Search results for "Microstructure"
showing 10 items of 707 documents
Suspended core tellurite glass optical fibers for infrared supercontinuum generation
2011
International audience; We report the fabrication and characterization of tellurite TeO(2)-ZnO-Na(2)O (TZN) microstructured suspended core optical fibers (MOFs). These fibers are designed for infrared supercontinuum generation with zero dispersion wavelength (ZDW) at 1.451 mu m. The measured losses at this wavelength are approximately 6 dB/m for a MOF with a 2.2 mu m diameter core. The effective area of a particular fiber is 3.5 mu m(2) and the nonlinear coefficient is calculated to be 437 W(-1)km(-1). By pumping a 20 cm long fiber at 1.56 mu m with a sub-nj femtosecond laser source, we generate a supercontinuum (SC) spanning over 800 nm in the 1-2 mu m wavelength range.
Chalcogenide glass hollow core photonic crystal fibers
2010
International audience; We report the first hollow core photonic crystal fibers (HC PCF) in chalcogenide glass. To design the required HC PCF profiles for such high index glass, we use both band diagram analysis to define the required photonic bandgap and numerical simulations of finite size HC PCFs to compute the guiding losses. The material losses have also been taken into account to compute the overall losses of the HC PCF profiles. These fibers were fabricated by the stack and draw technique from Te20As30Se50 (TAS) glass. The fibers we drew in this work are composed of six rings of holes and regular microstructures. Two profiles are presented, one is known as a kagome lattice and the ot…
Tellurites fibers for infrared supercontinuum sources : opto-geometric profiles and extrinsic absorptions management
2016
This PhD thesis work focuses on the synthesis and purification of vitreous materials used for the development of waveguides with varied profiles, dedicated to supercontinuum (SC) generation between 1 and 5 μm.Concerning the purification of tellurite glasses, several leads were followed, but best results are obtained for the purification of the TeO2-ZnO-Na2O glassy system by the means of zinc fluoride. Attenuation measurements performed on several meter-long single-index fiber samples reveal the nearly complete elimination of water-related absorptions between 3 and 4 μm (OH ions concentration lower than 1 ppm mass.). Such water-purified glasses were firstly dedicated to microstructured optic…
Fibres optiques à coeur supendu en verre d'oxyde de tellure et génération d'effets non linéaires dans l'infrarouge au-delà de 2 microns
2012
The work reported in this thesis deals with the fabrication of suspended core tellurite microstructured optical fibers (MOFs) for supercontinuum generation beyond 2 µm. In order to reach our aim, we first studied thermal and optical properties of TeO2-ZnO-R2O and TeO2-WO3-R2O (where R = Li, Na and K) glasses. The glass 80TeO2-10ZnO-10Na2O (molar %) has been chosen in order to make MOFs for characterization of the generated non linear optical effects. Synthesis performed under dry and oxidative atmosphere allowed us to reduce the hydroxyl groups concentration by a factor of 30 compared to fabrication in air atmosphere. Use of dehydrating agents (ZnF2 and TeCl4) allowed to reduce again the OH…
Polarization Modulation Instability in All-Normal Dispersion Microstructured Optical Fibers With Quasi-Continuous Pump
2019
We report the experimental observation of the polarization modulation instability (PMI) effect in all-normal dispersion (ANDi) microstructured optical fibers (MOFs) with quasi-continuous pumping. The small unintentional birefringence (~10-5), that any realistic non-polarization maintaining MOF exhibits, contributes to this nonlinear effect. PMI can produce two sidebands whose polarization state is orthogonal to the polarization of the pump. In this work, only one type of PMI process is observed, i.e., when the pump is polarized along the slow axis of the fiber and sidebands are generated in the fast axis mode. This PMI process was studied experimentally in two ANDi fibers with different dis…
Pulsed electric field (PEF) recovery of biomolecules from Chlorella: Extract efficiency, nutrient relative value, and algae morphology analysis
2023
This study investigated the effects of pulsed electric field (PEF) (3 kV/cm, 44 pulses, 99 kJ/kg), solvent (H2O or 50 % DMSO) and time (0, 10, 20, 30, 60, 90, 120 and 180 min) on the extraction of Chlorella antioxidant biomolecules and minerals. The results showed that PEF treatment increased the biomolecules recovery. For the extraction time of 120 min, more proteins and polyphenols were obtained using water, while more chlorophyll a and b, and carotenoids were obtained using 50 % DMSO as the extraction solvent. The extracts mineral concentration (PEF vs control) were analysed including Mg, P, Ca, Fe and Zn, and the Relative Nutrient Values results indicated that Chlorella H2O-extracts cou…
Accurate modal characterization of optical fibers using acousto-optics
2016
In-fiber acousto-optics enable accurate and broadband characterization of two mode optical fibers. Differential effective index, group index and dispersion are reported for two-mode optical fibers. Small phase differences between the quasi-degenerated vector modes comprising the LP 11 mode are also measured. In addition, a fine analysis of fiber axial non-uniformities can be performed using a time-resolved acousto-optic technique. In this case, sub-ppm changes of effective index are measured with few cm resolution along fiber sections of about 2 m.
Endlessly single-mode heat-sink waveguide
1998
Recently, a new form of optical fiber, the photonic crystal fiber, has been reported. This fiber has a hexagonal array of submicrometer air holes running along its length and a lattice site without a hole (a line defect) in its center. The defect acts as a core, confining light that travels along the fiber as a guided mode. This structure can be endlessly single mode, never supporting more than one confined mode no matter what the diameter of the core or the wavelength of the light. Having discovered this effect experimentally and provided a qualitative explanation for the observed behavior, we present here a planar version of this fiber. Periodic arrays of parallel planar fins are placed o…
Study of the microstructure and efficiency of YSZ-SPS finely structured ceramic coatings
2018
Thanks to the using of liquid carrier, suspension plasma spray (SPS) enables the manufacture of finely structured coatings. As for conventional plasma spraying (APS), the microstructures of SPS coatings can be tailored by controlling the spray conditions. However, SPS is more complicated than APS due to its number of modifiable parameters.This thesis aims to provide a more fundamental understanding of the relationship between SPS process parameters and the properties of YSZ coatings by identifying generic models based on the use of mathematical statistical methods for the study of influence and sensitivity of the individual parameters.Systematic experiments were carried out to study the inf…
Morphology of ZnO grown by MOCVD on sapphire substrates
2004
A quantitative roughness and microstructural analysis of ZnO grown on sapphire by atmospheric metalorganic chemical vapor deposition (MOCVD) is presented. In order to investigate the influence of the substrate on the morphology, different sapphire orientations have been employed. Scanning force microscopy data have been analyzed for a variety of thicknesses to elucidate, if possible, the growth mechanisms involved in the growth process. Our study reveals significant differences between morphologies depending on whether the substrate surface exhibits steps (misoriented a-, c- and r-planes) or not (m-plane); however, no major differences on the calculated roughness coefficients have been foun…