Search results for "Gravimetry"
showing 10 items of 178 documents
Adsorption of m-Xylene on Prehydrated Zeolite BaX: Correlation between Temperature-Programmed Desorption and Low-Temperature Neutron Powder Diffract…
1999
Adsorption of m-xylene on partially hydrated zeolite BaX is studied by thermogravimetry, mass spectrometry, temperature-programmed desorption and neutron diffraction for different m-xylene loadings of the zeolite. Macroscopic and microscopic measurements, for both molecules, were correlated and relationships were found between the crystallographic positions of the adsorbed molecules on the zeolite and macroscopic properties such as the number and the area of the peaks in the desorption spectra for m-xylene or water. The influence of water molecules on the adsorption phenomenon of m-xylene on BaX zeolite was characterized. In particular, it was shown that the increase of the filling of the p…
Pyrolysis study of sol-gel derived TiO2powders
2004
An amorphous TiO2 gel was obtained by hydrolysing titanium(IV) isopropoxide with a stoichiometric amount of water using SnCl2 as catalyst. In these operative conditions, a TiO2 gel matrix containing a lower fraction of organic residual was obtained with respect to samples prepared by previously modifying the titanium alkoxide precursor with chelating ligands. Dried gel powders were characterized by N2 adsorption analyses, FT-IR and XRD measurements. Thermogravimetric (TG) and differential thermal analysis (DTA) coupled with mass spectrometric (MS) and gas chromatographic (GC) measurements were performed in order to identify the organic products released from TiO2 gel pyrolysis. The Tg-MS se…
Tungstophosphoric acid supported on polycrystalline TiO2 for the photodegradation of 4-nitrophenol in aqueous solution and propan-2-ol in vapour phase
2009
Abstract The present work reports the preparation of samples based on Millennium PC-500 TiO 2 loaded with different amounts of tungstophosphoric acid (up to 30% in weight) and their characterisation by means of different physicochemical techniques: powder X-ray diffraction, N 2 adsorption–desorption at −196 °C, transmission electron microscopy, UV–vis and FT-IR spectroscopies and thermogravimetric analyses. The acidity of samples was evaluated by FT-IR using pyridine as probe molecule, and the catalysts activity was tested for the photodegradation of 4-nitrophenol in aqueous solution and for the photo-oxidation of propan-2-ol in vapour phase. The results show a noticeable improvement (8 and…
Synthesis and thermal behavior of Janus dendrimers, part 1
2010
Abstract Eight Janus-type dendrimers up to the second generation were synthesized, and their thermal properties were evaluated. Compounds consist of the dendritic bisMPA based polyester moieties, and either 3,4-dihexyloxybenzoic acid or 3,4-dihexadecyloxybenzoic acid moieties, attached to opposite sides of the pentaerythritol core. The structures of the molecules were verified with 1 H NMR, 13 C NMR, ESI TOF mass spectrometry and elemental analysis. The thermal stability was evaluated by thermogravimetric analysis, displaying onset decomposition temperatures ( T d ) ranging from 241 to 308 °C. Phase transitions were studied by differential scanning calorimetry. Based on the performed studie…
Development and characterization of co-loaded curcumin/triazole-halloysite systems and evaluation of their potential anticancer activity.
2014
Abstract Positively charged halloysite nanotubes functionalized with triazolium salts (f-HNT) were employed as a carrier for curcumin molecules delivery. The synthesis of these f-HNT new materials is described. Their interaction with curcumin was evaluated by means dynamic light scattering (DLS) and UV–vis spectroscopy in comparison with pristine unmodified HNT (p-HNT). The curcumin load into HNT was estimated by thermogravimetric analysis (TGA) measurements, while the morphology was investigated by scanning electron microscopy (SEM) techniques. Release of curcumin from f-HNT, at three different pH values, by means of UV–vis spectroscopy was also studied. Furthermore, different cancer cell …
Thermal analysis applied to the characterization of degradation in soil of polylactide: II. On the thermal stability and thermal decompositon kinetics
2010
[EN] The disposal stage of polylactide (PLA) was assessed by burying it in active soil following an international standard. Degradation in soil promotes physical and chemical changes in the polylactide properties. The characterization of the extent of degradation underwent by PLA was carried out by using Thermal Analysis techniques. In this paper, studies on the thermal stability and the thermal decomposition kinetics were performed in order to assess the degradation process of a commercial PLA submitted to an accelerated soil burial test by means of multi-linear-non-isothermal thermogravimetric analyses. Results have been correlated to changes in molecular weight, showing the same evolutio…
Thermogravimetric analysis. A tool to evaluate the ability of mixtures in consolidating waterlogged archaeological woods
2010
Waterlogged archaeological woods (Pinus pinaster, Ulmus cf. minor and Fagus sylvatica L.) were consolidated by using Colophony, Rosin 100, and a mixture of Poly(ethylene) glycol (PEG) 3000 and Poly(propylene) glycol (PPG) 425. The efficiency of the consolidants was estimated by determining the content entrapped into the cavity of degraded wood. For this purpose, thermogravimetry was demonstrated to be a reliable tool. In the case that the polymeric mixture was used for impregnation, it was also possible to discriminate the amount of PEG 3000 from that of PPG 425 captured by the wood capillaries. Regardless of the wood nature, all the consolidants were present in treated samples in large amo…
Adsorption isotherms and thermal behavior of hybrids based on quercetin and inorganic fillers
2019
We investigated the adsorption process of quercetin onto several inorganic fillers, such as kaolinite, calcium carbonate and alumina. Firstly, we performed equilibrium adsorption studies in order to determine the quercetin/filler adsorption isotherms, which were successfully fitted through the Langmuir model. Based on the adsorption data analysis, we estimated the maximum adsorption capacity of each filler as well as the Langmuir constant, which is related to the affinity between quercetin and the surfaces of the inorganic particles. Then, we prepared hybrids formed by fillers saturated with quercetin. The obtained composites were characterized by thermogravimetric analysis with the aim of …
Microwave assisted synthesis and solid-state characterization of lithocholyl amides of isomeric aminopyridines
2011
Microwave (MW) assisted synthesis and solid state structural characterizations of novel lithocholyl amides of 2-, 3-, and 4-aminopyridine are reported. It is shown that the MW technique is a proper method in the preparation of N-lithocholyl amides of isomeric aminopyridines. It offers many advantages compared to conventional heating. The molecular and crystal structures as well as the polymorphic and hydrated forms of prepared conjugates with their thermodynamic stabilities have been characterized by means of high resolution liquid- and solid-state NMR spectroscopy, single crystal and powder X-ray diffraction, and thermogravimetric analysis. Owing to the many biological functions of bile ac…
Nanocomposites of bacterial cellulose/hydroxyapatite for biomedical applications.
2008
In the present work, a nanocomposite material formed by bacterial cellulose (BC) networks and calcium-deficient hydroxyapatite (HAp) powders was synthesized and characterized. The HAp nanoparticles were previously prepared by a wet chemical precipitation method, starting from aqueous solutions of calcium nitrate and di-ammonium phosphate salts. Energy-dispersive spectroscopy reveals that the prepared HAp corresponds to calcium-deficient hydroxyapatite. BC-HAp nanocomposites were prepared by introducing carboxymethylcellulose (CMC) into the bacteria culture media. HAp nanoparticles were then introduced and remained suspended in the culture medium during the formation of cellulose nanofibrils…