. The second step optimizes the generator by using the results obtained in the first step as the constraints that must be fulfilled by a design based on a Finite Element Method (FEM) analysis. Furthermore, the approach i…
Nanostructured Materials Obtained by Electrochemical Methods: From Fabrication to Application in Sensing, Energy Conversion, and Storage
2020
It is well known that physical and surface properties of nanomaterials are promising to enhance efficiency of nanostructured devices for sensing and for sustainable energy production, conversion, and storage. However, the practical use of nanomaterials is often complicated by the lack of scalable and cost-efficient synthesis procedures and the challenge of integrating into devices 1D nanomaterials saving their structural features. In this field, one of the most severe challenges is to find suitable methods for fabricating nanomaterials. Over the years, numerous preparation methods were proposed in the literature, but not all of them are easily scalable and economically advantageous for indu…
Adaptive Feed-Forward Neural Network for Wind Power Delivery
2022
This paper describes a grid connected wind energy conversion system. The interconnecting filter is a simple inductor with a series resistor to minimize three-phase current Total Harmonic Distortion (THD). Using the Recursive Least Squares (RLS) Estimator, an online grid impedance technique is proposed in the stationary reference frame using the Recursive Least Squares (RLS) Estimator. An Adaptive Feedforward Neural (AFN) Controller has also been developed using the inverse of the system to improve the performance of the current Proportional-Integral controller under dynamical conditions and provide better DC link voltage stability. The neural network weights are computed in real-time using …
Low-cost high-haze films based on ZnO nanorods for light scattering in thin c-Si solar cells
2015
Light scattering from ZnO nanorods (NR) is investigated, modeled, and applied to a solar cell. ZnO NR (120-1300 nm long, 280-60 nm large), grown by low-cost chemical bath deposition at 90 degrees C, exhibit diffused-to-total transmitted light as high as 70% and 30% in the 400 and 1000 nm wavelength range, respectively. Data and scattering simulation show that ZnO NR length plays a crucial role in light diffusion effect. A transparent ZnO NR film grown on glass and placed on top of a 1 mu m thick c-Si solar cell is shown to enhance the light-current conversion efficiency for wavelengths longer than 600 nm. (C) 2015 AIP Publishing LLC.
Improving Perovskite Solar Cells: Insights From a Validated Device Model
2017
To improve the efficiency of existing perovskite solar cells (PSCs), a detailed understanding of the underlying device physics during their operation is essential. Here, a device model has been developed and validated that describes the operation of PSCs and quantitatively explains the role of contacts, the electron and hole transport layers, charge generation, drift and diffusion of charge carriers and recombination. The simulation to the experimental data of vacuum-deposited CH3NH3PbI3 solar cells over multiple thicknesses has been fit and the device behavior under different operating conditions has been studied to delineate the influence of the external bias, charge-carrier mobilities, e…
A methodology for optimisation of solar dish-Stirling systems size, based on the local frequency distribution of direct normal irradiance
2021
Abstract In geographical areas where direct solar irradiation levels are relatively high, concentrated solar energy systems are one of the most promising green energy technologies. Dish-Stirling systems are those that achieve the highest levels of solar-to-electric conversion efficiency, and yet they are still among the least common commercially available technologies. This paper focuses on a strategy aimed at promoting greater diffusion of dish-Stirling systems, which involves optimizing the size of the collector aperture area based on the hourly frequency distributions of beam irradiance and defining a new incentive scheme with a feed-in tariff that is variable with the installed costs of…
Efficient energy conversion for cubic third-harmonic generation that is phase matched in KTiOPO(4).
2000
We demonstrate, for the first time to our knowledge, that efficient third-harmonic generation can be achieved with a cubic contribution much larger than the quadratic processes. An energy-conversion efficiency of 2.4% is achieved for cubic third-harmonic generation that is phase matched along the x axis of a KTiOPO(4) crystal by use of a picosecond fundamental laser emitting at 1618 nm. The associated cascading processes are only 10% of the pure cubic interaction, which is very suitable for study of the specific quantum optical correlations. Calculations of the third-harmonic generation conversion efficiency with respect to group-velocity dispersion and to the longitudinal Gaussian beam pro…
Second-harmonic generation in surface periodically poled lithium niobate waveguides:On the role of multiphoton absorption
2008
Second harmonic generation is investigated in lithium niobate channels realized by proton exchange and quasi-phase-matched by surface periodic-poling. The reduction in conversion efficiency at high powers is interpreted in terms of multi-photon absorption via two-color terms, yielding an estimate of the dominating three-photon process.