Search results for "Smut"

A comparative study of photocatalytically active nanocrystalline tetragonal T zyrcon- type and monoclinic scheelite-type bismuth vanadate

2018

The authors from Vinča Institute of Nuclear Sciences acknowledge the financial support of the Ministry of Education, Science and Technological Development of the Republic of Serbia (Project no: 172056 ). The work of K. Smits was supported by Latvian National Research Program IMIS2 (Grant no. 302/2012 ).

The Influence of Morphological Aspects in the Reaction Pathway and Superconductive Properties of Bi2223-Ca2CuO3 Ceramic Composites

1994

ABSTRACTA variation of the solid-state matrix technique has been developed as a procedure for the preparation of 2223 bismuth superconducting phases [(Bi,Pb)2Sr2Ca1-nCunO4+2n, n=3]. The adequate processing of samples of nominal compositions 2223+x 0021, obtained both by this procedure and by the polymer matrix method, has allowed the modification of the microstructure of the calcium copper excess, with no noticeable change in that of the 2223 grains. The study of the phase evolution in the processing of the samples has shown that the formation rate of the 2223 phase is faster when the particle size of the calcium cuprate is smaller. A dependence of the intergranular superconducting properti…

Sensing properties of assembled Bi2S3nanowire arrays

2015

Bismuth sulfide (Bi2S3) nanowires were grown in porous aluminium oxide template and a selective chemical etching was applied to transfer the nanowires to a solution. Well aligned nanowire arrays were assembled on pre-patterned silicon substrates employing dielectrophoresis. Electron beam lithography was used to connect aligned individual nanowires to the common macroelectrode. In order to evaluate the conductometric sensing performance of the Bi2S3 nanowires, current–voltage characteristics were measured at different relative humidity (RH) levels (5–80%) / argon medium. The response of the Bi2S3 nanowires depending of RH is found to be considerably different from those reported for other ty…

Response of human endothelial cells to oxidative stress on Ti6Al4V alloy.

2007

Titanium and its alloys are amongst the most frequently used materials in bone and dental implantology. The good biocompatibility of titanium(-alloys) is attributed to the formation of a titanium oxide layer on the implant surface. However, implant failures do occur and this appears to be due to titanium corrosion. Thus, cells participating in the wound healing processes around an implanted material, among them endothelial cells, might be subjected to reactive oxygen species (ROS) formed by electrochemical processes during titanium corrosion. Therefore, we studied the response of endothelial cells grown on Ti6Al4V alloy to H(2)O(2) and compared this with the response of endothelial cells gr…

Bismuth-Catalyzed Growth of SnS2 Nanotubes and Their Stability

2009

Electroplated bismuth absorbers for planar NTD-Ge sensor arrays applied to hard x-ray detection in astrophysics

2018

Single sensors or small arrays of manually assembled neutron transmutation doped germanium (NTD-Ge) based microcalorimeters have been widely used as high energy-resolution detectors from infrared to hard X-rays. Several planar technological processes were developed in the last years aimed at the fabrication of NTD-Ge arrays, specifically designed to produce soft X-ray detectors. One of these processes consists in the fabrication of the absorbers. In order to absorb efficiently hard X-ray photons, the absorber has to be properly designed and a suitable material has to be employed. Bismuth offers interesting properties in terms of absorbing capability, of low heat capacity (needed to obtain h…

Application of electrochemical impedance for characterising arrays of Bi2S3 nanowires

2015

Abstract Electrochemical Impedance Spectroscopy (EIS) was used to characterise the electrical properties of bismuth sulphide (Bi2S3) nanowires (NWs) templated within anodic aluminium oxide (AAO) membranes. A specially engineered cell, with a nominal electrolyte volume of 0.1–0.2 ml, was used to hold and measure the electrochemical impedance of the fragile NW/AAO samples. An equivalent circuit model was developed to determine the filling density of nanowires within the porous templates. The EIS method can be utilised to probe the nanowire filling density in porous membranes over large sample areas, which is often unobtainable using electron microscopy and conductive atomic force microscopy t…

The Annealing Behavior of the Subsurface Zone Induced by Friction in Bismuth Detected by Positron Lifetime Technique

2013

The annealing behavior of the subsurface zone (SZ) in pure bismuth induced by dry sliding was studied using the positron lifetime measurement. This measurement allows us to detect the SZ and its recovery, and recrystallization processes. The comparative measurements of the sample exposed to compression revealed the thermal stability of the SZ. The compressed sample rebuilt its structure due to the recovery and recrystallization processes at the temperature of 60 °C, whereas the sample exposed to dry sliding does it at higher temperature of 260 °C, which is close to the melting point. The isothermal annealing at the temperature of 100 °C confirmed these results. The defect depth profile indu…

Role of Nanoelectromechanical Switching in the Operation of Nanostructured Bi2Se3 Interlayers between Conductive Electrodes

2016

We demonstrate a simple low-cost method of preparation of layered devices for opto- and thermoelectric applications. The devices consist of a functional Bi2Se3 layer of randomly oriented nanoplates and flexible nanobelts enclosed between two flat indium tin oxide (ITO) electrodes. The number of functional interconnections between the ITO electrodes and correspondingly the efficiency of the device can be increased by gradual nanoelectromechanical (NEM) switching of flexible individual Bi2Se3 nanobelts in the circuit. NEM switching is achieved through applying an external voltage to the device. For the first time, we investigate in situ NEM switching and breakdown parameters of Bi2Se3 nanobel…

Space charge limited current mechanism in Bi2S3 nanowires

2016

We report on the charge transport properties of individual Bi2S3 nanowires grown within the pores of anodized aluminum oxide templates. The mean pore diameter was 80 nm. Space charge limited current is the dominating conduction mechanism at temperatures below 160 K. Characteristic parameters of nanowires, such as trap concentration and trap characteristic energy, were estimated from current-voltage characteristics at several temperatures.