Search results for "Permeability"
showing 10 items of 596 documents
Effect of relative humidity on carvacrol release and permeation properties of chitosan based films and coating
2014
International audience; The influence of water vapour conditions on mass transport and barrier properties of chitosan based films and coatings were studied in relation to surface and structural properties. Water contact angles, material swelling, polymer degradation temperature, barrier properties (PO2, PCO2, WVP) and aroma diffusion coefficients were determined. The solvent nature and the presence of carvacrol influenced the surface and structural properties and then the barrier performance of activated chitosan films. Increasing RH from 0% to 100% led to a significant increase in material swelling. The plasticization effect of water was more pronounced at high humid environment, while at …
TOPS-MODE approach for the prediction of blood-brain barrier permeation.
2004
The blood-brain barrier permeation has been investigated by using a topological substructural molecular design approach (TOPS-MODE). A linear regression model was developed to predict the in vivo blood-brain partitioning coefficient on a data set of 119 compounds, treated as the logarithm of the blood-brain concentration ratio. The final model explained the 70% of the variance and it was validated through the use of an external validation set (33 compounds of the 119, MAE = 0.33), a leave-one-out crossvalidation (q(2) = 0.65, S(press) = 0.43), fivefold full crossvalidation (removing 28 compounds in each cycle, MAE = 33, RMSE = 0.43) and the prediction of +/- values for an external test set …
An Experimental Investigation on the Air Permeability of Passive Ventilation Grilles
2015
Abstract The need of increasing both energy saving and acoustic insulation has leaded to the design of lowest air permeability frames resulting in the worsening of indoor air quality. Moreover, sometime in several civil-use existing buildings (i.e. schools or houses, historical buildings) mechanical ventilation systems cannot be installed due to non-removable constraints. In these cases, passive ventilation grilles are a cheap and effective solution for the ventilation. This work deals with an in-depth experimental analysis about the air permeability values measured over a set of passive ventilation grilles available on the market. Obtained results often showed performances very far to thos…
Bacterial Cytolysin Perturbs Round Window Membrane Permeability Barrier In Vivo: Possible Cause of Sensorineural Hearing Loss in Acute Otitis Media
1998
ABSTRACT The passage of radioiodinated streptolysin-O (SLO) and albumin through the round window membrane (RWM) was studied in vivo. When applied to the middle ear, SLO became quantitatively entrapped in this compartment and no passage to the cochlea occurred. However, flux of radioiodinated albumin through the toxin-damaged RWM was observed. We propose that the passage of noxious macromolecules, such as proteases, from a purulent middle-ear effusion may be facilitated by pore-forming toxins, resulting in cochlear damage and sensorineural hearing loss.
Performance of industrial scale hollow-fibre membranes in a submerged anaerobic MBR (HF-SAnMBR) system at mesophilic and psychrophilic conditions
2013
The aim of this work was to evaluate the effect of temperature on the performance of industrial hollow-fibre (HF) membranes treating urban wastewater in a submerged anaerobic MBR system (SAnMBR). To this end, a demonstration plant with two commercial HF ultrafiltration membrane modules (PURON®, Koch Membrane Systems, PUR-PSH31) was operated at 20, 25 and 33 °C. The mixed liquor total solid (MLTS) level was a key factor affecting membrane permeability (K). K was higher under psychrophilic than mesophilic conditions when operating at similar transmembrane fluxes and MLTS, because the biomass activity of the psychrophilic mixed liquor was lower than the mesophilic mixed liquor. Thus, lower ext…
Impact of graphitic carbon nitride nanosheets in mixed- matrix membranes for removal of heavy metals from water
2021
International audience; Removal of heavy metal ions from water is being a challenge and Polysulfone (PSf) membranes have shown great potential to remove them from contaminated solutions. In this work, the introduction of Graphitic carbon nitride nanosheets (g-C3N4) into PSf membranes was implemented to improve the permeability and separation performance of PSf membranes. g-C3N4 was incorporated into the membrane matrix via nonsolvent induced phase inversion method. The prepared mixed matrix membranes showed enhanced performances towards water filtration. The incorporation of g-C3N4 into the membrane matrix caused an increase in the desired physicochemical properties like hydrophilicity and …
Morphometry of micrite particles in cretaceous microporous limestones of the Middle East: influence on reservoir properties.
2011
24 pages; International audience; Microporosity may account for a significant part of the total porosity of Cretaceous limestone reservoirs of the Middle East. In these microporous facies porosity is moderate to excellent (up to 35%) while permeability is poor to moderate (up to 190 mD). Micritic limestones also may form dense layers with very low porosity and permeability values. Micritic samples were collected from three fields of the Habshan and Mishrif Formations, to examine the spatial relationship with their porosity, permeability and pore throat radius distributions. Two key parameters of the micritic particles are studied using scanning electron microscopy: their morphology (shape a…
A guide to the use of pore-forming toxins for controlled permeabilization of cell membranes
1993
Depending on the size of the pores one wishes to produce in plasma membranes, the choice will probably fall on one of the three toxins discussed above. S. aureus alpha-toxin should be tried first when pores of 1-1.5 nm diameter are required. This is generally the case when Ca2+ and nucleotide dependence of a given process is being studied. If alpha-toxin does not work, this is probably due to the fact that the toxin either does not produce pores, or that the pores are too small. In this case, high concentrations of alpha-toxin should be tried. If this still does not work, we recommend the use of HlyA. When very large pores are to be created, e.g. for introduction of antibodies into the cell…
Surface, mechanical and barrier properties of bio-based composite films based on chitosan and whey protein
2014
Mono-component and composite bilayer and blend films composed of chitosan and whey protein were made. Colour, microstructure, water contact angles, swelling, water vapour sorption, barrier properties (oxygen, water vapour), water vapour diffusion coefficients and mechanical properties were determined. The influence of water vapour on barrier properties was studied in relation to the surface and structural properties. Mono-component and bilayer films were transparent with a homogeneous surface. Contrarily, blend films were translucent. Bilayer films had significantly lower water vapour permeability in comparison to mono-component and blend films. In all bilayer films, the air side (chitosan)…
The liquid state of FG-nucleoporins mimics permeability barrier properties of nuclear pore complexes
2019
Nuclear pore complexes form a permeability barrier in vivo that regulates nucleocytoplasmic transport. Here, the authors present a microfluidic device that couples rapid liquid–liquid phase separation of nucleoporins with direct optical interrogation. Freshly formed liquid nucleoporin droplets mimic permeability barrier properties of NPCs.