Search results for "Scanning"
showing 10 items of 1808 documents
Individual-particle analysis of airborne dust samples collected over Morocco in 2006 during SAMUM 1
2011
During the course of SAMUM 1 in May and June 2006, airborne samples were collected in southern Morocco at altitudes between 830 and 3340 m above ground. We analysed approximately 22 500 particles of 1–30 μm by automated individual-particle analysis with a scanning electron microscope (SEM) and an energy-dispersive X-ray (EDX) analyser. The major difference between samples is due to the presence and amount of chlorine- and sulphur-bearing particles, pointing to a varying maritime influence and to different degrees of aging. In contrast, the desert dust component is very homogeneous independent of altitude, activated local source area, and dust storm intensity, implying very fast mixing of th…
Airborne investigation of the aerosols–cloud interactions in the vicinity and within a marine stratocumulus over the North Sea during EUCAARI (2008)
2013
Abstract Within the European Aerosol Cloud Climate and Air Quality Interactions (EUCAARI) project, the Meteo France research aircraft ATR-42 was operated from Rotterdam (Netherlands) airport during May 2008, to perform scientific flights dedicated to the investigation of aerosol–cloud interactions. The objective of this study is to illustrate the impact of cloud processing on the aerosol particle physical and chemical properties. The presented results are retrieved from measurements during flight operation with two consecutive flights, first from Rotterdam to Newcastle (United Kingdom) and subsequently reverse along the same waypoints back to Rotterdam using data measured with compact Time …
Surface spectroscopic study of the corrosion of ultrathin57Fe-evaporated and Langmuir-Blodgett films in humid SO2 environments
2000
Integral conversion electron Mossbauer spectroscopy (ICEMS), x-ray photoelectron spectroscopy (XPS), Auger electron spectroscopy (AES) and scanning electron microscopy (SEM) have been used to carry out a comparative study of the corrosion resistance against humid SO2-aggressive environments of ultrathin 57Fe films. These films, having a thickness ≤ 2.5 nm, have been prepared by evaporation of 57Fe under vacuum and by 57Fe coating by a Langmuir–Blodgett (LB) technique on SiO2/Si wafers. The results have shown that the corrosion resistance of the evaporated films is similar to that of massive Fe. However, the LB films show a remarkably higher corrosion resistance. Thus, although the Fe films …
Preparation by radio-frequency magnetron co-sputtering and characterization of thin films of lanthanum–strontium ferromanganites
2005
Abstract (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ films with y = 0, 0.2, 0.5, 0.8 and 1, a few hundred nanometers thick, were deposited onto polycrystalline yttria-stabilized zirconia YSZ by a magnetron co-sputtering technique using individual targets of La 0.8 Sr 0.2 MnO 3 and La 0.8 Sr 0.2 FeO 3 . The deposition parameters, substrate temperature and gas pressure, were studied by scanning electron microscopy, energy dispersive X-ray spectrometry, X-ray diffraction and interferential microscopy for their effects on the morphological, chemical, topographic and crystallographic properties of films and YSZ-film interfaces. (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ thin films were found to be …
Initial chemical transport of reducing elements and chemical reactions in oxide cathode base metal
2002
Abstract In the present work, the formation of compounds associated to the diffusion of reducing elements (Mg and Al) to the nickel surface of a one-piece oxide cathode has been studied. Those compounds have been evidenced after the annealing steps at high temperature performed on cathode base metal prior to the emitting coating deposition. Therefore, they form the “initial” interface between the nickel and the coating, in other words, the interface existing at the beginning of cathode life. Extensive analysis to characterize the nickel base prior to coating deposition has been performed by means of scanning electron microscopy (SEM) coupled with energy dispersive X-ray spectroscopy (EDX), …
A corrosion study of austenitic and martensitic steels under boiler conditions by means of 57Fe conversion electron mössbauer spectroscopy
1978
Abstract The growth of protective oxide layers on a martensitic FeCr (1.4122) and two austenitic FeCrNi steel samples (1.4550 and Incoloy 800) was studied by means of the 57Fe Conversion Electron Mossbauer Spectroscopy (CEMS). Scanning electron microscopy was applied to characterize the topographical nature of the oxide layers. Following a technical procedure of running-in steam generators, the steel specimens were oxidized in oxygen-free water at 295°C, 142 bar and a pH value between 9 and 10 for periods up to 70 h. In the case of the steels 1.4122 and 1.4550 the only oxide phase detected was non-stoichiometric magnetite, whereas nickel ferrite of nonstoichiometric composition was found…
Autocorrelation Metrics to Estimate Soil Moisture Persistence From Satellite Time Series: Application to Semiarid Regions
2021
Satellite-derived soil moisture (SM) products have become an important information source for the study of land surface processes in hydrology and land monitoring. Characterizing and estimating soil memory and persistence from satellite observations is of paramount relevance, and has deep implications in ecology, water management, and climate modeling. In this work, we address the problem of SM persistence estimation from microwave sensors using several autocorrelation metrics that, unlike traditional approaches, build on accurate estimates of the autocorrelation function from nonuniformly sampled time series. We show how the choice of the autocorrelation estimator can have a dramatic impac…
Green composites based on biodegradable polymers and anchovy (Engraulis Encrasicolus) waste suitable for 3D printing applications
2022
Every day large amounts of fish waste are produced and grossly discarded in markets around the world causing environmental and hygiene issue. The use of these scraps for the production of materials with higher added value can definitely contributed to solve this problem. In this work, 10% and 20% of anchovy fishbone powder (EE), obtained by market waste, were microbiological and mechanical tested and subsequently added to polylactic acid (PLA) and to a commercial blend of biodegradable co-polyesters (Mater-Bi®). Rheological characterization suggests the potential printability of all prepared composites filaments. 10% EE filled composites showed outstanding printability. Morphological analys…
Small GTP-binding proteins of the Rho- and Ras-subfamilies are not involved in the actin rearrangements induced by attaching and effacingEscherichia …
1998
Attaching and effacing Escherichia coli (AEEC) are extracellular pathogens that induce the formation of actin-rich structures at their sites of attachment to eukaryotic host cells. We analysed whether small GTP-binding proteins of the Rho- and Ras-subfamilies, which control the cellular actin system, are essential for these bacterial-induced microfilament reorganizations. For this purpose we specifically inactivated them using the Clostridium difficile toxins TcdB-10463 and TcdB-1470. Such treatment led to a dramatic breakdown of the normal actin cytoskeleton, but did not abrogate the bacterial-induced actin rearrangements. Our data therefore indicate that the microfilament reorganizations …
Bioencapsulation of living bacteria (Escherichia coli) with poly(silicate) after transformation with silicatein-α gene
2007
Bioencapsulation is an intriguing way to immobilize biological materials, including cells, in silica, metal-oxides or hybrid sol-gel polymers. Until now only the sol-gel precursor technology was utilized to immobilize bacteria or yeast cells in silica. With the discovery of silicatein, an enzyme from demosponges that catalyzes the formation of poly(silicate), it became possible to synthesize poly(silicate) under physiological (ambient) conditions. Here we show that Escherichia coli can be transformed with the silicatein gene, its expression level in the presence of isopropyl beta-D-thiogalactopyranoside (IPTG) can be efficiently intensified by co-incubation with silicic acid. This effect co…