Search results for "Surfaces and interfaces"
showing 10 items of 939 documents
Localization of n-alcohols and structural effects in aqueous solutions of sodium dodecyl sulfate
1997
Small-angle neutron Mattering measurements OD sodium dodecyl sulfate aqueous solutions have been performed in the presence of n-alcohols, from methanol to octanol, at different alcohol concentrations. By modeling the experimental intensities, it was possible to obtain structural information and to derive simultaneously the distribution of the alcohols between the aqueous and the micellar phases. It was found that short chain alcohols tend to remain in the aqueous phase and, by altering the solvent properties, induce a decrease in the aggregation number of sodium dodecyl sulfate micelles. On the other hand, alcohols with longer hydrocarbon chains were found to be present in both phases thoug…
Mechanical and electroconductive properties of spatially distributed double stranded DNA arrays on Au (111)
2008
Abstract Conductive AFM was used to investigate electroconductivity through 10 nm long double stranded DNA molecules in mixed monolayers of thioalkylated-DNA and mercaptohexanol (MCH) on Au (111) surface. The distribution of DNA molecules on the surface was analyzed by tapping mode AFM. Measurements performed in lift mode confirmed that the DNA molecules protrude from the surface rather than lie horizontally adsorbed on the interface. The optimal conductivity measurement time, which is shorter than the mechanical relaxation time of oligonucleotide duplexes, was determined. It was concluded that oligonucleotide duplexes have a resistance of the order of ~ 2 Ω ⁎ m at 1 V.
Pulsed X‐Ray Radiation Responses of Solarization‐Resistant Optical Fibers
2018
International audience; The transient radiation‐induced attenuation (RIA) of two different versions of pure‐silica‐core (PSC) multimode optical fibers (so‐called “solarization‐resistant” fibers) exposed to nanosecond 1 MeV X‐ray pulses are investigated. On‐line RIA spectra measurements at both room temperature (RT) and liquid nitrogen temperatures (LNT) in the range 1–3.5 eV are performed. Following the RIA kinetics, the properties of the metastable defects that are bleached just after the pulse are discussed. The spectral decomposition of the RIA is performed using known Gaussian bands associated to point defects absorbing in this spectral range. For both fiber types, the generation and th…
Performance Analysis of a Prototype High‐Concentration Photovoltaic System Coupled to Silica Optical Fibers
2021
High-concentration photovoltaic (HCPV) systems are one of the most promising technologies for the generation of renewable energy with high-conversion efficiency. Their development is still at an early stage, but the possibility of integrating high-concentration systems into buildings offers new opportunities to achieve the net-zero-energy building goal. Herein, the optical and energetic performance of a hybrid daylighting−HCPV prototype based on pure- or doped-silica optical fibers (OFs) to guide 2000× concentrated sunlight inside the buildings is evaluated. There, the light can either be used to illuminate interior spaces or projected on solar cells to generate electricity. The system equi…
Surface modifications induced by pulsed-laser texturing—Influence of laser impact on the surface properties
2014
Abstract Laser cleaning technology provides a safe, environmentally friendly and very cost effective way to improve cleaning and surface preparation of metallic materials. Compared with efficient cleaning processes, it can avoid the disadvantages of ductile materials prepared by conventional technologies (cracks induced by sand-blasting for example) and treat only some selected areas (due to the optical fibers). By this way, laser technology could have several advantages and expand the range of thermal spraying. Moreover, new generations of lasers (fiber laser, disc laser) allow the development of new methods. Besides a significant bulk reduction, no maintenance, low operating cost, laser f…
Determination of charge carrier mobility of hole transporting polytriarylamine-based diodes
2010
Hole transport properties of three different side chain poly(triarylamines) have been determined by means of the analysis of steady-state current-voltage characteristics using co-planar diode structures. The interpretation is based on space-charge limited models with field-dependent mobility. Mobilities between ~ 10- 8 and 10- 6 cm2 V- 1 s- 1 are obtained. The highest mobility is achieved for poly(tetraphenylbenzidine) devices and the lowest for poly(triphenylamine) devices. Electron-rich methoxy substituents increase the mobility of poly(triphenylamine)s. A comparison of the mobility values with those obtained using organic field-effect transistors is also given. © 2009 Elsevier B.V. All r…
Polymer solar cells with novel fullerene-based acceptor
2004
Abstract Alternative acceptor materials are possible candidates to improve the optical absorption and/or the open circuit voltage of polymer–fullerene solar cells. We studied a novel fullerene-type acceptor, DPM-12, for application in polymer–fullerene bulk heterojunction photovoltaic devices. Though DPM-12 has the identical redox potentials as methanofullerene PCBM, surprisingly high open circuit voltages in the range V OC =0.95 V were measured for OC 1 C 10 -PPV:DPM-12-based samples. The potential for photovoltaic application was studied by means of photovoltaic characterization of solar cells including current–voltage measurements and external quantum yield spectroscopy. Further studies …
Statistical characterization of self-assembled charged nanoparticle structures
2013
We propose a novel approach for description of dynamics of nanostructure formation for a system consisting of oppositely charged particles. The combination of numerical solution of analytical Bogolyubov–Born–Green–Kirkwood–Yvon (BBGKY) type equation set with reverse Monte Carlo (RMC) method allows us to overcome difficulties of standard approaches, such as kinetic Monte Carlo or Molecular Dynamics, to describe effects of long-range Coulomb interactions. Moreover, this allows one to study the system dynamics on realistic time and length scales. We applied this method to a simple short-range Lenard–Jones (LJ)-like three- (3D) and two-dimensional (2D) system combining the long-range Coulomb an…
Sputtered cuprous oxide thin films and nitrogen doping by ion implantation
2016
Abstract The structural, optical and electrical properties of sputtered cuprous oxide thin films have been optimized through post-deposition thermal treatments. Moreover we have studied the effects of nitrogen doping introduced by ion implantation followed by the optimized oxidant thermal annealing. Three concentrations have been used, 0.6 N%, 1.2 N%, and 2.5 N%. Along with the preservation of the Cu 2 O phase, a slight optical band gap narrowing and a significant conductivity enhancement has been observed with respect to the undoped samples. These results can be justified by the absence of further oxygen vacancies promoted by dopant introduction and by the substitution of O atoms by N ones…
A comparative analysis of electron spectroscopy and first-principles studies on Cu(Pd) adsorption on MgO
2006
Ultrathin MgO films were grown on a W(1 1 0) substrate while metastable impact electron (MIES) and photoelectron (UPS) spectra were measured in situ; apart from the valence band emission, no additional spectral features were detected. The oxide surface was exposed to metal atoms (Cu, Pd) at RT. A comparison with the DOS extracted from first-principles DFT calculations shows that the metal-induced intensity developing above the top of the O 2p valence band in the UP spectra under Cu(Pd) exposure is caused by Cu 3d (Pd 4d) emission. The emission seen in the MIES spectra is attributed to the ionization of Cu 3d and 4s states of adsorbed neutral Cu atoms in an Auger process, Auger neutralizatio…