Search results for "PHOTOELECTRON"

N-Doped Anatase/Rutile Photocatalysts for the Synthesis of Aromatic Aldehydes Under Ultraviolet and Solar Irradiation

2015

N-doped anatase/rutile photocatalysts were prepared by a sol-gel method, using TiCl4 as TiO2 precursor and urea as N-dopant source. The catalysts required a thermal treatment at temperature higher than 300 degrees C to achieve actual nitrogen doping; this treatment also allowed obtaining crystalline and hydrophobic samples. Moreover, nitrogen doping modified the surface of samples by increasing the anatase to rutile phase ratio and hydrophilicity. The catalysts were characterized by BET specific surface area, XRD, ESEM, TGA, FT-IR, DRS and XPS measurements, with particular attention to the assessment of the N-doping effect. It was found that XPS analysis should be used together with DRS and…

Changes in surface stress, morphology and chemical composition of silica and silicon nitride surfaces during the etching by gaseous HF acid

2007

Abstract HF acid attack of SiO2 and Si3N4 substrates is analyzed to improve the sensitivity of a sensor based on microcantilever. Ex situ analysis of the etching using XPS, SIMS and AFM show significant changes in the anisotropy and the rate of the etching of the oxides on SiO2 and Si3N4 surface. Those differences influence the kinetic evolution of the plastic bending deflection of the cantilever coated with SiO2 and Si3N4 layer, respectively. The linear dependence between the HF concentration and the Si3N4 cantilever bending corresponds to a deep attack of the layer whereas the non-linear behavior observed for SiO2 layer can be explained by a combination of deep and lateral etching. The ca…

Interaction of Gold with Co-Condensed and Grafted HMS-SH Silica: A 29Si {1H} CP-MAS NMR Spectroscopy, XRD, XPS and Au LIII EXAFS Study

2010

Hexagonal mesoporous silica (HMS) is functionalised with mercaptopropyl groups by adopting two different procedures ; co-condensation and grafting. In both cases tetraethylorthosilicate (TEOS) and 3-mercaptopropyltriethoxysilane (3-MPTES) are used as the silicon and sulfur precursors, respectively. The obtained materials are analysed by several techniques such as N 2 sorption, TG-DTA, XRD, SAXS and-solid state 29 Si { 1 H} CP-MAS NMR spectroscopy. By taking advantage of the chemical interaction between gold and the -SH groups, the effect of the thiol addition procedure on the supporting capability of the functionalised silica is evaluated by depositing gold through the incipient wet impregn…

Deconvolution of XPS spectra

1991

The resolution of XPS spectra is limited mainly by instrumental parameters like the spectral line width of the exciting X-ray source and the finite energy resolution of the electron analyzer. If the line broadening functions resulting from the instrumental setup can be estimated and expressed by a spectrometer function, a mathematical recalculation of the intrinsic signal is possible by deconvolution. With the method presented in this paper, a resolution enhancement by a factor of 3 can be obtained. Measured spectra of physically correlated spin orbit doublets have been deconvoluted, and it is shown, that the intensity ratios and the positions are comparable with results obtained by highly …

Adsorbates on thin iron(100) films

1995

The electronic and magnetic properties of different kinds of adsorbates on thin magnetized Fe(100) films have been investigated by means of spin resolving photoelectron spectroscopy. The study has been carried out with atomically physisorbed xenon, the molecule carbon monoxide, and metallic gold. The spin splitting of the Xe 5p signal can be explained by magnetic interactions with the final ionic hole state. By spin analysis, it could be shown that at room temperature for low exposures the adsorption of CO is dissociative and with increasing exposure additionally molecular. The Au related features for the monolayer show different line shapes in both spin channels but no splittings due to an…

2019

Energy-level alignment at organic-metal interfaces plays a crucial role for the performance of organic electronic devices. However, reliable models to predict energetics at strongly coupled interfaces are still lacking. We elucidate contact formation of 1,2,5,6,9,10-coronenehexone (COHON) to the (1 1 1)-surfaces of coinage metals by means of ultraviolet photoelectron spectroscopy, x-ray photoelectron spectroscopy, the x-ray standing wave technique, and density functional theory calculations. While for low COHON thicknesses, the work-functions of the systems vary considerably, for thicker organic films Fermi-level pinning leads to identical work functions of 5.2 eV for all COHON-covered meta…

Studies of Molecular Orientation and Order in Self-Assembled Semifluorinated n-Alkanethiols:  Single and Dual Component Mixtures

1997

The structure, orientation and morphology of self-assembled monolayers of a semifluorinated n-alkanethiol, F(CF2)8(CH2)11SH (F8H11SH), have been investigated by polarized IR, angular dependent XPS, ToF-SIMS, contact angle, and ellipsometric measurements. The orientation of the all trans hydrocarbon segment was found to be tilted much less from the surface normal than the 30° tilt found for octadecanethiol. This has been attributed to the steric constraints imposed by the larger cross section fluorocarbon helices that subsequently are tilted from the surface normal. In addition, studies of dual component mixtures of F8H11SH/F8SH and F8SH/F8H2SH have revealed that competitive adsorption occur…

Supported iridium catalysts for the total oxidation of short chain alkanes and their mixtures: Influence of the support

2021

13 figures, 3 tables.-- Supplementary information available.-- © 2020. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/

Epitaxial growth of molybdenum on TiO2(110)

2003

Abstract Molybdenum was deposited on blue (i.e. non-stoichiometric) TiO2(1 1 0) surface using a very low deposition rate (less than 0.05 eqML min−1). The resulting deposit was investigated by means of X-ray photoelectron diffraction (XPD), LEED and XPS. Just after deposition, the film is mainly constituted of metallic molybdenum, contains oxygen homogeneously dispersed through the whole deposit and the broad features detected in XPD scans are interpreted as a coarse epitaxy between TiO2(1 1 0) surface and the (0 0 1) face of bcc molybdenum. The orientation relationship is: Mo(1 0 0)[0 0 1]//TiO2(1 1 0)[0 0 1]. After annealing the deposit at 673 K, XPD scans become sharper and epitaxy is ach…

Oxidation State and Local Structure of Chromium Ions in LaOCl

2021

This research is funded by the Latvian Council of Science, project “Novel transparent nanocomposite oxyfluoride materials for optical applications”, project No. LZP-2018/1-0335. Institute of Solid State Physics, University of Latvia as the Center of Excellence has received funding from the European Union’s Horizon 2020 Framework Programme H2020-WIDESPREAD-01-2016-2017- TeamingPhase2 under grant agreement No. 739508, project CAMART2.