Search results for "Fluid dynamics"

Transient birefringence of polymer melts in intermittent shear flow: Model analysis of the non-linear viscoelastic behaviour

1977

A non-linear viscoelastic model has been used to interpret transient flow birefringence in changing shear flow for a polymer melt. It is shown how the new model is consistent with the basic hypothesis of the linear stress-optical law. Stress growth in shear flow and relaxation after different amounts of shearing are compared with the predictions of the non-linear model. A good agreement between experimental data and theoretical predictions is found.

Viscometric behaviour of polymer blends based on poly (vinylidene fluoride)

1994

The viscosity behaviour of dilute dimethylformamide solutions of poly(vinylidene fluoride)-poly (methyl methacrylate) and poly(vinylidene fluoride)-polystyrene has been studied at 25°C. The polymer concentration ranges are such that neither phase separation nor microgel formation occurs, although we are very close to theta conditions. The intrinsic viscosity and viscosity interaction parameter of the ternary mixtures have been calculated. The estimation of the compatibility of the above polymer pairs has been studied based on: a) specific viscosities; b) viscosity interaction parameters, according to Krigbaum and Wall formalism, and c) viscosity interaction parameters of a system formed by …

Nonisothermal elongational behavior of blends with liquid crystalline polymers

1994

Measurements of melt strength and breaking stretching ratio of several blends of thermoplastic polymers with liquid crystalline polymers are presented. The melt strength behavior depends not only on the viscosity of the blends but also on the temperature dependence of the viscosity. In particular, even if the viscosities of the blends are, at the extrusion temperature, lower than that of the thermoplastic matrices, the melt strength can be larger than that of the pure thermoplastics if its viscosity-temperature curve exceeds that of the matrices far from the solidification temperature. This behavior allows one to spin or film blow these blends despite the low viscosity.

Shear flow characterization of blends containing liquid crystal polymers

1992

A simple phenomenological approach is proposed in order to predict the presence of minima in the viscosity-composition curves of blends of thermoplastic with liquid crystal polymer (LCP). When the viscosity of the liquid crystal polymer is larger than that of the thermoplastic matrix, a minimum is observed. A possible explanation of the presence of yield stress in the flow curves of these blends is also given.

Optimized Continuous Application of Hyperpolarized Xenon to Liquids

2018

International audience; In recent years, NMR with hyperpolarized (HP) xenon inside functionalized host structures (e.g. cryptophanes) have become a potential candidate for the direct observation of metabolic processes (i.e. molecular imaging). A critical issue for real applications is the dissolution of the HP-gas in the liquid which contains the host. In this work, we present recent developments for an improved and controlled dissolution of HP-Xe in liquids using hollow fiber membranes and different compressor systems. The designed apparatus consists of a compressor and a membrane unit. The compressor provides HP-129 Xe continuously at small adjustable pressures and in a polarization-prese…

The Origin of Non-thermal Fluctuations in Multiphase Flow in Porous Media

2021

Core flooding experiments to determine multiphase flow in properties of rock such as relative permeability can show significant fluctuations in terms of pressure, saturation, and electrical conductivity. That is typically not considered in the Darcy scale interpretation but treated as noise. However, in recent years, flow regimes that exhibit spatio-temporal variations in pore scale occupancy related to fluid phase pressure changes have been identified. They are associated with topological changes in the fluid configurations caused by pore-scale instabilities such as snap-off. The common understanding of Darcy-scale flow regimes is that pore-scale phenomena and their signature should have a…

Vaporization Characteristics of Ethanol Droplets: Influence of the Environment Humidity

2011

The study of the gasification of a droplet via vaporization, which involves heat, mass and momentum transfer processes in gas and liquid phases, and their coupling at the droplet interface, is necessary for better understanding and modeling of complex spray and mixture formation issues. A detailed description of the vaporization of an isolated droplet has been realized in this experimental study aimed at investigating the impact of the water vapor contained in the surrounding gas on the evaporation of an ethanol droplet. The experimental set-up consists of a heated chamber with a cross quartz fibers configuration as droplet support. An ethanol droplet is located at the intersection of the c…

The importance of fracture-healing on the deformation of fluid-filled layered systems

2014

International audience; Understanding the fracturingehealingerefracturing cycle is a fundamental part of studying the deformation dynamics and the permeability evolution of rock systems. Previous studies, however, have not examined the influence of healing i.e. fracture-closure through vein formation and the mechanical properties of the " healed " fractures (veins) on the rock deformation. We present results from a two-dimensional coupled hydro-mechanical model which simulates large time and spatial scale dynamic fracturing and healing of a porous medium under the influence of gravity, tectonic stretching and elevated fluid pressures. Our results show that healing decreases the local porosi…

Influence of bed roughness on flow and turbulence structure around a partially-buried, isolated freshwater mussel

2023

The present study uses eddy-resolving numerical simulations to investigate how bed roughness affects flow and turbulence structure around an isolated, partially-buried mussel (Unio elongatulus) aligned with the incoming flow. The rough-bed simulations resolve the flow past the exposed part of a gravel bed, whose surface is obtained from a laboratory experiment that also provides some additional data for validation of the numerical model. Results are also discussed for the limiting case of a horizontal smooth bed. Additionally, the effects of varying the level of burial of the mussel inside the substrate and the discharge through the two mussel siphons are investigated via a set of simulatio…

2016

Recent gas flux measurements have shown that Strombolian explosions are often followed by periods of elevated flux, or “gas codas,” with durations of order a minute. Here we present UV camera data from 200 events recorded at Stromboli volcano to constrain the nature of these codas for the first time, providing estimates for combined explosion plus coda SO2 masses of ≈18–225 kg. Numerical simulations of gas slug ascent show that substantial proportions of the initial gas mass can be distributed into a train of “daughter bubbles” released from the base of the slug, which we suggest, generate the codas, on bursting at the surface. This process could also cause transitioning of slugs into cap b…