Search results for "Hardware_PERFORMANCEANDRELIABILITY"
showing 10 items of 91 documents
A Novel Fault-Tolerant Routing Algorithm for Mesh-of-Tree Based Network-on-Chips
2019
Use of bus architecture based communication with increasing processing elements in System-on-Chip (SoC) leads to severe degradation of performance and speed of the system. This bottleneck is overcome with the introduction of Network-on-Chips (NoCs). NoCs assist in communication between cores on a single chip using router based packet switching technique. Due to miniaturization, NoCs like every Integrated circuit is prone to different kinds of faults which can be transient, intermittent or permanent. A fault in any one component of such a crucial network can degrade performance leaving other components non-usable. This paper presents a novel Fault-Tolerant routing Algorithm for Mesh-of-Tree …
Silicon dosimeters based on Floating Gate Sensor: design, implementation and characterization
2020
A rad-hard monolithic dosimeter has been implemented and characterized in a standard 180 nm CMOS technology. The radiation sensor (C-sensor) is based on a Floating Gate (FG) MOS discharge principle. The output current is processed by a current-to-voltage (I/V) interface and then converted by a 5-bit flash ADC. The dosimeter is re-usable (FG can be recharged) and can detect a dose up to 1krad (Si) with a resolution of 30rad (Si) typical over temperature 0 to 85°C range. The ADC allows easy further signal processing for calibration and averaging, etc. The power consumption of C-sensor plus I/V interface is < 2mW from a 5 V power supply. The overall layout area is less than 0.25mm2. The Rad…
Low-Power, Subthreshold Reference Circuits for the Space Environment : Evaluated with -rays, X-rays, Protons and Heavy Ions
2019
The radiation tolerance of subthreshold reference circuits for space microelectronics is presented. The assessment is supported by measured results of total ionization dose and single event transient radiation-induced effects under &gamma
Fault-Tolerant Network-on-Chip Design for Mesh-of-Tree Topology Using Particle Swarm Optimization
2018
As the size of the chip is scaling down the density of Intellectual Property (IP) cores integrated on a chip has been increased rapidly. The communication between these IP cores on a chip is highly challenging. To overcome this issue, Network-on-Chip (NoC) has been proposed to provide an efficient and a scalable communication architecture. In the deep sub-micron level NoCs are prone to faults which can occur in any component of NoC. To build a reliable and robust systems, it is necessary to apply efficient fault-tolerant techniques. In this paper, we present a flexible spare core placement in Mesh-of-Tree (MoT) topology using Particle Swarm Optimization (PSO) by considering IP core failures…
Torus Topology based Fault-Tolerant Network-on-Chip Design with Flexible Spare Core Placement
2018
The increase in the density of the IP cores being fabricated on a chip poses on-chip communication challenges and heat dissipation. To overcome these issues, Network-onChip (NoC) based communication architecture is introduced. In the nanoscale era NoCs are prone to faults which results in performance degradation and un-reliability. Hence efficient fault-tolerant methods are required to make the system reliable in contrast to diverse component failures. This paper presents a flexible spare core placement in torus topology based faulttolerant NoC design. The communications related to the failed core is taken care by selecting the best position for a spare core in the torus network. By conside…
Multiple Fault Diagnosis of Electric Powertrains Under Variable Speeds Using Convolutional Neural Networks
2018
Electric powertrains are widely used in automotive and renewable energy industries. Reliable diagnosis for defects in the critical components such as bearings, gears and stator windings, is important to prevent failures and enhance the system reliability and power availability. Most of existing fault diagnosis methods are based on specific characteristic frequencies to single faults at constant speed operations. Once multiple faults occur in the system, such a method may not detect the faults effectively and may give false alarms. Furthermore, variable speed operations render a challenge of analysing nonstationary signals. In this work, a deep learning-based fault diagnosis method is propos…
Application prospects of silica core side-glowing optical fibers
2005
The side-emitting optical fibers are specially designed to stimulate leakage of the core-transmitted radiation via their side surfaces, so creating the effect of glowing tiny wires. The basic design concepts for this kind of optical fibers are discussed, as well as some of the present and potential future applications.
Applying Dynamic Performance Management to Enterprises
2016
This chapter will illustrate two examples of DPM applied to enterprises. Cases will show how DPM can support a learning-oriented approach into the P&C processes of business organizations.
Comparison among different rainfall energy harvesting structures
2018
In this paper, an experimental comparison between different rainfall harvesting devices through the study of the electrical rectifying circuit is proposed. In more detail, three harvesting structures are considered: the cantilever, the bridge and the floating circle. Different waveforms were acquired and discussed. The processed data were compared in order to suggest the best choice for the rectifying circuit, from the simplest one to that most frequently endorsed in the technical literature.
Solution Processed Micro- and Nano-Bioarrays for Multiplexed Biosensing
2012
This Feature article reports on solution dispensing methodologies which enable the realization of multiplexed arrays at the micro- and nanoscale for relevant biosensing applications such as drug screening or cellular chips.