Search results for "Open"
showing 10 items of 3963 documents
Polymer solar cells based on diphenylmethanofullerenes with reduced sidechain length
2011
Diphenylmethanofullerenes (DPMs) show interesting properties as acceptors in polymer bulk heterojunction solar cells due to the high open circuit voltages they generate compared to their energy levels. Here we investigate the effect of reducing the alkane sidechain length of the DPMs from C12 to C6 in the properties of the solar cell. This change leads to an increase in the electron mobility, thus allowing for a lower fullerene content, which in turn results in an increase in the short circuit current and, finally, in an increase in the efficiency of the device (from 2.3 to 2.6%) due to the higher concentration of the more absorbing polymer in the film. Atomic force microscopy images and ex…
Tomato peel drying and carotenoids stability of the extracts
2014
Summary Tomato peels were firstly dried by different methods (hot air, freeze-drying, and fluidized bed drying) to evaluate the recovery of lycopene, β-carotene and DPPH radical scavenging activity. Comparison of the results showed that hot air drying at 50 °C was a suitable method and alternative to freeze-drying to preserve carotenoids compounds and antioxidant activity in tomato peels. Then, ethanol/ethyl acetate (1:1) extracts from tomato peel, previously dried at 50 °C by hot air, were submitted to heat (100 °C) and light treatment (1000 lumen) to evaluate their stability as natural food dyes. Heating of the extracts caused a progressive reduction of total carotenoids, up to about 30% …
2-Chloro/phenyl-7-arylimino-6,6-dimethylcyclopenta[b]pyridylnickel chlorides: Synthesis, characterization and ethylene oligomerization
2017
Abstract 2-Chloro/phenyl-7-arylimino-6,6-dimethylcyclopenta[b]pyridylnickel chlorides (Ni1–Ni8) were synthesized from the respective ligands L1–L8 and characterized. Upon activation with either methylaluminoxane (MAO) or ethylaluminium sesquichloride (EASC), they show high catalytic activity of up to 10.84 × 106 g(oligomer) mol− 1(Ni) h− 1 in ethylene oligomerization. The products range from butenes to dodecenes for Ni1–Ni4, but are limited to butenes and hexenes in the case of Ni5–Ni8. DFT calculations indicate that the Ni C bond length in the model alkyl complexes depends both on the nature of the substituents at the heterocycles and the kind of the alkyl group, shedding some light on the…
Synthesis, characterization and catalytic behavior of AlTf/UVM-7 as new green catalysts for the glycols etherification reactions
2010
Abstract Bimodal porous Al–UVM-7 system materials with different Si-to-Al ratios were prepared using the Atrane route. These were converted in strong acid heterogeneous AlTf-based catalysts after the treatment with methanolic solutions of triflic acid. The materials so obtained were used as catalysts for the conversion of ethylene glycol (EG) and propylene glycol (PG) with octanol under solvent-free conditions. The process is selective to short ethoxylated structures resulting in the corresponding monoethers. While the conversion of EG and PG was very high (>94%) irrespective of the support characteristics, 1-octanol was transformed only in low degree (3–35%), and its conversion depends on …
A DFT study of the role of the Lewis acid catalysts in the [3 + 2] cycloaddition reaction of the electrophilic nitrone isomer of methyl glyoxylate ox…
2015
The molecular mechanism and stereoselectivity of the BF3 Lewis acid catalyzed [3 + 2] cycloaddition (32CA) reaction between C-methoxycarbonyl nitrone and cyclopentene has been theoretically studied using DFT methods at the MPWB1K/6-31G(d) computational level. The BF3 catalyst accelerates the 32CA reaction by decreasing the activation energy leading to the formation of the trans cycloadduct as the kinetic product, in agreement with the experimental data. Inclusion of solvent effects slightly increases the activation energy and decreases the exothermic character of the 32CA reaction as a consequence of a better solvation of nitrone than the transition state and the cycloadduct. The use of the…
