Search results for "STABILITY"

showing 10 items of 3085 documents

Magnetic Direct-Write Skyrmion Nanolithography

2020

Magnetic skyrmions are stable spin textures with quasi-particle behavior and attract significant interest in fundamental and applied physics. The metastability of magnetic skyrmions at zero magnetic field is particularly important to enable, for instance, a skyrmion racetrack memory. Here, the results of the nucleation of stable skyrmions and formation of ordered skyrmion lattices by magnetic force microscopy in (Pt/CoFeSiB/W)n multilayers, exploiting the additive effect of the interfacial Dzyaloshinskii-Moriya interaction, are presented. The appropriate conditions under which skyrmion lattices are confined with a dense two-dimensional liquid phase are identified. A crucial parameter to con…

Condensed Matter::Quantum GasesPhysicsApplied physicsCondensed matter physicsSkyrmionHigh Energy Physics::PhenomenologyGeneral EngineeringNucleationGeneral Physics and Astronomy02 engineering and technologyCondensed Matter::Mesoscopic Systems and Quantum Hall Effect010402 general chemistry021001 nanoscience & nanotechnology01 natural sciences0104 chemical sciencesMagnetic fieldNanolithographyLattice (order)MetastabilityGeneral Materials ScienceMagnetic force microscope0210 nano-technologyNonlinear Sciences::Pattern Formation and SolitonsACS Nano
researchProduct

Photoassociative production and trapping of ultracold KRb molecules.

2004

We have produced ultracold heteronuclear KRb molecules by the process of photoassociation in a two-species magneto-optical trap. Following decay of the photoassociated KRb*, the molecules are detected using two-photon ionization and time-of-flight mass spectroscopy of KRb$^+$. A portion of the metastable triplet molecules thus formed are magnetically trapped. Photoassociative spectra down to 91 cm$^{-1}$ below the K(4$s$) + Rb (5$p_{1/2}$) asymptote have been obtained. We have made assignments to all eight of the attractive Hund's case (c) KRb* potential curves in this spectral region.

Condensed Matter::Quantum GasesPhysicsAtomic Physics (physics.atom-ph)FOS: Physical sciencesGeneral Physics and AstronomyDiatomic moleculeSpectral linePhysics - Atomic PhysicsHeteronuclear moleculeIonizationMetastabilityMoleculeProduction (computer science)Physics::Atomic PhysicsRotational spectroscopyAtomic physicsPhysical review letters
researchProduct

Persistent currents in a circular array of Bose-Einstein condensates

2002

A ring-shaped array of Bose-Einstein condensed atomic gases can display circular currents if the relative phase of neighboring condensates becomes locked to certain values. It is shown that, irrespective of the mechanism responsible for generating these states, only a restricted set of currents are stable, depending on the number of condensates, on the interaction and tunneling energies, and on the total number of particles. Different instabilities due to quasiparticle excitations are characterized and possible experimental setups for testing the stability prediction are also discussed.

Condensed Matter::Quantum GasesPhysicsParticle numberCondensed matter physicsCondensed Matter (cond-mat)FOS: Physical sciencesCondensed MatterStability (probability)Atomic and Molecular Physics and Opticslaw.inventionCircular bufferlawQuasiparticleRelative phaseAtomic physicsBose–Einstein condensateQuantum tunnellingPhysical Review A
researchProduct

Scaling Behavior in Non-Hookean Compression of Thin-Walled Structures

2010

The mechanics and stability of thin-walled structures is a challenging and important branch in structural mechanics. Under vertical compression the deformation of a thin-walled box differs from that of, e.g., a cylindrical shell. It is demonstrated here that compression of a box can be described by a set of generic scaling laws representing three successive regimes: a linear, wrinkled, and collapsed regime. The linear Hookean regime represents the normal behavior before any instability sets in, while the following wrinkled regime is shown to be analogous to compression of thin-film blisters. The compression force reaches its maximum at the onset of the final collapsed regime that has all th…

Condensed Matter::Soft Condensed MatterPhysics::Fluid DynamicsPhysicsClassical mechanicsDeformation (mechanics)Structural mechanicsShell (structure)General Physics and AstronomyThin walledCompression (physics)ScalingStability (probability)InstabilityPhysical Review Letters
researchProduct

Mechanisms for the Decay of Unstable and Metastable Phases: Spinodal Decomposition, Nucleation and Late-Stage Coarsening

1989

The basic concepts on the kinetics of phase separation in alloys are introduced, and the current status of the theory is briefly reviewed. Particular emphasis is given to questions such as the conditions under which the linearized theory of spinodal decomposition is valid, the significance of spinodal curves, the possible description of coarsening in terms of power laws and structure-factor scaling, and non-equilibrium percolation phenomena.

Condensed Matter::Soft Condensed MatterSpinodalChemistrySpinodal decompositionPercolationMetastabilityNucleationThermodynamicsIsing modelPower lawScaling
researchProduct

Re-entrance phase formation of CeSb thin films

2001

Abstract We report the epitaxial growth of (1 0 0)- and (1 1 1)-oriented CeSb thin films on Al 2 O 3 (1 1 2 0) and (0 0 0 1) substrates by means of molecular beam epitaxy. Depending on the overall Sb-to-Ce flux ratio and the molecular state of Sb x , we observe a re-entrance behavior in the phase formation and orientation of CeSb on Al 2 O 3 (1 1 2 0) . This behavior is shown to exhibit, in some respect, similarities to III–V compound growth, but also more complexities due to the instability of the rare earth component against oxidation. A geometric orientation selection model is suggested which reproduces the observed re-entrance behavior as well as the overall CeSb growth rate.

