Search results for "Organic Chemicals"
showing 10 items of 728 documents
Accelerated Light-Induced Defect Transformation Study of Elkem Solar Grade Silicon
2012
AbstractSolar cells made of silicon feedstock from a metallurgical route must qualify not only the initial efficiency, but must also be comparable to the solar cells made from reference polysilicon on the spectral response after light induced degradation. A detailed comparative study of light induced defects and its impact on cell performance is necessary for both materials. We have studied accelerated light induced degradation (ALID) defect transformation for Elkem Solar Silicon and polysilicon solar cells by selecting wafers from different positions from respective silicon bricks. Active boron-oxygen complexes and iron ions in multicrystalline silicon solar cells have been analyzed, and t…
One pot light assisted green synthesis, storage and antimicrobial activity of dextran stabilized silver nanoparticles.
2014
Background Green synthesis of nanomaterials finds the edge over chemical methods due to its environmental compatibility. Herein, we report green synthesis of silver nanoparticles (Ag NPs) mediated with dextran. Dextran was used as a stabilizer and capping agent to synthesize Ag NPs using silver nitrate (AgNO3) under diffused sunlight conditions. Results UV–vis spectra of as synthesized Ag nanoparticles showed characteristic surface plasmon band in the range from ~405-452 nm. Scanning electron microscopy (SEM) and atomic force microscopy (AFM) studies showed spherical Ag NPs in the size regime of ~50-70 nm. Face centered cubic lattice of Ag NPs was confirmed by powder X-ray diffraction (PXRD…
Silver-loaded nanoparticles affect ex-vivo mechanical behavior and mineralization of dentin
2019
Background: The aim was to evaluate the effect of silver loaded nanoparticles (NPs) application on the triboscopic, crystallographic and viscoelastic properties of demineralized dentin. Polymethylmetacrylate-based NPs and Ag loaded NPs were applied on demineralized dentin. Material and Methods: Treated and untreated surfaces were probed by a nanoindenter to test viscoelasticity, and by atomic force microscopy to test nanoroughness and collagen fibril diameter. X-ray diffraction and transmission electron microscopy through selected area diffraction and bright-field imaging were also used. Results: Dentin treated with Ag-NPs attained the lowest complex modulus, and the highest tan delta value…
Thermal Properties, Raman Spectroscopy and Tem Images of Neutron-Bombarded Graphite
2013
Neutron-irradiated graphite to a total dose of 3.6 × 1016 n cm−2 was studied by DSC, Raman spectroscopy and transmission electron microscopy (TEM). The Wigner energy of neutron-irradiated graphite was 9.5 J/g as measured by DSC; it was released with an exothermal peak at 220°C. The Raman spectroscopy has confirmed the expected effect caused by neutron irradiation of the graphite substrate. The TEM imaging has shown that neutron-irradiated graphite can be effectively exfoliated by sonication in comparison to pristine graphite, which under similar conditions does not exfoliate at all. The interstitial Frenkel defects in neutron-irradiated graphite are intercalated between the graphene layers …
Determination of the Boron/Lead Ratio in Ceramic Materials Based on Electrochemical Quartz Crystal Microbalance
2004
A method for quantitatively determining the relationship boron/lead in ceramic materials is presented. It is based on the attachment of microsamples of ceramic frits to an electrochemical quartz crystal microbalance (EQCM). After a reductive deposition step in the � 0.25 to � 0.85 V (vs. AgCl/Ag) potential range, well-defined stripping peaks are recorded in 0.10 M NaCl plus 0.10 M mannitol. The deposition of boron and lead from suspensions of solid materials, and its subsequent oxidative dissolution can be monitorized at the EQCM. The quotient between the maximum mass gain and the corresponding charge passed enables for a direct quantitation of the boron/lead molar ratio in ceramic material…
Influence of radiation defects on tritium release parameters from Li2O
1998
Abstract The study of the influence of radiation defects on tritium release behavior from polycrystalline Li2O was performed by simultaneous measurements of the luminescence emission and tritium release. It was found that the radiation defects in Li2O introduced by electron irradiation cause the retention of tritium. It is thought that the tritium recovery is affected by the formation of a Li–T bond, which is tolerant of high temperatures. The retardation of tritium decreases with increasing absorbed dose in the dose range from 50 to 140 MGy. The aggregation of radiation defects at high irradiation doses is considered to be responsible for the decrease of the interaction of tritium with rad…
Barrier properties of chitosan coated polyethylene
2012
The transfer properties of chitosan coated polyethylene (PE) films were studied. The barrier properties of non coated PE were not affected by relative humidity changes. The presence of the hydrophilic chitosan layer acted as a water reservoir on the polyethylene film surface which significantly promoted its sensitivity to the water vapour. The water vapour permeability increased 1.85 times at a higher RH. Coated PE films showed more than two-order decrease in the oxygen permeability (PO2) and three-order-decrease in the carbon dioxide permeability (PCO2). When the chitosan coated PE surface was exposed to the water vapour, the PO2 and the PCO2 were significantly increased. However, the perm…
Natural Radioactivity in Clay Ceramics and their Raw Materials in Latvia
2018
Natural radionuclides K-40, and Th-232, U-238 (Ra-226) decay chain products contained in building materials are the main source of radiation dose received by population and the only source of indoor radiation exposure. Present work contains results of the study of natural radionuclide activity level in clay, clay ceramics and silica bricks used in Latvia. Obtained data show that radionuclide content in different clay products can differ up to five times. However, determined activity index values for all tested materials, except fireproof bricks, were below radionuclide concentration level permitted by EU and Latvian national regulations. Comparison with analogous data from other North Europ…
Preparation of polyelectrolyte-modified membranes for heavy metal ions removal
2017
ABSTRACTPolyethersulfone membranes were modified by polyelectrolyte (PE) multilayers, made of poly(allylamine hydrochloride) with poly(styrene sulfonate), to remove Cu2+, Zn2+ and Ni2+ heavy metal cations from aqueous solutions in a wide range of metal concentration (50–1200 ppm). After characterization of the modified membranes, the efficiency of the process was estimated for single heavy metal ions solution leading to high rejection rates (>90% for 50 ppm) and good adsorption capacities (7.0–8.5 mg cm−2) whatever the metal ion tested. The stability in time of the modified membranes was proved by repeating successive filtrations with the same membrane. The filtration process was also used …
Laboratory measurements and astronomical search for the HSO radical
2016
[Context] Despite the fact that many sulfur-bearing molecules, ranging from simple diatomic species up to astronomical complex molecules, have been detected in the interstellar medium, the sulfur chemistry in space is largely unknown and a depletion in the abundance of S-containing species has been observed in the cold, dense interstellar medium. The chemical form of the missing sulfur has yet to be identified.