Search results for "Proton"
showing 10 items of 5886 documents
Advances in Anodic Alumina Membranes-based fuel cell: CsH2PO4 pore-filler as proton conductor at room temperature
2009
Abstract Anodic alumina membranes (AAM) filled with cesium hydrogen phosphate proton conductor have been tested as inorganic composite electrolyte for hydrogen–oxygen thin film (≤50 μm) fuel cell (TFFC) working at low temperatures (25 °C), low humidity ( T gas = 25 °C) and low Pt loading (1 mg cm −2 ). Single module TFFC delivering a peak power of around 15–27 mW cm −2 , with open circuit voltage (OCV) of about 0.9 V and short circuit current density in the range 80–160 mA cm −2 have been fabricated. At variance with pure solid acid electrolytes showing reproducibility problems due to the scarce mechanical resistance, the presence of porous alumina support allowed to replicate similar fuel…
Methanol and proton transport through chitosan-phosphotungstic acid membranes for direct methanol fuel cell
2020
Composite chitosan-phosphotungstic acid membranes were synthesized by ionotropic gelation. Their liquid uptake is higher for thin membranes (23 ± 2 μm), while it is lower (~70%) for thicker membranes (50-70 μm). Polarization curves recorded using single module fuel cell at 70°C allowed to estimate a peak power density of 60 mW cm−2 by using 1 M as methanol and low Pt and Pt/Ru loadings (0.5 and 3 mg cm−2) at the cathode and at the anode, respectively. Electrochemical impedance spectroscopy was used to estimate the membrane conductivity and to model the electrochemical behavior of methanol electrooxidation inside the fuel cell revealing a two-step mechanism mainly responsible of overall kine…
Cross-linked PEEK-WC proton exchange membrane for fuel cell
2009
Abstract The low cost proton exchange membrane was prepared by cross-linking water soluble sulfonated-sulfinated poly(oxa- p -phenylene-3,3-phthalido- p -phenylene-oxa- p -phenylene-oxy-phenylene) (SsPEEK-WC). The prepared cross-linked membrane became insoluble in water, and exhibited high proton conductivity, 2.9 × 10 −2 S/cm at room temperature. The proton conductivity was comparable with that of Nafion ® 117 membrane (6.2 × 10 −2 S/cm). The methanol permeability of the cross-linked membrane was 1.6 × 10 −7 cm 2 /s, much lower than that of Nafion ® 117 membrane.
Covalent-ionically cross-linked polyetheretherketone proton exchange membrane for direct methanol fuel cell
2010
Abstract In this paper, the proton exchange membrane prepared by covalent-ionically cross-linking water soluble sulfonated–sulfinated poly(oxa- p -phenylene-3,3-phthalido- p -phenylene-oxa- p -phenylene-oxy-phenylene) (SsPEEK-WC) is reported. Compared with covalent cross-linked PEEK-WC membrane, this covalent-ionically cross-linked PEEK-WC membrane exhibits extremely reduced water uptake and methanol permeability, but just slightly sacrificed proton conductivity. The proton conductivity of the covalent-ionically cross-linked PEEK-WC membrane reaches to 2.1 × 10 −2 S cm −1 at room temperature and 4.1 × 10 −2 S cm −1 at 80 °C. The methanol permeability is 1.3 × 10 −7 cm 2 s −1 , 10 times …
Fuel cell modelling and test: Experimental validation of model accuracy
2013
In the last few years, renewable energies have been encouraged by worldwide governments to meet energy saving policies. Among renewable energy sources, fuel cells have attracted much interest for a wide variety of research areas. Fuel cell-based residential-scaled power supply systems take advantage of simultaneous generation of power and heat, reducing the overall fossil fuel consumption and utilities cost. Modeling is one of the most important topics concerning fuel cell use. In this paper, a measurement-based steady-state and dynamic fuel cell model is presented. The proposed modelling approach is implemented on a 5kW Proton Exchange Membrane Fuel Cell. The parameters identification proc…
MATLAB-based simulator of a 5 kW fuel cell for power electronics design
2013
Abstract In the last few years, renewable energies have been encouraged by worldwide governments to meet energy saving policies. Among renewable energy sources, fuel cells have attracted much interest for a wide variety of research areas. Since combined heat-power generation is allowed, household appliances are still the most promising applications. Fuel cell-based residential-scaled power supply systems take advantage by simultaneous generation of power and heat, reducing the overall fossil fuel consumption and utilities cost. Modelling is one of the most important topic concerning fuel cell use. In this paper, a measurement-based steady-state and dynamic fuel cell model is presented. The …
Calculation of Proton-Deuteron Elastic Scattering at 10 MeV with a Realistic Potential
1998
We present the first results of a calculation of the differential cross section and of polarization observables for proton-deuteron elastic scattering at 10thinspthinspMeV proton laboratory energy, for the Paris potential. The method used is the {open_quotes}screening and renormalization approach{close_quotes} which allows one to correctly take into account the Coulomb repulsion between the two protons. Comparison is made with the precise experimental data of Sagara {ital et al.}thinspthinsp[Phys.thinspthinspRev.thinspthinspC {bold 50}, 576 (1994)] and of Sperison {ital et al.}thinspthinsp[Nucl.thinspthinspPhys.thinspthinsp{bold A422}, 81 (1984)]. {copyright} {ital 1998} {ital The American …
Water Dynamics in Neural Tissue
2013
Water dynamics in post-mortem two-years old bovine cerebral right hemisphere has been investigated through Elastic and Quasi-elastic Neutron Scattering. Experimental parameters such as stability in time of the proton dynamics, data reproducibility and changes in the tissues dynamics upon the conservation protocol, cryogenic towards formalin addition, have been carefully investigated. Results are extremely encouraging and comparisons to magnetic resonance imaging findings are discussed.
Annihilation at rest of antiprotons and protons into neutral particles
2003
Abstract Annihilation of antiprotons and protons at rest into neutral particles has been studied with the Crystal Barrel detector at LEAR. Annihilation frequencies are determined for final states containing π 0 , η , η ′ and ω mesons using a liquid and a room temperature, 12 bar, gaseous hydrogen target. Including annihilation frequencies for production of neutral kaons from other experiments, the identified reactions for annihilation in liquid hydrogen add up to a branching fraction of (3.56±0.28)% per annihilation compared to the frequency of (3.50±0.30)% with which we observe the all-neutral decay modes inclusively. Since the exclusive final states are normalized to the Crystal Barrel me…
Proton Transfer and Protein Conformation Dynamics in Photosensitive Proteins by Time-resolved Step-scan Fourier-transform Infrared Spectroscopy
2014
Monitoring the dynamics of protonation and protein backbone conformation changes during the function of a protein is an essential step towards understanding its mechanism. Protonation and conformational changes affect the vibration pattern of amino acid side chains and of the peptide bond, respectively, both of which can be probed by infrared (IR) difference spectroscopy. For proteins whose function can be repetitively and reproducibly triggered by light, it is possible to obtain infrared difference spectra with (sub)microsecond resolution over a broad spectral range using the step-scan Fourier transform infrared technique. With -10(2)-10(3) repetitions of the photoreaction, the minimum num…