Condensed matter physicsChemistryStereochemistryHeterojunctionCondensed Matter PhysicsEpitaxyInstabilityPhase formationFlux ratioInorganic ChemistryMaterials ChemistryGrowth rateThin filmMolecular beam epitaxyJournal of Crystal Growth
researchProduct

Pressure induced increase in Tc for the organic-based magnet FeII(TCNE)2 (TCNE=tetracyanoethylene)

2013

Abstract Pressure dependent magnetization and 57Fe Mossbauer studies were performed on Fe(TCNE)[C4(CN)8]1/2·zCH2Cl2 (TCNE = tetracyanoethylene). Pressure did not influence the Mossbauer parameters in paramagnetic state. Mossbauer data reveals the onset of magnetic ordering at 130 K and significant enhancement of the magnetic ordering temperature from 100 to 150 K accompanied by an increase of the spontaneous magnetization, which is higher than reported from the magnetic data, and application of pressure induces the reversible formation of a new, metastable magnetic species. These changes suggest an increase of the dimensionality of magnetic interaction, i.e., stronger interlayer coupling. A…

Condensed matter physicsChemistryTetracyanoethyleneInorganic ChemistryMagnetizationParamagnetismchemistry.chemical_compoundCrystallographyMetastabilityMagnetMössbauer spectroscopyMaterials ChemistryPhysical and Theoretical ChemistrySpontaneous magnetizationNéel temperaturePolyhedron
researchProduct

Frustration of structural fluctuations upon equilibration of shear melts

2002

Abstract We report on the formation of amorphous solids from aquaeous suspensions of charged colloidal spheres. Comprehensive light scattering and microscopic studies show that in these systems the nucleation rate density continuously increases to very high values. At the highest particle densities of 47.5 μm −3 (packing fraction Φ =0.146) an amorphous state is observed of only short range order, finite static shear modulus and frozen long time dynamics. This state is composed of a piling of––as we propose pre-critical––nuclei. Differences from the Hard Sphere case are discussed in some detail. There the arrest of density fluctuations is observed and described by Mode Coupling scenarios. In…

Condensed matter physicsChemistrymedia_common.quotation_subjectNucleationFrustrationHard spheresCondensed Matter PhysicsAtomic packing factorLight scatteringElectronic Optical and Magnetic MaterialsAmorphous solidCondensed Matter::Soft Condensed MatterShear modulusChemical physicsMetastabilityMaterials ChemistryCeramics and Compositesmedia_commonJournal of Non-Crystalline Solids
researchProduct

Proton conducting polymer composites for electrochromic devices

1999

Abstract This report describes composite proton electrolytes composed of nanosize zirconium phosphate or antimonic acid particles suspended in a poly(vinyl acetate)/glycerin gel matrix. The proton conductivity was 10 −3 –10 −4 S/cm at room temperature, thermal stability prevailed up to at least 110°C, and compatibility was found with oxide electrodes; these properties makes the electrolyte suitable for use in solid state electrochemical devices. The temperature dependence of the conductivity was found to obey the Williams-Landel-Ferry relationship at temperatures over 60°C, thus suggesting that the ion conductivity in the composite electrolyte can be described by mechanisms normally taken t…

Conductive polymerMaterials scienceInorganic chemistryOxideGeneral ChemistryElectrolyteConductivityCondensed Matter PhysicsElectrochromic deviceschemistry.chemical_compoundchemistryZirconium phosphateElectrochromismGeneral Materials ScienceThermal stabilitySolid State Ionics
researchProduct

Design of experiment approach applied to reducing and oxidizing tolerance of anode supported solid oxide fuel cell. Part I: Microstructure optimizati…

2011

The main drawback of Ni/YSZ anode supports for solid oxide fuel cell application is their low tolerance to reducing and oxidizing (RedOx) atmosphere changes, owing to the Ni/NiO volume variation. This work describes a structured approach based on design of experiments for optimizing the microstructure for RedOx stability enhancement. A full factorial hypercube design and the response surface methodology are applied with the variables and their variation range defined as: (1) NiO proportion (40-60 wt% of the ceramic powders), (2) pore-former proportion (0-30 wt% corresponding to 0-64 vol.%), (3) NiO particle size (0.5-8 mu m) and (4) 8YSZ particle size (0.6-9 mu m).

ConductivityMaterials scienceDesign of experimentRenewable Energy Sustainability and the EnvironmentNon-blocking I/OEnergy Engineering and Power TechnologyRedOx stabilityCermetMicrostructureAnodeChemical engineeringSolid oxide fuel cellOxidizing agentCermetsSolid oxide fuel cellNi-YSZ anode supported cellResponse surface methodologyParticle sizeElectrical and Electronic EngineeringPhysical and Theoretical ChemistrySurface response methodologySofc AnodeReduction
researchProduct