Search results for "Raman spectroscopy."
showing 10 items of 790 documents
THz nanocrystal acoustic vibrations from ZrO2 3D supercrystals
2013
International audience; We report sharp low-frequency Raman spectral features of supercrystals synthesized via the "benzyl alcohol route" and consisting of either yttrium-stabilized or pure zirconia (ZrO2) nanocrystals. In situ formed benzoate species control the nanocrystal growth and act as organic glue leading to the assembly of the nanocrystals in highly ordered 3D supercrystals. We attribute some Raman peaks to THz acoustic vibrations of individual nanocrystals which are only weakly coupled due to the strong acoustic mismatch between the capping ligands and the nanocrystals. Peak positions are consistent with nanocrystal sizes estimated from transmission electron microscopy and X-ray p…
Structural anisotropy and annealing-induced nanoscale atomic rearrangements in metamict titanite
2012
The structural state of metamict titanite was studied by Raman spectroscopy, complementary high-resolution transmission electron microscopy, and single-crystal X-ray diffraction. The results show that Raman scattering collected from metamict titanite is highly anisotropic, which is typical of single crystals. But surprisingly, the observed Raman-scattering dependence on the sample orientation is much more pronounced for heavily metamict than for weakly metamict titanite samples. These radiation-induced anisotropic effects are related to the specific atomic arrangements in metamict titanite. The Raman spectra collected in backscattering geometry from a plane nearly perpendicular to the chain…
A new route to grow oxide nanostructures based on metal displacement deposition. Lanthanides oxy/hydroxides growth
2012
Abstract A metal displacement reaction has been used in order to cause precipitation of oxide nanostructures within pores of anodic alumina membrane (AAM) templates. Here, we focus on the displacement deposition of LnO/OH (Ln = La, Ce, Sm, Er) nanostructures using Zn as sacrificial anode, employing a specific cell arrangement where a galvanic couple was formed between zinc anode and the Au thin layer covering template pore bottom. Progress of displacement deposition reaction into template channels was monitored measuring the open circuit potential as well as pH changes of the electrolyte. A progressive de-activation of the anode surface was observed for long deposition times, caused by depo…
Physicochemical characterization and photoelectrochemical analysis of iron oxide films
2013
Iron oxide films with a nanoporous structure were grown by anodizing sputter-deposited Fe in a fluoride containing ethylene glycol solution and annealed under air exposure at different temperatures. X-ray diffraction and Raman spectroscopy allowed to identify the presence of hematite and/or magnetite after thermal treatment for films annealed at T ≥ 400 °C under air exposure. According to GDOES compositional depth profiles, the thermal treatment sensitively reduced the amount of fluoride species incorporated into the film during the anodizing process. A band gap value of ~2.0 eV was estimated for all the investigated layers, while a flat band potential dependent on both the growth condition…
The influence of thickness, interpore distance and compositional structure on the optical properties of self-ordered anodic aluminum oxide films
2016
Highly ordered anodic aluminum oxide (AAO) films were fabricated using a two-step anodization process in oxalic acid, sulfuric acid, or ethylene glycol containing sulfuric acid, which are important in design of nanostructured optical devices. The morphology and UV-Vis reflectance spectroscopy of these films were analyzed. The morphological parameters of the AAO films, such as the thickness, pore diameter, interpore distance, porosity, pore arrangement regularity, and anodization electrolyte, were adjusted in order to study the effect of these parameters on the UV-Vis reflectance properties of these films. Raman spectroscopy measurements were then utilized to better understand the chemical d…
High-pressure Raman investigation of high index facets bounded alpha-Fe2O3 pseudocubic crystals
2021
[EN] High index facet bounded alpha-Fe2O3 pseudocubic crystals has gained the attention of the scientific community due to its promising electrochemical sensing response towards aqueous ammonia. The structural stability of alpha-Fe2O3 pseudocubic crystals is investigated through high-pressure Raman spectroscopy up to 22.2 GPa, and those results are compared with our ab initio theoretical calculations. The symmetry of the experimental Raman-active modes has been assigned by comparison with theoretical data. In addition to the Raman-active modes, two additional Raman features are also detected, whose intensity increases with compression. The origin of these two additional peaks addressed in t…
Polarized multiplex coherent anti-Stokes Raman scattering using a picosecond laser and a fiber supercontinuum
2011
International audience; We perform multiplex coherent anti-Stokes Raman scattering (CARS) micro-spectroscopy with a picosecond pulsed laser and a broadband supercontinuum (SC) generated in photonic crystal fiber. CARS signal stability is achieved using an active fiber coupler that avoids thermal and mechanical drifts. We obtain multiplex CARS spectra for test liquids in the 600–2000 cm−1 spectral range. In addition we investigate the polarization dependence of the CARS spectra when rotating the pump beam linear polarization state relative to the linearly polarized broad stokes SC. From these polarization measurements we deduce the Raman depolarization ratio, the resonant versus nonresonant …
Chalcogenide Glasses Based on Germanium Disulfide for Second Harmonic Generation
2007
International audience; High second-order susceptibilities are created by thermal poling in bulk germanium disulfide based chalcogenide glasses. Experimental conditions of the poling treatment (temperature, voltage, time) were optimized for each glass composition. The second-order nonlinear signals were recorded by using the Maker fringes experiment and a second-order coefficient χ(2) up to 8 pm V-1 was measured in the Ge25Sb10S65 glass. This value is obtained using a simulation based on accurate knowledge of the thickness of the nonlinear layer. Two mechanisms are proposed to explain the creation of a nonlinear layer under the anode: the formation and the migration of charged defects towar…
Resonant Raman characterization of InAlGaN/GaN heterostructures
2006
InAlGaN/GaN heterostructures and thin films with In composition ranging from 0.03 to 0.1 are characterized by means of Raman scattering excited at various energies in the ultra violet range, tuning the laser excitation energy through the band gap of In x Al y Ga 1-x-y N. It is shown that the addition of In to the Al y Ga 1-y N alloy diminishes considerably the vibration energy of the A 1 (LO) phonon mode. The phonon line is asymmetric on the low energy side, and the asymmetry increases with In content, while the main peak shifts to lower energies. A shift of the phonon energy has also been observed when the excitation energy is close to the absorption edge of the In x Al y Ga 1-x-y N layer.…
Growth zoning and strain patterns inside diamond crystals as revealed by Raman maps
2005
The Raman mapping technique provides a non-destructive means of studying internal growth textures and other micro-structural heterogeneity inside diamond single-crystals. Raman maps showing distribution patterns of the bandwidth (FWHM) of the main first-order lattice vibration of diamond ( LO=TO phonon at ~1332 cm −1 ) along two-dimensional planes inside diamond crystals may reveal the internal growth zoning of these crystals. The observed zoning is affected, and in some cases even obscured in micro-areas adjacent to inclusions, by patterns of heterogeneous strain in the diamond. We present Raman maps obtained from diamond crystals containing large, single-crystal graphite inclusions, from …