Search results for "Methanol"

Methanol electrooxidation with Cu-B catalyst

2016

In the last few years alternative energy sources have been fast developing. One of these sources is fuel cell. Due to development of the renewable energy sources, the powering of fuel cells with bio-fuels is very important. The one of this fuel is methanol. The use of fuel cells on a large scale is mainly limited by the high cost of catalysts - mainly platinum. Elimination of Pt as catalyst would allow for wider commercial application of fuel cells. The paper presents a study of methanol electrooxidation on electrode with Cu-B alloy catalyst. Researches were done by the method of polarizing curves of electrooxidation of methanol in glass vessel. An aqueous solution of KOH was used as the el…

Stop Ni - Co jako katalizator anody ogniwa paliwowego zasilanego alkoholem metylowym

2016

Interplay of acidity and ionic liquid structure on the outcome of a heterocyclic rearrangement reaction

2021

The study of suitable probe reactions is a powerful tool to investigate the properties of nonconventional solvents such ionic liquids (ILs). In particular, we studied the acid-catalyzed mononuclear rearrangement of heterocycles (MHR) of the Z-phenylhydrazone of 5-amino-3-benzoyl-1,2,4-oxadiazole into the relevant 1,2,3-triazole, in solution of ILs by means of kinetic measurements. We chose as solvents six ILs differing both in the cation and anion, in the presence of five carboxylic and sulfonic acids as catalysts. For a useful comparison, the reaction was also performed in 1,4-dioxane and methanol. In general, the reaction occurs faster in ILs, compared to conventional solvents, according …

CCDC 973767: Experimental Crystal Structure Determination

2014

Related Article: Alexandre Abhervé, Juan Modesto Clemente-Juan, Miguel Clemente-León, Eugenio Coronado, Jaursup Boonmak, Sujittra Youngme|2014|New J.Chem.|38|2105|doi:10.1039/C3NJ01516E

Effect of atomic layer deposited zinc promoter on the activity of copper-on-zirconia catalysts in the hydrogenation of carbon dioxide to methanol

2023

Funding Information: The work at Aalto University has been financially supported by the Academy of Finland (COOLCAT consortium, decision no. 329977 and 329978 ; ALDI consortium, decision no. 331082 ). This work made use of Aalto University Bioeconomy, OtaNano and RawMatters infrastructure. Hannu Revitzer (Aalto University) is thanked for the ICP-OES analysis, Aalto workshop people (especially Seppo Jääskeläinen) for working on the reactor modifications. The DFT calculations were made possible by computational resources provided by the CSC — IT Center for Science, Espoo, Finland ( https://www.csc.fi/en/ ) and computer capacity from the Finnish Grid and Cloud Infrastructure (urn:nbn:fi:resear…

Linear Triphosphines as Ligands for Metal Complexes Immobilization in Ionic Liquids: Palladium-Catalyzed Methoxylation of Alkynes

2012

Several novel palladium triphosphine complexes have been synthesized and tested as recyclable catalysts for the methoxylation of alkynes into acetals in ionic liquids. A complete conversion of phenylacetylene was achieved with only 0.2% of (Pd(Triphos)NCMe)((PF6)2) in a methanol/(BMIM)(BF4) mixture. We discovered that the addition of an ionic liquid to methanol allowed not only to increase the activity of the palladium catalyst but also to provide a recyclable catalyst which can be reused several times with a weaker drop of activity. To complete these catalytic studies, we describe the synthesis of the first poor -electron-donating/strong -electron-acceptor linear Triphosphine which, afte…

Effect of different co-solvents on biodiesel production from various low-cost feedstocks using Sr–Al double oxides

2020

The main objective of the present paper comprises the investigation of biodiesel production from low-cost feedstock such as lard oil and waste cooking oil (WCO) using Sr-Al double oxides. Nanocatalyst was characterised FTIR, XRD, SEM, TEM, BET and XPS. The Sr:Al with 3:1 molar ratio showed the best catalytic activity in the conversion of both oils to fatty acid methyl ester. The effect of acetone and tetrahydrofuran (THF) as a co-solvent for transesterification were compared and the best result was obtained with 5 % THF. The mutual effect of the nanocatalyst and co-solvent on biodiesel production was investigated. The characterisation of biodiesel synthesised from lard oil and WCO was perfo…

N-Cinnamoyltetraketide Derivatives from the Leaves of Toussaintia orientalis

2015

Seven N-cinnamoyltetraketides (1−7), including the new Ztoussaintine E (2), toussaintine F (6), and toussaintine G (7), were isolated from the methanol extract of the leaves of Toussaintia orientalis using column chromatography and HPLC. The configurations of E-toussaintine E (1) and toussaintines A (3) and D (5) are revised based on single-crystal X-ray diffraction data from racemic crystals. Both the crude methanol extract and the isolated constituents exhibit antimycobacterial activities (MIC 83.3−107.7 μM) against the H37Rv strain of Mycobacterium tuberculosis. Compounds 1, 3, 4, and 5 are cytotoxic (ED50 15.3−105.7 μM) against the MDA-MB-231 triple negative aggressive breast cancer cel…

Reactions of m-Terphenyl-Stabilized Germylene and Stannylene with Water and Methanol: Oxidative Addition versus Arene Elimination and Different React…

2015

Reactions of the divalent germylene Ge(ArMe6)2 (ArMe6 = C6H3-2,6-{C6H2-2,4,6-(CH3)3}2) with water or methanol gave the Ge(IV) insertion product (ArMe6)2Ge(H)OH (1) or (ArMe6)2Ge(H)OMe (2), respectively. In contrast, its stannylene congener Sn(ArMe6)2 reacted with water or methanol to produce the Sn(II) species {ArMe6Sn(μ-OH)}2 (3) or {ArMe6Sn(μ-OMe)}2 (4), respectively, with elimination of ArMe6H. Compounds 1–4 were characterized by IR and NMR spectroscopy as well as by X-ray crystallography. Density functional theory calculations yielded mechanistic insight into the formation of (ArMe6)2Ge(H)OH and {ArMe6Sn(μ-OH)}2. The insertion of an m-terphenyl-stabilized germylene into the O–H bond was…

Effect of sample preparation on gel permeation chromatography results of determination of molecular weight of polyethylene obtained with using of zir…

2003

Molecular weights of polyethylene (PE) obtained with using of zirconocene catalyst activated with large excess of methylaluminoxane (MAO) were determined by gel permeation chromatography (GPC) method. It was found that repeatability of the measurements is strongly influenced by MAO remained in PE samples as well as time of sample keeping in the apparatus (dissolution + measurement time) at temp. 142 °C. A method of MAO removing from PE samples, before GPC measurement, based on additional washing of the sample with HF in methanol solution has been proposed. This modification leads to better both authenticity and repeatability of the results. Studies on the influence of time of sample keeping…