Search results for "Iode"
showing 10 items of 1284 documents
Intra-center and recombination luminescence of bismuth defects in fused and unfused amorphous silica fabricated by SPCVD
2013
Abstract Photoluminescence (PL) of bismuth doped silicon dioxide excited by UV excimer lasers (ArF — 193 nm, KrF — 248 nm) and a green light laser diode (532 nm) is studied in a wide spectral band at temperatures ranging from 12 to 750 K. Two types of samples are investigated: unfused, 100 μm in thickness amorphous layer immediately deposited on the inner surface of silica substrate tube, and the same material after profusion resulted from tube collapsing to a rod by external heating. PL bands centered at 620–650 nm, 820 nm and 1400 nm wavelengths are observed in both fused and unfused samples. Under excitation by the green laser diode decay time constants for 650 nm (orange) and 1400 nm (N…
Light-emitting diodes based on phenylenevinylene oligomers with defined chain lengths
1997
Abstract We present characteristic electroluminescence data on single-layer devices based on three different oligo phenylenevinylene compounds with defined chain lengths. Light-emitting diodes (LEDs) were prepared by subsequent vacuum evaporation of the oligomer film and the A1 top electrode onto an indium—tin oxide (ITO) substrate. The LEDs show light emission in the spectral range of yellow to orange depending on the conjugation length of the compound used. We report photoluminescence and optical absorption data of the thin sublimed films, together with the wavelength dependence of the electroluminescence and with the current—voltage characteristics of the LED devices. The redox behavior …
Responsivity measurements of N-on-P and P-on-N silicon photomultipliers in the continuous wave regime
2013
We report the electrical and optical comparison, in continuous wave regime, of two novel classes of silicon photomultipliers (SiPMs) fabricated in planar technology on silicon P-type and N-type substrate respectively. Responsivity measurements have been performed with an incident optical power from tenths of picowatts to hundreds of nanowatts and on a broad spectrum, ranging from ultraviolet to near infrared (340-820 nm). For both classes of investigated SiPMs, responsivity shows flat response versus the optical incident power, when a preset overvoltage and wavelength is applied . More in detail, this linear behavior extends up to about 10 nW for lower overvoltages, while a shrink is observ…
Autonomous frequency stabilization of two extended cavity diode lasers at the potassium wavelength on a sounding rocket
2016
We have developed, assembled, and flight-proven a stable, compact, and autonomous extended cavity diode laser (ECDL) system designed for atomic physics experiments in space. To that end, two micro-integrated ECDLs at 766.7 nm were frequency stabilized during a sounding rocket flight by means of frequency modulation spectroscopy (FMS) of 39^K and offset locking techniques based on the beat note of the two ECDLs. The frequency stabilization as well as additional hard- and software to test hot redundancy mechanisms were implemented as part of a state-machine, which controlled the experiment completely autonomously throughout the entire flight mission.
APDs as single-photon detectors for visible and near-infrared wavelengths down to Hz rates
2012
For the SPECTRAP experiment at GSI, Germany, detectors with Single-Photon counting capability in the visible and near-infrared regime are required. For the wavelength region up to 1100 nm we investigate the performance of 2x2 mm^2 avalanche photo diodes (APDs) of type S0223 manufactured by Radiation Monitoring Devices. To minimize thermal noise, the APDs are cooled to approximately -170 deg. C using liquid nitrogen. By operating the diodes close to the breakdown voltage it is possible to achieve relative gains in excess of 2x10^4. Custom-made low noise preamplifiers are used to read out the devices. The measurements presented in this paper have been obtained at a relative gain of 2.2x10^4. …
Design, upgrade and characterization of the silicon photomultiplier front-end for the AMIGA detector at the Pierre Auger Observatory
2021
The successful installation, commissioning, and operation of the Pierre Auger Observatory would not have been possible without the strong commitment and effort from the technical and administrative staff in Malargue. We are very grateful to the following agencies and organizations for financial support: Argentina -Comision Nacional de Energia Atomica; Agencia Nacional de Promocion Cientifica y Tecnologica (ANPCyT); Consejo Nacional de Investigaciones Cientificas y Tecnicas (CONICET); Gobierno de la Provincia de Mendoza; Municipalidad de Malargue; NDM Holdings and Valle Las Lenas; in gratitude for their continuing cooperation over land access; Australia -the Australian Research Council; Braz…
Polycaprolactone-based scaffold for oil-selective sorption and improvement of bacteria activity for bioremediation of polluted water: Porous PCL syst…
2017
A novel floatable and biodegradable sponge for the selective absorption of oil from water and potentially useful as cell carrier for bioremediation treatments was prepared in polycaprolactone (PCL). The eco-friendly process for fabricating the PCL sponge does not involve either synthetic routes or organic solvents, thus minimizing environmental hazard. In particular, the 3D porous materials have been prepared by mixing in the melt the polymer matrix with two water-soluble porogen agents (NaCl and PEG) and thereafter leaching the obtained PCL/NaCl/PEG composites in water. The PCL sponges here proposed are capable to remove different types of oily pollutants (up to 500 wt%), and were successf…
Optical characterization of phase transitions in pure polymers and blends
2015
To study the optical properties of polymeric samples, an experimental apparatus was designed on purpose and set up. The sample is a thin film enclosed between two glass slides and a PTFE frame, with a very thin thermocouple placed on sample for direct temperature measurement. This sample holder was placed between two aluminum slabs, equipped with a narrow slit for optical measurements and with electrical resistances for temperature control. Sample was enlightened by a laser diode, whereas transmitted light was detected with a photodiode. Measurements were carried out on polyethylene-terephtalate (PET) and two different polyamides, tested as pure polymers and blends. The thermal history impo…
Evaluation of a commercial APD array (Avalanche PhotoDiode) for a readout detector in a hadrontherapy beam characterization application
2010
The aim of the present work is the characterization of the S8898–128–02 Avalanche PhotoDiode array (APDs) from Hamamatsu Photonics. This work includes the implementation of a readout system as well as electronic noise estimation in APDs under several conditions varying integration times and clock frequencies.
Magnetic skyrmions: from fundamental to applications
2016
In this topical review, we will discuss recent advances in the field of skyrmionics (fundamental and applied aspects) mainly focusing on skyrmions that can be realized in thin film structures where an ultrathin ferromagnetic layer (<1 nm) is coupled to materials with large spin-orbit coupling. We review the basic topological nature of the skyrmion spin structure that can entail a stabilization due to the chiral exchange interaction present in many multilayer systems with structural inversion asymmetry. The static spin structures and the dynamics of the skyrmions are also discussed. In particular, we show that skyrmions can be displaced with high reliability and efficiency as needed for t…