Search results for "Inert"
showing 10 items of 333 documents
Closed tank pneumatic press application to improve Sauvignon Blanc wine quality and nutraceutical properties
2019
The machines used in the winemaking process directly affect the quality of wine and its nutraceutical properties. Grapes-pressing is a very important step in winemaking as it may promote the presence and/or absence of enzymatic processes on the must, leading to the creation of different products in terms of chemical composition, starting from the same grapes. The aim of the study was to compare two different pressing systems of Sauvignon Blanc grapes using an innovative pneumatic discontinuous closed tank press in two operating modes: the traditional pressing mode in presence of oxygen and the inert pressing mode, performed through grapes pressing under inert gas with nitrogen recovery. Che…
Previsione delle prestazioni del veicolo su strada: stato dell’arte
2016
Questo lavoro contiene una rassegna dei metodi che sono usati per la previsione delle prestazioni del veicolo su strada, in dipendenza del motore installato. La prima parte mostra il calcolo delle resistenze al moto, cioè le forze che il veicolo deve vincere per avanzare sulle strade piane e in salita. Particolarmente interessante appare la parte che riguarda la resistenza aerodinamica, della quale si tratta di metodi sperimentali (galleria del vento), metodi empirici e metodi CFD. Si propone inoltre l’applicazione della norma CUNA sulla velocità per la determinazione dei consumi anche al calcolo dei coefficienti aerodinamici. La rassegna esclude la resistenza accidentale in curva perché no…
Assessing the performance of different model-based techniques to estimate water content in the upper soil layer
2016
he knowledge of soil water content (SWC) of the upper soil layer is important for most hydrological processes occurring over vegetated areas and under dry climate. Because direct field measurements of SWC are difficult, the use of different type of sensors and model-based approaches have been proposed and extensively used during the last decade. The main objective of this work is to assess the performance of two models estimating SWC of the upper soil layer: the transient line heat source method and the physically based Hydrus-1D model. The models' performance is assessed using field measurements acquired through a Time Domain Reflectometer (TDR). The experiment was carried out on an olive …
miMic
2016
miMic, a sonic analogue of paper and pencil is proposed: An augmented microphone for vocal and gestural sonic sketching. Vocalizations are classified and interpreted as instances of sound models, which the user can play with by vocal and gestural control. The physical device is based on a modified microphone, with embedded inertial sensors and buttons. Sound models can be selected by vocal imitations that are automatically classified, and each model is mapped to vocal and gestural features for real-time control. With miMic, the sound designer can explore a vast sonic space and quickly produce expressive sonic sketches, which may be turned into sound prototypes by further adjustment of model…
Mapping soil water content under sparse vegetation and changeable sky conditions: comparison of two thermal inertia approaches
2013
A critical analysis of a thermal inertia approach to map surface soil water content on bare and sparsely vegetated soils by means of remotely sensed data is reported. The study area is an experimental field located in Barrax, Spain. In situ data were acquired within the Barrax 2011 research project. An advanced hyperspectral scanner airborne imager provides images in the visible/near-infrared and thermal infrared bands. Images were acquired both in day and night times by the Instituto Nacional de Técnica Aeroespacial between 12th and 13th of June 2011. The scene covers a corn irrigation pivot surrounded by bare soil, where a set of in situ data have been collected both previously and simult…
Thermal and thermo-oxidative stability and kinetics of decomposition of PHBV/sisal composites
2017
The decomposition behaviours of composites made of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) and sisal were assessed in terms of thermal stability and decomposition kinetics, under inert and oxidative conditions, by means of multi-rate linear non-isothermal thermogravimetric experiments. A statistical design of experiments was applied to study the influence of the addition of sisal (0-10-20-30%wt), the presence coupling agent (Yes/No) and the applied conditions of work (inert or oxidative). An improvement of the thermal and thermo-oxidative stability of PHBV with the addition of sisal was observed for all cases. An accurate methodology based on iso-conversional methods was applied…
Engine/Transmission Matching
2014
This chapter deals with the forecasting of vehicle performance on the road, according to the installed engine. It begins with Section 1, which shows the calculation of the resistance to motion, that is, the forces that the vehicle must overcome to advance on flat roads and uphill. The calculation excludes accidental resistance in curves because it is not essential for predicting the behavior of the vehicle on the road. Section 2 begins with the power characteristic, the forecast by traction–speed and power–speed diagrams, calculation of gear ratios, and then passing to the limits to the estimated acceleration, feature consumption, and distance. This chapter concludes with a section on the d…
Nanofilm Low Cost Oxygen Sensors
2009
Abstract The resitivity change of ultra thin metals under air exposure is used for vacuum or inert gas packaging control. In order to reach low cost, single use applications, few nm thin Aluminum layers were deposited on PET substrates and combined with wireless electronic readout circuitry. The sensor respose is characterized by resistance changes and explained in terms of multiphase diffusion mechanisms which are very sensitive to technological parameters.
Vegetation Patterns in the Hyperbolic Klausmeier Model with Secondary Seed Dispersal
2023
This work focuses on the dynamics of vegetation stripes in sloped semi-arid environments in the presence of secondary seed dispersal and inertial effects. To this aim, a hyperbolic generalization of the Klausmeier model that encloses the advective downhill transport of plant biomass is taken into account. Analytical investigations were performed to deduce the wave and Turing instability loci at which oscillatory and stationary vegetation patterns arise, respectively. Additional information on the possibility of predicting a null-migrating behavior was extracted with suitable approximations of the dispersion relation. Numerical simulations were also carried out to corroborate theoretical pre…
Sensitivity Analysis and Frequency Dynamics of Grid-Connected Converters with Virtual Inertia
2021
For the participation in the frequency control of the system, power converters can be controlled with different strategies and methods, sharing the common concept of virtual inertia capability. In this work, a sensitivity analysis of two main categories of converter controls with virtual inertia is presented. The considered schemes are a grid-following current vector control with additional virtual inertia block and a grid-forming control scheme based on virtual synchronous machine concept. A proper basis for the comparison is first assessed providing an analytical correlation between the control parameters of the two schemes. For the two control strategies, the sensitivity analysis of the …