Search results for "Number"
showing 10 items of 3939 documents
Chapter 3 patterns and thresholds of runoff generation and sediment transport on some Mediterranean hillslopes
2005
Abstract Runoff and sediment transport data obtained from hillslopes in two limestone areas in southeast Spain are analysed in order to define spatial and temporal thresholds for sediment movement at the patch scale under Mediterranean semiarid and subhumid climatological conditions. The data discussed in this paper include a 7-year series of runoff and sediment collection in open Gerlach plots. The 136 events are analysed in relation to characteristics of rainfall, soil and soil surface components. In both cases slopes behave as a patchwork of runoff and runon areas and the size of the runoff or runon patches being dependent on the climatological conditions. These control the hydrological …
Mechanical, thermal and acoustical characterizations of an insulating bio-based composite made from sunflower stalks particles and chitosan
2014
International audience; This study has for objective the determination of thermal, mechanical and acoustical properties of insulating bio-based composite made with chitosan and sunflower's stalks particles. An experimental design was established to find the size grading of particles, the ratio chitosan/sunflower particles and the stress of compaction influencing the thermal and mechanical properties. Composites with a thermal conductivity $(\kappa)$ of 0.056 W/m/K, a maximum stress $(\sigma_{\text{max}})$ of 2 MPa and an acoustic coefficient of absorption $(\alpha)$ of 0.2 were obtained with a ratio of chitosan of 4.3% (w/w) and a size grading of particles higher to 3 mm. These mechanical a…
On the variations of acoustic absorption peak with particle velocity in micro-perforated panels at high level of excitation.
2010
The acoustic behavior of micro-perforated panels (MPP) is studied theoretically and experimentally at high level of pressure excitation. A model based on Forcheimer's regime of flow velocity in the perforations is proposed. This model is valid at relatively high Reynolds numbers and low Mach numbers. The experimental method consists in measuring the acoustical pressure at three different positions in an impedance tube, the two measurement positions usually considered in an impedance tube and one measurement in the vicinity of the rear surface of the MPP. The impedance tube is equipped with a pressure driver instead of the usual loudspeaker and capable of delivering a high sound pressure lev…
Experimental investigation of holes interaction effect on the sound absorption coefficient of micro-perforated panels under high and medium sound lev…
2011
Abstract This paper experimentally investigates the holes interaction effect on the sound absorption coefficient of micro-perforated panels under high and medium sound levels. The theoretical formulations are based on a semi-empirical approach and the use of Fok’s function to model the acoustic surface impedance. For the high sound level regime, an empirical power law involving three coefficients is adapted. It is shown theoretically and experimentally that these coefficients can lead to optimized absorption performance and particularly, a formula relating the critical Reynolds number (Reynolds number value after which the absorption coefficient decreases with the increase of sound level) a…
Investigation of water sorption and aluminum releases from high viscosity and resin modified glass ionomer.
2019
Background High viscosity glass ionomer cement (HVGIC) and resin-modified glass ionomer cement (RMGIC) have recently been clinically preferred thanks to their numerous advantages. However, initial moisture contamination has a negative effect on the mechanical and physical properties of these cements. The aim of this study was in vitro of HVGICs and RMGICs, with and without surface protection, on water sorption, solubility and release of aluminum. Material and Methods In this study, as HVGICs; Equia Forte, IonoStar Plus, Riva Self Cure; as RMCIS, Ionolux and Riva Light Cure; and as control, Z250 universal composite was used. Equia coat, Voco varnish and Riva coat were chosen as surface prote…
Basalt Fibre Composite with Carbon Nanomodified Epoxy Matrix under Hydrothermal Ageing
2021
This work aimed to investigate the effect of hybrid carbon nanofillers (e.g., carbon nanotubes/carbon nanofibers in the ratio 1:1 by mass) over the electrical and flexural properties for an epoxy matrix and corresponding basalt fibre reinforcing composite (BFRC) subjected to full-year seasonal water absorption. Hydrothermal ageing was performed by full immersion of the tested materials into distilled water according to the following model conditions (seasons). The mechanical properties were measured in three-point bending mode before environmental ageing and after each season. Upon environmental ageing, the relative change of flexural strength and elastic modulus of the epoxy and NC was wit…
Hybrid layers of etch-and-rinse versus self-etching adhesive systems.
2010
Objective: To evaluate the effectiveness in the formation of resin tags, adhesive lateral branches and hybrid layers of five adhesive systems, when bonding to dentine. Material and Methods: Flat dentin surfaces from 25 molars were bonded with several adhesive systems according to the manufacturers? instructions. Composite build-ups were constructed incrementally with Tetric Ceram. The Specimens were sectioned parallel to the long axis. One section was treated with phosphoric acid and sodium hypochlorite in order to reveal the hybrid layer formation. The other section was stored in 30% hydrochloric acid to detect resin tags and adhesive lateral branch formation. Results: The two etch-and-rin…
Spectroscopic and quantum chemical study of pressure effects on solvated chlorophyll
2004
Abstract Hydrostatic pressure effects up to 907 MPa on absorption spectra of chlorophyll a molecules dissolved in diethyl ether have been studied at ambient temperature both experimentally and theoretically using quantum chemistry methods. The fluorescence spectra are studied only experimentally. The data suggest that coordination interactions between the central Mg atom of the chlorophyll and solvent molecules along with interactions that modify the porphyrin skeleton of the solute are responsible for the observed differences of pressure dependence of the Q y , Q x , and Soret spectral bands. The coordination number of the Mg atom changes from five to six between 400 and 600 MPa.
Microscopic origin of the charge transfer in single crystals based on thiophene derivatives: A combined NEXAFS and density functional theory approach
2016
We have investigated the charge transfer mechanism in single crystals of DTBDT-TCNQ and DTBDT-F4TCNQ (where DTBDT is dithieno[2,3-d;2',3'-d'] benzo[1,2-b;4,5-b']dithiophene) using a combination of near-edge X-ray absorption spectroscopy (NEXAFS) and density functional theory calculations (DFT) including final state effects beyond the sudden state approximation. In particular, we find that a description that considers the partial screening of the electron-hole Coulomb correlation on a static level as well as the rearrangement of electronic density shows excellent agreement with experiment and allows to uncover the details of the charge transfer mechanism in DTBDT-TCNQ and DTBDT-F4 TCNQ, as w…
Double-Electron Excitations in L-edges X-ray-Absorption Spectra of W, Ir and Cs Oxide Compounds
1993
Very strong double-electron excitations have been observed for the first time in the W, Ir L 3-edge and Cs L 1,2,3-edges X-ray-absorption spectra of tungsten and iridium oxide thin films and cesium oxide containing glasses. They are expressed as peaks with a width of several electron-volts located at the absorption background above the edge. The positions of these features are in good agreement with atomic calculations in the Z+1 approximation. They can be attributed to the transitions 2p4d → 5d5d for the L 2,3-edges and 2s4d → 6p5d for the L 1-edge with the dipole selection rules for the angular and total angular momentum ΔL=±1, ΔJ=0,±1.