Search results for "Raman spectroscopy."
showing 10 items of 790 documents
Reactive direct current magnetron sputtered TiO2 thin films with amorphous to crystalline structures.
2008
International audience; TiO2 thin films were deposited on soda–lime glass substrates by reactive direct current magnetron sputtering in a mixture of pure argon and oxygen. The influence of both the deposition time, td, and the post-annealing treatments on the films morphology, composition and structure was analyzed by scanning electron microscopy, ellipsometry, X-ray photoelectrons spectroscopy, X-ray diffraction (XRD) and Raman spectroscopy. Amorphous TiO2 was obtained for the shortest deposition time, td=15 min. Increasing td up to 30 min, poorly crystallized anatase and rutile phases were formed together with amorphous TiO2, as was revealed by complementary XRD patterns and Raman spectra…
Study of surface layers and ejected powder formed by oxidation of titanium substrates with a pulsed Nd:YAG laser beam.
2009
Laser treatment of a titanium surface at certain conditions initiates the formation of titanium oxide layers as well as micro (nano) scale powder ejected from the surface of the substrate. The resultant morphology of the surface as well as the size and the structure of the particles are all strongly dependent on the treatment parameters (laser fluence, pulse frequency, overlap parameter, etc.). In this study, titanium substrates were treated with an industrial pulsed Nd:YAG laser in air, with varying parameters. Surface layers and ejected materials were compared using scanning and transmission electron microscopy, X-ray diffraction and Raman spectroscopy. The rutile phase of TiO(2) dominate…
Pulsed laser growth and characterization of thin films on titanium substrates
2007
Abstract Colored layers were obtained by laser surface treatment of Ti substrates with a pulsed Nd:YAG Q-switched laser. The changes in the morphology, structure and chemical composition of the layers were studied by SEM, EDS, XPS, SIMS and Raman spectroscopy as a function of the laser fluence in the 4–60 J cm −2 . For laser fluences lower than 25 J cm −2 , the layers are colorless or yellow. Their surface is smooth, but they display cracks which increase when the fluence increases. The O/Ti ratio, determined by XPS analysis, varies from 0.7 (colorless layers) to 1.3 (yellow layer). Moreover, XPS spectra evidence non-negligible amounts of nitrogen and carbon in these layers. Raman spectra s…
One-Dimensional TiO2-B Crystals Synthesised by Hydrothermal Process and Their Antibacterial Behaviour on Escherichia coli
2016
We have successfully synthesised one-dimensional single crystals of monoclinic phase titanium dioxide nanostructures (TiO2-B), prepared by a hydrothermal process. Morphological characterization was carried out by atomic force and scanning and transmission electron microscopy techniques. In order to study the crystalline structure, samples were calcined at 500°C in an air-filled chamber. X-ray diffraction results indicated that as-prepared samples presented diffraction patterns of hydrate hydrogen titanate and those calcined at 500°C exhibited the TiO2-B and anatase phases, confirmed by Raman spectroscopy. Scanning electron microscopy results showed that the one-dimensional nanostructures ha…
Optical and Acoustic Vibrations Confined in Anatase TiO2 Nanoparticles under High-Pressure
2014
International audience; The effect of an applied high pressure on the optical and acoustic vibrations of small anatase TiO2 nanoparticles is studied using Raman scattering. All the Raman peaks show a significant variation of their frequency with pressure, except for the low-frequency peak which is due to acoustic vibrations confined in the nanoparticles. These variations (or lack thereof) are compared to first-principles calculations of the stiffness tensor and phonons of bulk anatase TiO2 as a function of pressure. In particular, the variation of the shape of the low-frequency peak is explained by the increase of the elastic anisotropy of anatase TiO2 as pressure is increased.
BN/GdxTi(1-x)O(4-x)/2 nanofibers for enhanced photocatalytic hydrogen production under visible light
2019
Abstract BN/GdxTi(1-x)O(4-x)/2 nanofibers were elaborated via electrospinning technique. The properties of the prepared nanofibers were controlled using different ratios of gadolinium. All the prepared nanofibers exhibit the tetragonal structure of anatase TiO2 phase. An increase in the unit cell volume and a decrease in the crystallite size were observed with increasing the doping amount of Gd3+ as revealed by Rietveld refinement analysis. The defect in TiO2 lattice was observed by Raman. The Gd3+ incorporation inside TiO2 lattice, which is accompanied by the creation of Ti-O-Gd bond, was characterized by the X-ray photoelectron spectra. Scanning electron microscopy demonstrates that the a…
TiO2 anatase films obtained by direct liquid injection atomic layer deposition at low temperature
2014
International audience; TiO2 thin films were grown by direct liquid injection atomic layer deposition (DLI-ALD) with infrared rapid thermal heating using titanium tetraisopropoxide and water as precursors. This titanium tetraisopropoxide/water process exhibited a growth rate of 0.018 nm/cycle in a self-limited ALD growth mode at 280 degrees C. Scanning electron microscopy and atomic force microscopy analyses have shown a smooth surface with a low roughness. XPS results demonstrated that the films were pure and close to the TiO2 stoichiometric composition in depth. Raman spectroscopy revealed that the films were crystallized to the anatase structure in the as-deposited state at low temperatu…
Preparation and Characterization of Nanostructured Fe-TiO2 Thin Films Produced by Electrophoretic Deposition
2013
Fe-TiO2 thin films have been produced by a sol-electrophoretic deposition method on metallic Ti foil substrates. X-ray diffractograms and Raman spectra confirms the anatase structure of deposited and annealed Fe-TiO2 films. Obtained Fe-TiO2 thin films demonstrate photoactivity under visible light radiation due to the doping with Fe3+ ions. Open circuit potential results shows that increase of the film thickness and surface area improves the photoactivity of Fe-TiO2.
Effect of Reynolds number and lithium cation insertion on titanium anodization
2016
This work studies the influence of using hydrodynamic conditions (Reynolds number, Re = 0 to Re = 600) during Ti anodization and Li+ intercalation on anatase TiO2 nanotubes. The synthesized photocatalysts were characterized by using Field Emission Scanning Electron Microscope (FE-SEM), Raman Confocal Laser Microscopy, Electrochemical Impedance Spectroscopy (EIS), Mott-Schottky analysis (M-S), photoelectrochemical hydrogen production and resistance to photocorrosion tests. The obtained results showed that the conductivity of the NTs increases with Li+ intercalation and Re. The latter is due to the fact that the hydrodynamic conditions eliminate part of the initiation layer formed over the tu…
Original Approach to Synthesize TiO2/ZnO Hybrid Nanosponges Used as Photoanodes for Photoelectrochemical Applications
2021
[EN] In the present work, TiO2/ZnO hybrid nanosponges have been synthesized for the first time. First, TiO2 nanosponges were obtained by anodization under hydrodynamic conditions in a glycerol/water/NH4F electrolyte. Next, in order to achieve the anatase phase of TiO2 and improve its photocatalytic behaviour, the samples were annealed at 450 degrees C for 1 h. Once the TiO2 nanosponges were synthesized, TiO2/ZnO hybrid nanosponges were obtained by electrodeposition of ZnO on TiO2 nanosponges using different temperatures, times, and concentrations of zinc nitrate (Zn(NO3)(2)). TiO2/ZnO hybrid nanosponges were used as photoanodes in photoelectrochemical water splitting tests. The results indi…