Asymmetrische Hetero-Diels-Alder-Reaktionen in wäßriger Lösung unter Verwendung von Aminosäureestern als chiralen Auxiliaren
1989
(R)- und (S)-Aminosaure-methylester-hydrochloride bilden mit Formaldehyd in THF/Wasser-Gemischen Iminium-Ionen, die als elektronenarme Dienophile mit Cyclopentadien, 1,3-Cyclohexadien und Alkyl-substituierten Butadienen bereits bei 0°C Hetero-Diels-Alder-Reaktionen eingehen. Die Cycloaddukte werden mit hohen Ausbeuten im Multigrammasstab und mit Diastereomerenverhaltnissen (bis zu 93:7) gebildet, die mit anderen chiralen Aminen bisher nicht erreicht werden konnten. Mit Hilfe von NOE-Experimenten werden die absoluten Konfigurationen der Hauptdiastereomeren zugeordnet. Aus den Phenylglycin- und den Serin-Derivaten konnen die chiralen Hilfsgruppen mittels hydrogenolytischer Methoden bzw. unter…
Hantzsch Ester-Mediated Photochemical Transformations in the Ketone Series: Remote C(sp3)–H Arylation and Cyclopentene Synthesis through Strain Relea…
2021
A metal-free Hantzsch ester-mediated synthesis of cyclopentenylketones as well as γ-hetarylketones starting from ketocyclopropanes under eco-friendly conditions was developed. The versatility of the developed conditions is shown by reacting ketocyclopropanes in both a formal [3 + 2] cycloaddition with terminal alkynes (further investigated using theoretical calculations) and a radical C-C-coupling with cyanopyridines. The newly developed methodologies were later on utilized as a downstream reaction for photogenerated cyclopropanes combining UV and visible light photochemistry. Following this procedure, a UV-driven Norrish-Yang-type reaction induces the ring strain of the intermediates, whic…
An Easy Way Towardɛ-Caprolactone Macromonomers by Microwave Irradiation Using Early Lanthanide Halides as Catalysts
2002
Poly(e-caprolactone) macromonomers were synthesized under microwave irradiation from commercial caprolactone, using commercial hydrated lanthanide halides as catalysts. The molecular weight of the polymers was in the range 3 000–5 000. Higher molecular weights (5 000–20 000) and lower polydispersity indices were obtained with THF adducts of the lanthanide halides as catalysts and also by applying longer reaction times or using diethylene glycol as a coupling reagent.
Single-Component Polymerization Catalysts for Ethylene and Styrene: Synthesis, Characterization, and Reactivity of Alkyl and Hydrido Yttrium Complex…
1999
Yttrium alkyl complexes Y(η5:η1-C5Me4SiMe2NCMe2R)(CH2SiMe3)(THF) (R = Me, Et) and Y(η5:η1-C9H6SiMe2NCMe3)(CH2SiMe3)(THF) can be prepared in high yields by a σ-bond metathesis reaction between Y(CH2SiMe3)3(THF)2 and amino-functionalized cyclopentadienes or indene. The structure of Y(η5:η1-C5Me4SiMe2NCMe2Et)(CH2SiMe3)(THF) was shown by single-crystal X-ray diffraction to be that of a three-legged piano stool. Reaction of Y(CH2SiMe3)3(THF)2 with the tridentate linked amido−cyclopentadienyl ligands (C5Me4H)SiMe2NHR (R = CH2CH2OMe, CH2CH2NMe2, CH2CH2CH2OMe, CMe2CH2OMe), which contain an additional donor site, results in the cleavage of the silicon−cyclopentadienyl bond and the formation of the t…
Alkyl Complexes of Rare-Earth Metals That Contain a Furyl-Functionalized Cyclopentadienyl Ligand: Alkyl Cation Formation and Unexpected Ring-Opening…
2003
Rare-earth metal complexes of the type [Ln{η5:η1-C5Me4SiMe2(C4H3O-2)}(CH2SiMe3)2(THF)] (Ln = Y, Lu) were prepared by σ-bond metathesis of [Ln(CH2SiMe3)3(THF)2] with the 2-furyl-functionalized tetramethylcyclopentadiene (C5Me4H)SiMe2(C4H3O-2) and isolated as colorless crystals. Single-crystal X-ray structure analysis of the lutetium complex confirmed the coordination of the furyl group and THF to give a molecule of trigonal bipyramidal geometry with the oxygen donor atoms in the apical positions. The lability of the oxygen donor atoms results in fluxional behavior. Reaction with triphenylborane in THF gave thermally robust mono(alkyl) cations [Ln{η5:η1-C5Me4SiMe2(C4H3O-2)}(CH2SiMe3)(THF)n]+.…