Search results for "Oxide"

The effect of Mo and Ge reactive elements on high-temperature oxidation of higher manganese silicide

2021

Abstract Higher manganese silicide (HMS) alloys (Mnx-αMoαSiy-βGeβ (x = 0.99–1.011, α = 0.005–0.02, y = 1.75, β = 0.005–0.01)) were studied to elucidate the effect of Mo and Ge pertaining to oxidation. Oxidation experiments were conducted using thermogravimetry and characterized using x-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM). Isoconversion experiments below 450 °C, shows that doping (up to 2 at%) raises the oxidation potential of HMS. Isothermally, the oxidation rate reduces buy one order of magnitude by doping on Mn and/or Si sites from 0.5 to 2 at%, revealing that the dopants-based oxides do not lessen the robustness of SiO2 oxide.

REAL-TIME MEASUREMENT OF VOLCANIC GASES BASED ON INFRARED SPECTROSCOPY

The interpretation of volcanic gas datasets offers key information to build/validate geological models relevant to a variety of volcanic processes and behaviours, including eruptions. Major efforts have therefore been spent in recent years to improve our ability to measure volcanic gas compositions and fluxes. In the last decades, near-infrared room-temperature diode lasers, though in an experimental phase, are finding applications in volcanic gas studies. In this PhD dissertation, I use the GasFinder 2.0, a commercial tunable diode infrared laser transmitter-receiver unit, operating in the 1.3-1.7 m wavelength range, in the attempt to measure CO2 mixing ratios and fluxes in volcanic gas e…

Nanofilm metal layers as vacuum quality sensors

2010

Abstract A monitoring device for vacuum quality is realized by lowest cost single use oxygen sensors for vacuum insulation panels. They use the pressure dependence of oxide layer growth thickness on electrically measured metal nanofilms. These films were manufactured by e-beam evaporation, characterized in terms of resistance change with subsequent modeling of underlying mechanisms.

Correlation between oxidation states of transition metal ions and variation of the coercivity in mixed-valence defect spinel ferrites

1997

Abstract Due to the very high dispersion of mixed-valence spinel ferrites prepared by ‘soft chemistry’ it becomes possible to oxidize in the spinel lattice, not only ferrous ions but also different transition metal ions (Cr 3+ , Mn 2+ , Mn 3+ , Mo 3+ , Mo 4+ V 2+ , V 3+ , Cu + ), by ‘soft’ oxidation between 150 and 500°C, under formation of non-stoichiometric spinels cation vacancies. The oxidation state with the coordination and the oxidation temperature of the cations have been determined in coppermanganese ferrites by derivative thermogravimetry (DTG), based on the specific solid-state reactivity of cations in the redox reaction. For Co-modified non-stoichiometric spinels, which present…

Electronic structure of EuO spin filter tunnel contacts directly on silicon

2011

We present an electronic structure study of a magnetic oxide/ semiconductor model system, EuO on silicon, which is dedicated for efficient spin injection and spin detection in silicon-based spintronics devices. A combined electronic structure analysis of Eu core levels and valence bands using hard X-ray photoemission spectroscopy was performed to quantify the nearly ideal stoichiometry of EuO “spin filter” tunnel barriers directly on silicon, and the absence of silicon oxide at the EuO/Si interface. These results provide evidence for the successful integration of a magnetic oxide tunnel barrier with silicon, paving the way for the future integration of magnetic oxides into functional spintr…

Interaction of valproic acid and some analogues with microsomal epoxide hydrolase.

1992

Abstract Valproic acid (VPA) and its analogues valpromide (VPM), valproyl-Coenzyme A (VP-CoA) and valproyl-ethylester (VPE) were examined as potential inhibitors of microsomal epoxide hydrolase (mEHb) using styrene-7,8-oxide (STO) and benzo(a)pyrene-4,5-oxide (BPO) as enzyme substrates. The effect of each potential inhibitor was examined using mEHb from rat liver, human livers (from a child, woman and man) and from human placenta. Of the compounds tested, only VPM (2 mM) expressed significant inhibition of mEHb activity with a maximum inhibition of 49%, 48%, 35% and 33% for liver microsomes from the child, woman, man and rat, respectively, using STO (2 mM) as substrate. Human placenta mEHb …

Valpromide is a poor inhibitor of the cytosolic epoxide hydrolase

1989

The effect of the antiepileptics valpromide and sodium valproate on the cytosolic epoxide hydrolase was studied in human fetal liver, kidneys and adrenals and from human adult liver and kidneys. Trans-stilbene oxide was used as substrate. Valpromide (10 mM) lowered the activity of the epoxide hydrolase to one half of the control in all organs studied. Sodium valproate (10 mM) was less powerful as an inhibitor than valpromide; however, it exerted a significant inhibition in all tissues studied.

Photo-polymerized lauryl methacrylate monolithic columns for CEC using lauroyl peroxide as initiator

2009

Lauryl methacrylate (LMA)-ester based monolithic columns photo-polymerized using lauroyl peroxide (LPO) as initiator were prepared, and their morphological and CEC properties were studied. The composition of the polymerization mixture (i.e. ratios of monomers/porogenic solvents, 1,4-butanediol/1-propanol and LMA/crosslinker) was optimized. The morphological and chromatographic properties of LMA columns were evaluated by means of SEM pictures and van Deemter plots of PAHs, respectively. The polymerization mixture selected as optimal provided a fast separation of a mixture of PAHs with excellent efficiencies (minimum plate heights of 8.9-11.1 μm). Satisfactory column-to-column (RS D < 4.5%) a…

Comparison on photo-initiators for the preparation of methacrylate monolithic columns for capillary electrochromatography.

2010

The synthesis of lauryl methacrylate monoliths for capillary electrochromatography by UV polymerization using several free-radical initiators (alpha,alpha'-azobisisobutyronitrile, 2,2-dimethoxy-2-phenylacetophenone, dibenzoyl peroxide (BPO) and lauroyl peroxide (LPO)) has been investigated. Using a 1,4-butanediol/1-propanol mixture as porogenic solvent, the influence of each initiator and its content on the morphological and electrochromatographical properties of beds was evaluated. Under their respective optimum content, satisfactory separations of a test mixture of PAHs with similar efficiencies (minimum plate heights of 8.0-12.7 microm obtained from Van Deemter plots) were achieved for t…

Synthesis, structural studies and reactivity of vanadium complexes with tridentate (OSO) ligand

2007

The direct reaction between [VCl(3)(thf)3] or [VO(OEt)3] and 2,2'-thiobis{4-(1,1,3,3-tetramethyl-butyl)phenol (tbopH(2)) leads to the formation of [V(2)(micro-tbop-kappa(3)O,S,O)2Cl(2)(CH(3)CN)(2)] (1).4CH(3)CN or [V(2)(micro-OEt)2(O)2(tbop-kappa(3)O,S,O)2] (2), respectively, in high yield. Compounds 1 and 2 were characterized by chemical and physical techniques including X-ray crystallography and variable temperature magnetic susceptibility studies (J = -29.1 cm(-1)) for 1. Complexes 1 and 2 were supported on MgCl2 and when activated with aluminium alkyls, were found to effectively polymerize ethene to produce polyethylene with a narrow molecular weight distribution M(w)/M(n) approximately…