Search results for "PREP"
showing 10 items of 1334 documents
Fourier-transform infrared determination of nicotine in tobacco samples by transmittance measurements after leaching with CHCl3
1998
Abstract A new procedure is proposed for the FT-IR spectrometric determination of nicotine in tobacco. The method is based on the extraction of nicotine in CHCl 3 from tobacco samples, wetted with an aqueous solution of NH 3 (0.1 M), and the measurement of absorbance in the stopped-flow mode at 1316 cm −1 , using a spectral baseline correction established from 1334 to 1300 cm −1 . The procedure developed does not requires a complex sample preparation, and provides a limit of detection of 0.045 mg ml −1 nicotine, a sampling frequency of 3.3 h −1 and a coefficient of variation of 0.3% for five independent measurements of a tobacco sample with a nicotine content of 1.5% w/w. The accuracy of th…
Determination of 129I/127I isotope ratios in liquid solutions and environmental soil samples by ICP-MS with hexapole collision cell
2003
The determination of I-129 in environmental samples at ultratrace levels is very difficult by ICP-MS due to a high noise caused by Xe impurities in argon plasma gas (interference of Xe-129(+)), possible (IH2+)-I-127 interference and an insufficient abundance ratio sensitivity of the ICP mass spectrometer for I-129/I-127 isotope ratio measurement. A sensitive, powerful and fast analytical technique for iodine isotope ratio measurements in aqueous solutions and contaminated soil samples directly without sample preparation using ICP-MS with a hexapole collision cell (ICP-CC-QMS) was developed. Oxygen is used as reaction and carrier gas for iodine thermal desorption via the gas phase from solid…
Flow injection flame atomic absorption analysis of Fe and Mn in cement samples
1993
A new procedure has been developed for the determination of Fe and Mn in cements. It consists in dispersing 50 mg of the solid sample in 25 ml of 0.15 mol/l HNO3 and 0.12 mol/l HCl solution. Acid slurries are heated at 50°C for 10 min and then different volumes of the slurry are injected into a water carrier stream. This previous acid treatment leaches the elements to be determined and permits the use of acid solutions as standards. For the Mn determination, the use of a single line flow injection manifold provides a limit of detection of 0.03 mgl−1 and a dynamic range up to 6 mgl−1. For the determination of Fe, the on-line dispersion of samples, using a well stirred mixing chamber, increas…
Optimization of a microwave-assisted extraction large-volume injection and gas chromatography–ion trap mass spectrometry procedure for the determinat…
2006
Abstract A sensitive and rapid method for the determination of polybrominated diphenyl ethers (PBDEs), polybrominated biphenyls (PBBs) and polychlorinated naphthalenes (PCNs) in sediment samples is proposed. The method involving microwave-assisted extraction (MAE) and large-volume injection (LVI) gas chromatography (GC)–ion trap mass spectrometry (ITMS), and the experimental conditions were optimized using the statistical design of experiments (DOE). A Plackett–Burman (P–B) design was chosen to estimate the influence of five factors, such as resonance excitation voltage (EV), isolation time (IT), excitation time (ET), ion source temperature (IST) and electron energy (EE) on the analytical r…
Determination of fungicide residues in fruits and vegetables by liquid chromatography–atmospheric pressure chemical ionization mass spectrometry
2002
Abstract A liquid chromatography (LC) method for the quantitative determination of five fungicide residues (dichloran, flutriafol, o -phenylphenol, prochloraz and tolclofos methyl) in oranges, lemons, bananas, peppers, chards and onions is described. The residues were extracted by matrix solid-phase dispersion (MSPD) using C 8 . Quantitative analysis was performed by isocratic LC coupled to quadrupole mass spectrometer using atmospheric pressure chemical ionization in the negative ionization mode. The limit of quantification was 0.01 mg kg −1 for flutriafol, o -phenylphenol and dichloran, and 0.1 mg kg −1 for prochloraz and tolclofos methyl. The MSPD method is also suitable for LC–UV analys…
Improvement of the detection limit for determination of 129I in sediments by quadrupole inductively coupled plasma mass spectrometer with collision c…
2004
The previously developed sample introduction device for the hot extraction of iodine from environmental samples (soils or sediments) and on-line introduction of analyte via the gas phase in quadrupole inductively coupled plasma mass spectrometry with hexapole collision cell (ICP-CC-QMS) was equipped with a cooling finger, which allowed intermediate iodine enrichment and improved the detection limits for I-129 down to 0.4 pg g(-1) without any additional sample preparation. A mixture of oxygen and helium as reaction gases in the hexapole collision cell was used for reducing the disturbing background intensity of Xe-129(+). Oxygen was also used as the carrier gas for iodine thermal desorption …
On-line microwave oven digestion flame atomic absorption analysis of solid samples
1990
Abstract A manifold has been developed for on-line microwave oven digestion and flame atomic absorption spectrometric (FAAS) determination of metallic elements in solid samples. The use of a closed flow system permits sample treatment before analysis by FAAS, the direct injection of slurries avoids a filtration step and the interconnection of two conventional rotary injection valves allows the rapid introduction of samples and standards. The determination of lead in sewage sludge was employed as a test system for the proposed on-line sample digestion manifold. The procedure has a limit of detection of 0.2 μg Pb g−1.
Improved technique for quantitative EDXRF analysis of powdered plant samples
1998
An improved technique for energy-dispersive x-ray fluorescence analysis of powdered plant samples is presented. It is based on the use of a special rotating and moveable sample holder (RMSH). This sample holder provides both controlled rotation and lateral transfer movements of the sample while a measurement is carried out, consequently simulating homogeneous excitation conditions over the sample. In this way it compensates for effects caused by the typical inhomogeneous distribution of intensity within the x-ray beam exciting the elements in the sample. The sample consists of powdered dry plant material deposited in an easy way on an adhesive tape, providing a stable layer of plant particl…
Miniaturized matrix solid phase dispersion procedure and solid phase microextraction for the analysis of organochlorinated pesticides and polybromina…
2009
Abstract This work has developed a miniaturized method based on matrix solid phase dispersion (MSPD) using C18 as dispersant and acetonitrile–water as eluting solvent for the analysis of legislated organochlorinated pesticides (OCPs) and polybrominated diphenylethers (PBDEs) in biota samples by GC with electron capture (GC-ECD). The method has compared Florisil®-acidic Silica and C18 as dispersant for samples as well as different solvents. Recovery studies showed that the combination of C18–Florisil® was better when using low amount of samples (0.1 g) and with low volumes of acetonitrile–water (2.6 mL). The use of SPME for extracting the analytes from the solvent mixture before the injectio…
Fishing for a drug: solid-phase microextraction for the assay of clozapine in human plasma
1999
Solid-phase microextraction (SPME) was investigated as a sample preparation method for assaying the neuroleptic drug clozapine in human plasma. A mixture of human plasma, water, loxapine (as internal standard) and aqueous NaOH was extracted with a 100-micron polydimethylsiloxane (PDMS) fiber (Supelco). Desorption of the fiber was performed in the injection port of a gas chromatograph at 260 degrees C (HP 5890; 30 m x 0.53 mm I.D., 1 micron film capillary; nitrogen-phosphorous selective detection). Fibers were used repeatedly in up to about 75 analyses. The recovery was found to be 3% for clozapine from plasma after 30 min of extraction. However, in spite of the low recovery, the analyte was…