Search results for "Mott-Schottky"
showing 10 items of 13 documents
Photoelectrochemical characterization of anatase-rutile mixed TiO2 nanosponges
2016
This work studies the influence of using hydrodynamic conditions during anodization on the morphology and electrochemical properties of anatase/rutile mixed TiO2 nanotubes (Reynolds number, Re = 0) and nanosponges (Re > 0). To this purpose different techniques were used, such as: microscopy techniques (Field-Emission Scanning Electron Microscope, FE-SEM, and Confocal Laser-Raman Spectroscopy), Electrochemical Impedance Spectroscopy (EIS), Mott Schottky (MS) analysis and photoelectrochemical water splitting tests. This investigation demonstrates that the morphology of TiO2 nanostructures may be greatly affected due to the hydrodynamic conditions and it can be adjusted in order to increase th…
Effect of Reynolds number and lithium cation insertion on titanium anodization
2016
This work studies the influence of using hydrodynamic conditions (Reynolds number, Re = 0 to Re = 600) during Ti anodization and Li+ intercalation on anatase TiO2 nanotubes. The synthesized photocatalysts were characterized by using Field Emission Scanning Electron Microscope (FE-SEM), Raman Confocal Laser Microscopy, Electrochemical Impedance Spectroscopy (EIS), Mott-Schottky analysis (M-S), photoelectrochemical hydrogen production and resistance to photocorrosion tests. The obtained results showed that the conductivity of the NTs increases with Li+ intercalation and Re. The latter is due to the fact that the hydrodynamic conditions eliminate part of the initiation layer formed over the tu…
Electronic properties and corrosion resistance of passive films on austenitic and duplex stainless steels
2018
Abstract Passive films were grown at constant potential in acidic (pH∼2) and alkaline (pH∼13) solutions on chromium, AISI 304L, AISI 316L and Duplex stainless steels. Passive films on chromium grow following a high field mechanism considering the presence of dissolution phenomena. According to the photoelectrochemical characterization, passive films on Cr have a bandgap of 3.4 eV when formed in acidic solution, and of 2.4 eV when formed in alkaline solution due to the formation of Cr(OH)3. These films result to be poorly stable against anodic dissolution due to a very anodic flat band potential. Conversely, impedance and photoelectrochemical measurements proved that passive films on stainle…
Electronic properties and mobile defects distribution in amorphous semiconducting passive films
2003
A study of the electronic properties of thin (drop 25 nm) a-WO3 and a-Nb2O5 is presented. Based on theory of amorphous semiconductor Schottky barrier the fitting of admittance curves in a large range of electrode potential (around 9 V) and a.c. frequency (100 Hz - 10 kHz) is performed. A density of electronic state distribution (DOS) is derived, which mimics the mobile defects distribution suggested by the classical high field model of oxides growth.
Corrosion behaviour of a highly alloyed austenitic alloy UB6 in contaminated phosphoric acid
2013
The influence of temperature (20–80°C) on the electrochemical behaviour of passive films anodically formed on UB6 stainless steel in phosphoric acid solution (5.5 M H3PO4) has been examined by using potentiodynamic curves, electrochemical impedance spectroscopy, and Mott-Schottky analysis. UB6 stainless steel in contaminated phosphoric acid is characterised by high interfacial impedance, thereby, illustrating its high corrosion resistance. The obtained results show that the films behave as n-type and p-type semiconductors in the potential range above and below the flat band potential, respectively. This behaviour is assumed to be the consequence of the semiconducting properties of the iron …
Study of Passive Films Formed on AISI 316L Stainless Steel in Non-Polluted and Underwater-Volcano-Polluted Seawater
2014
This work studies the semiconducting behavior of passive films formed on AISI 316L (UNS S31603) in two different sea-water solutions, non-polluted and polluted, collected from the volcano of El Hierro Island. Polarization measurements, potentiostatic passivation tests, electrochemical impedance spectroscopy, and capacitance measurements were performed. Results show that the polluted seawater worsens passivation kinetics. Additionally, passive films formed on AISI 316L stainless steel in polluted seawater have been found to be less protective than those formed in non-polluted seawater, showing a more defective structure, owing to the acidity of the polluted medium.
Use of Mott-Schottky Plots to Characterise the Amorphous Passive Film/Electrolyte Junction
2010
Mott-Schottky analysis of differential capacitance data of passive-film electrolyte junctions. Is it really providing correct physical insights on th…
2009
Semiconductor electrochemistry approach to passivity and passivity breakdown of metals and metallic alloys
2004
AbstractA critical appraisal of the use of the theory of semiconductors in characterising passive films on metals and alloys is provided, with special emphasis on the use of Mott-Schottky theory for the location of characteristic energy levels of the passive film-electrolyte junction. Some inconsistencies between theory and experimental results in the case of thin passive films are discussed together with possible alternative ways for overcoming such problems. The role of semiconducting properties in determining the pitting behaviour of passive films on W in solutions containing halide is presented and discussed. The validity of a recently proposed correlation between the solid state proper…