Search results for "Molar"
showing 10 items of 1069 documents
Determination of UV filters in both soluble and particulate fractions of seawaters by dispersive liquid–liquid microextraction followed by gas chroma…
2014
An analytical method to determine the total content (i.e., not only in the soluble fraction but also in the particulate one) of eight commonly used UV filters in seawater samples is presented for the first time. Dispersive liquid-liquid microextraction (DLLME) is used as microextraction technique to pre-concentrate the target analytes before their determination by gas chromatography-mass spectrometry (GC-MS). In order to release the UV filters from the suspended particles an ultrasound treatment is performed before DLLME. The ultrasound treatment time was studied in order to achieve a quantitative lixiviation of the target analytes. The type and volume of both disperser and extraction solve…
Determination of atranol and chloroatranol in perfumes using simultaneous derivatization and dispersive liquid-liquid microextraction followed by gas…
2013
Abstract A new analytical method based on simultaneous derivatization and dispersive liquid–liquid microextraction (DLLME) followed by gas chromatography–mass spectrometry (GC–MS), for the determination of the allergenic compounds atranol and chloroatranol in perfumes, is presented. Derivatization of the target analytes by means of acetylation with anhydride acetic in carbonate buffer was carried out. Thereby volatility and detectability were increased for improved GC–MS sensitivity. In addition, extractability by DLLME was also enhanced due to a less polar character of the solutes. A liquid–liquid extraction was performed before DLLME to clean up the sample and to obtain an aqueous sample …
Spectrophotometric estimation of bicalutamide in tablets
2007
A simple, sensitive, rapid, accurate and precise spectrophotometric method has been developed for the estimation of bicalutamide in bulk and pharmaceutical dosage forms. Bicalutamide shows maximum absorbance at 272 nm with molar absorptivity of 2.3399×10(4) l/mol/cm. Beer's law was obeyed in the concentration range of 1.5-18 μg/ml. The limit of detection and limit of quantification were found to be 0.1 and 0.4 μg/ml, respectively. Results of analysis were validated statistically and by recovery studies.
Determination of organophosphorus pesticides in honeybees after solid-phase microextraction.
2001
A method based on solid-phase microextraction (SPME) followed by gas chromatography with nitrogen-phosphorus detection was developed for the purpose of determining 18 organophosphorus pesticide residues in honeybee samples (Apis mellifera). The extraction capacities of polyacrylate and poly(dimethylsiloxane) fibers were compared. The main factors affecting the SPME process, such as the absorption time profile, salt, and temperature, were optimized. The method involved honeybee sample homogenization, elution with an acetone:water solution (1:1) and dilution in water prior to fiber extraction. Moreover, the matrix effect on the extraction was evaluated. In samples spiked at the 0.2 mg kg(-1) …
The 4th international comparison on EPR dosimetry with tooth enamel
2011
This paper presents the results of the 4th International Comparison of in vitro electron paramagnetic resonance dosimetry with tooth enamel, where the performance parameters of tooth enamel dosimetry methods were compared among sixteen laboratories from all over the world. The participating laboratories were asked to determine a calibration curve with a set of tooth enamel powder samples provided by the organizers. Nine molar teeth extracted following medical indication from German donors and collected between 1997 and 2007 were prepared and irradiated at the Helmholtz Zentrum Munchen. Five out of six samples were irradiated at 0.1, 0.2, 0.5, 1.0 and 1.5 Gy air kerma; and one unirradiated s…
Development of stir bar sorptive-dispersive microextraction mediated by magnetic nanoparticles and its analytical application to the determination of…
2014
A novel microextraction technique combining the principles of stir bar sorptive extraction (SBSE) and dispersive micro-solid phase extraction (DμSPE) is presented. The main feature of the method is the use of a neodymium-core stirring bar physically coated with a hydrophobic magnetic nanosorbent. Depending on stirring speed, the magnetic sorbent either acts as a coating material to the stir bar, thus affording extraction alike SBSE, or as a dispersed nanosorbent medium for the collection and extraction of the target analytes, in close analogy to DμSPE. Once the stirring process is finished, the strong magnetic field of the stir bar prevails again and rapidly retrieves the dispersed MNPs. Al…
3,3?,5,5?-Tetramethylbenzidme for the colorimetric determination of manganese in water
1998
Manganese can be determined by colorimetry with previous oxidation of Mn(II) in a strong basic medium, using 3,3′,5,5′-tetramethylbenzidine as a chromogenic reagent. The molar absorptivity of the reaction product is 3.4 × 104 mol−1l cm−1l, the detection limit 3 ng/ml, the RSD (0.5 mg/l,n = 8) 0.9% and the calibration range (1-cm cells) 0.02–0.8 mg/1 V(V), Cr(VI) and Co(II) are the most significant interferences. The new method was compared with an AAS procedure (air-acetylene flame) with previous solvent extraction and also with a colorimetric method for the determination of manganese in sea and drinking water.
Eficacia analgésica del diclofenaco sódico vs. ibuprofeno después de la extracción quirúrgica de un tercer molar inferior incluido
2004
-Objetivo: En este estudio evaluamos la eficacia analgésica del diclofenaco sódico en comparación con el ibuprofeno, después de la extracción quirúrgica de un tercer molar inferior incluido. -Diseño de estudio: Los pacientes que participaron en el estudio fueron distribuidos de forma aleatoria en dos grupos. Uno fue el grupo ibuprofeno y el otro el grupo diclofenaco. La intervención practicada fue la extracción quirúrgica de un tercer molar inferior cuya dificultad fue determinada en función del grado de inclusión en todos los pacientes. Las variables registradas fueron la intensidad del dolor y la necesidad de medicación de rescate durante un periodo de una semana. Los registros se realiza…
Dispersion Polymerization of Vinylidene Fluoride in Supercritical Carbon Dioxide
2006
The dispersion polymerization of vinylidene fluoride in supercritical carbon dioxide is investigated using two ammonium carboxylate perfluoropolyether stabilizers of different molecular weights. Under suitable operating conditions a polymer made of well-dispersed spherical particles has been obtained up to relatively high conversion. The experimental data of polymerization rate and molecular weight distribution are in good agreement with the predictions of a model previously developed. Such an agreement supports the conclusion that the polymerization kinetics is dominated by the interphase transport of the active radicals between the continuous phase and the polymer particles.
Zur kinetik der anionischen polymerisation von methyl-methyacrylat in tetrahydrofuran bei −75°C
1973
Die anionische Polymerisation von Methylmethacrylat (MMA) in Tetrahydrofuran (THF) verlauft bei −75°C mit Cumylcasium bzw. oligomerem α-Methylstyrylcasium als Initiatoren ohne erkennbare Nebenreaktionen analog der anionischen Polymerisation von unpolaren Monomeren in atherischen Losungsmitteln. Als Beweis wird hauptsachlich die enge Molekulargewichtsverteilung der unter diesen Bedingungen hergestellten Polymethylmethacrylate angefuhrt. Bei −75°C betragen die Geschwindigkeitskonstanten fur die Monomeranlagerung an das Ionenpaar kw(±) = 80 dm3 mol−1 s−1 und an das freie Anion etwa kw(−) ≈ 6 · 104 dm3 mol−1 s−1. Leitfahigkeitsmessungen ergeben, das die Dissoziationskonstante des Polymethylmeth…