Search results for "Infrared"
showing 10 items of 2110 documents
FTIR matrix isolation and theoretical studies of glycolic acid dimers
2018
Glycolic acid (GA) dimers were studied in low temperature argon matrices by means of FTIR spectroscopy. Experimentally, the dimers were produced when monomeric glycolic acid molecules were thermally mobilized upon annealing of argon matrices at 25–35 K. The experimental spectra observed upon annealing indicate the presence of three different dimer structures. Computationally, MP2 and DFT calculations were used to study the potential dimer species in order to scrutinize the possible dimer structures, their energetics and their spectral features. Altogether 27 local minima were found for dimer structures for the three lowest conformers of glycolic acid considered based on previous studies on …
Employing Microwave Graphene Field Effect Transistors for Infrared Radiation Detection
2018
In this work, we investigate the possibility of employing graphene field effect transistors, specifically designed for microwave applications, as infrared detectors for telecom applications. Our devices have been fabricated on a sapphire substrate employing CVD-grown transferred graphene. The roles of both the gate dielectric and the DC bias conditions have been evaluated in order to maximize the infrared generated signal through an experimental investigation of the signal-to-noise ratio dependence on the transistor operating point.
Comparison of a near-infrared reflectance spectroscopy system and skin conductance measurements for in vivo estimation of skin hydration: a clinical …
2017
Diffuse reflectance spectroscopy system was developed for estimation of skin hydration in the near-infrared spectral range of 900-1700 nm. Experimental setup consisted of a near-infrared spectrometer, Y-type fiber optics probe with 1 detection and 6 illumination fibers, halogen-tungsten light source and a PC. By analyzing diffuse reflectance spectrum, a parameter representing skin hydration by performing baseline correction and calculating the area under the 1450 nm water absorption maximum is proposed. A clinical study was performed acquiring data of skin hydration of 39 patients' forearm skin. Results of the developed system are compared to results obtained by a commercial device based on…
Motor Cortex Function in Fibromyalgia: A Study by Functional Near-Infrared Spectroscopy
2019
Previous studies indicated changes of motor cortex excitability in fibromyalgia (FM) patients and the positive results of transcranial stimulation techniques. The present study aimed to explore the metabolism of motor cortex in FM patients, in resting state and during slow and fast finger tapping, using functional Near-Infrared Spectroscopy (fNIRS), an optical method which detects in real time the metabolism changes in the cortical tissue. We studied 24 FM patients and 24 healthy subjects. We found a significant slowness of motor speed in FM patients compared to controls. During resting state and slow movement conditions, the metabolism of the motor areas was similar between groups. The oxy…
Structural characterization and optical constants of p-toluene sulfonic acid doped polyaniline and its composites of chitosan and reduced graphene-ox…
2020
Para-Toluene sulfonic acid doped polyaniline (PANI), PANI/chitosan composites, PANI/reduced graphene-oxide composites and a ternary composite comprising of PANI, chitosan and reduced graphene-oxide have synthesised via oxidative polymerisation of aniline by Ammonium peroxydisulfate (APS). FTIR, XRD, FESEM and UV-VIS techniques were performed for the confirmation of the successful synthesis. The fundamental optical parameters such as, complex refractive index, complex dielectric constants and optical conductivity of the PANI and the composites were investigated in the UV-VIS-NIR range. The results show a clear dependence on the constituent component such as sulphur as well as the absorbance …
Flash infrared annealing as a cost-effective and low environmental impact processing method for planar perovskite solar cells
2019
Abstract For successful commercialization of perovskite solar cells, straightforward solutions in terms of environmental impact and economic feasibility are still required. Flash Infrared Annealing (FIRA) is a rapid method to fabricate perovskite solar cells with efficiencies >18% on simple, planar architecture, which allows a film synthesis in only 1.2 s, faster than the previous report based in a meso architecture and all of them without the usage of antisolvent. In this work, through a comparative study with the common lab-scale method, the so-called antisolvent (AS), the main photovoltaic parameters and working mechanisms obtained from impedance spectroscopy (IS) measurements show simil…
Global analysis of the high resolution infrared spectrum of methane 12CH4 in the region from 0 to 4800 cm-1
2009
International audience; We report the global analysis of methane (12CH4) lines from high resolution rovibrational spectra including accurate line positions and intensities in the region 0–4800 cm−1. This covers four polyads: The Ground State Monad (rotational levels), the Dyad (940–1850 cm−1, 2 vibrational levels, 2 sublevels), the Pentad (2150–3350 cm−1, 5 vibrational levels, 9 sublevels) and the Octad (3550–4800 cm−1, 8 vibrational levels, 24 sublevels) and some of the associated hot bands (Pentad−Dyad and Octad−Dyad). New Fourier transform infrared (FTIR) spectra of the Pentad and Octad regions have been recorded with a very high resolution (better than 0.001 cm−1 instrumental bandwidth,…
Preliminary analysis of CH3D from 3250 to 3700 cm(-1)
2006
International audience; The infrared spectrum of CH3D from 3250 to 3700 cm(-1) was studied for the first time to assign transitions involving the nu(2) + nu(3), nu(2) + nu(5), nu(2) + nu(6), nu(3) + 2(nu 6) and 3 nu(6) vibrational states. Line positions and intensities were measured at 0.011 cm(-1) resolution using Fourier transform spectra recorded at Kitt Peak with isotopically enriched samples. Some 2852 line positions (involving over 900 upper state levels) and 874 line intensities were reproduced with RMS values of 0.0009 cm(-1) and 4.6%, respectively. The strongest bands were found to be nu(2) + nu(3) at 3499.7 cm(-1) and nu(2) + nu(6) at 3342.5 cm(-1) with integrated strengths, respe…
Artificial cartilage bio-matrix formed of hyaluronic acid and Mg2+-polyphosphate.
2016
Here we show that inorganic polyphosphate (polyP), a polyanionic metabolic regulator consisting of multiple phosphate residues linked by energy-rich phosphoanhydride bonds, is present in the synovial fluid. In a biomimetic approach, to enhance cartilage synthesis and regeneration, we prepared amorphous polyP microparticles with Mg2+ as counterions. The particles were characterised by X-ray diffraction (XRD), energy-dispersive X-ray (EDX) and Fourier transformed infrared spectroscopic (FTIR) analyses. Similar particles were obtained after addition of Mg2+ ions to a solution containing hyaluronic acid, as a major component of the synovial fluid, and soluble Na-polyP. The viscous paste-like ma…
Challenges in the use of Near Infrared Spectroscopy for improving wood quality: A review
2018
Aims of study: Forestry-related companies require quality monitoring methods capable to pass a large number of samples. This review paper is dealing with the utilization of near infrared (NIR) technique for wood analysis.Area of study: We have a global point of view for NIR applications and characterization of different kind of wood species is considered.Material and methods: NIR spectroscopy is a fast, non-destructive technique, applicable to any biological material, demanding little or no sample preparation. NIR spectroscopy and multivariate analysis serve well in laboratories where the conditions are controlled. The main challenges to NIR spectroscopy technique in field conditions are mo…