Search results for "Surfaces"

showing 10 items of 2837 documents

A comparative study of carboxy myoglobin in saccharide-water systems by molecular dynamics simulation.

2007

Results from room-temperature molecular dynamics simulation on a system containing carboxy-myoglobin, water, and maltose molecules are reported. Protein atomic fluctuations, protein−solvent and solvent−solvent hydrogen bonding have been analyzed and compared to the ones in trehalose−water and sucrose−water systems (Proteins 2005, 59, 291−302). Results help in rationalizing, at a molecular level, the effects of homologues disaccharides on protein structure/dynamics experimentally observed. Furthermore, the effectiveness of disaccharides in bioprotection in terms of peculiar protein−matrix coupling is also discussed.

SucroseHydrogen bondMyoglobinmyoglobin simulation conformational substates disaccharideTrehaloseWaterHydrogen BondingMaltoseSurfaces Coatings and FilmsProtein Structure Tertiarychemistry.chemical_compoundMolecular dynamicsProtein structureMolecular levelchemistryMyoglobinModels ChemicalComputational chemistryMaterials ChemistryMoleculeComputer SimulationPhysical and Theoretical ChemistryMaltoseThe journal of physical chemistry. B
researchProduct

Thermal Aggregation of Bovine Serum Albumin in Trehalose and Sucrose Aqueous Solutions

2012

We report results of static and dynamic light scattering measurements performed on bovine serum albumin (BSA) in saccharide (trehalose and sucrose) solutions. Our aim is to study the effects of the two disaccharides on the first steps of thermal aggregation of BSA in aqueous solutions at two protein concentrations (1 and 30 mg/mL) at increasing sugar/water ratio. Results show that sugars modify early stages of aggregation mainly by perturbing the thermodynamic behavior of the solvent (i.e., general solvent effects) without involving direct, specific sugar-protein interactions. This agrees with current hypotheses on sugar action in protein solutions. (1-3) The linear correlation detected bet…

SucroseSucrosechemistry.chemical_compoundDynamic light scatteringMaterials ChemistryAnimalsTransition TemperaturePhysical and Theoretical ChemistryBovine serum albuminProtein Structure QuaternarySugarChromatographyAqueous solutionbiologyTemperatureTrehaloseWaterSerum Albumin BovineTrehaloseSettore FIS/07 - Fisica Applicata(Beni Culturali Ambientali Biol.e Medicin)Surfaces Coatings and FilmsSolutionsSolventtrehalose protein aggregation solvent effects light scatteringchemistrySolventsbiology.proteinCattleProtein MultimerizationSolvent effectsThe Journal of Physical Chemistry B
researchProduct

Inhibitoren der Korrosion (9) Nachweis der Sekundärinhibitoren bei einigen Sulfoxiden, Triphenylarsinoxid und einigen Sulfoniumsalzen

1971

Die Schutzwerte von Dibenzylsulf-oxyd und strukturell verwandten Ver-bindungen sowie von Triphenylarsin-oxyd werden bestimmt. Sulfoxyde und Arsinoxyde werden (a) nach Protonierung in die kathodischen Bereiche gefuhrt und (b) nach Elektronenaufnahme in die ko-ordinationsfahigen Sekundarinhibitoren (Thioather und tert. Arsine) umgewan-delt. Die Sekundarinhibitoren ziehen entweder auf das Metall auf und unter-drucken dann die Auflosung des Eisens oder werden nicht am Metall fixiert (z. B. Diphenylsulfid) und entfalten dann keinen Schutz. Im Falle des Dibenzyl-sulfoxyds konnen ca. 90% des einge-setzten Dibenzylsulfoxyds als Dibenzyl-sulfid vom Eisen abgelost werden; 16% an unverandertem Dibenzy…

SulfoniumMechanical EngineeringMetals and AlloysOxideProtonationSulfoxideGeneral MedicineSurfaces Coatings and FilmsMetalchemistry.chemical_compoundArsinechemistryMechanics of MaterialsHydrogen Sulfatevisual_artPolymer chemistryMaterials ChemistryDibenzyl sulfidevisual_art.visual_art_mediumEnvironmental ChemistryMaterials and Corrosion/Werkstoffe und Korrosion
researchProduct

Isolation, dynamic NMR study and X-ray characterisation of a bis sulfonium zirconocene-ate dimer.

2004

The novel dimer [Cp(2)Zr[upper bond start]([minus sign in circle])S([plus sign in circle])CH(Ph)CH[double bond]C[upper bond end]PPh(2)](2), the first example of a structurally characterised sulfur-bridged binuclear zirconathiolane complex, was prepared, characterised by NMR spectroscopy and X-ray crystallography, and some aspects of its solution behaviour were studied.

SulfoniumStereochemistryDimerMetals and AlloysX-rayGeneral ChemistryNuclear magnetic resonance spectroscopyCatalysisSurfaces Coatings and FilmsElectronic Optical and Magnetic Materialschemistry.chemical_compoundchemistryMaterials ChemistryCeramics and CompositesChemical communications (Cambridge, England)
researchProduct

Micrometer-size crystalline monolayer MoS2 domains obtained by sulfurization of molybdenum oxide ultrathin films

2023

In this work, the formation of micrometer-size crystalline monolayer (1L) MoS2 flakes with triangular shape and a central multilayer core is obtained by the sulfurization at 800 °C of pre-deposited ultrathin MoOx films (1.2–1.8 nm) on c-sapphire substrates. The thickness uniformity, crystalline quality, doping and strain distribution in the MoS2 flakes as a function of the initial MoOx thickness was evaluated by micro-Raman (μR) mapping. The excellent crystalline quality of the triangular 1L-MoS2 flakes was confirmed by micro-photoluminescence (μPL) maps, showing a very intense peak at ∼1.85 eV, that decreases in the central part, as expected for multilayers MoS2. A biaxial strain of ∼0.38–…

SulfurizationRaman spectroscopySettore FIS/01 - Fisica SperimentaleElectrical and Electronic EngineeringCondensed Matter PhysicsMoS2PhotoluminescenceAtomic and Molecular Physics and OpticsTransmission electron microscopySurfaces Coatings and FilmsElectronic Optical and Magnetic Materials
researchProduct

A set-up for simultaneous measurement of second harmonic generation and streaming potential and some test applications.

2018

We present a measurement cell that allows simultaneous measurement of second harmonic generation (SHG) and streaming potential (SP) at mineral-water interfaces with flat specimen that are suitable for non-linear optical (NLO) studies. The set-up directly yields SHG data for the interface of interest and can also be used to obtain information concerning the influence of flow on NLO signals from that interface. The streaming potential is at present measured against a reference substrate (PTFE). The properties of this inert reference can be independently determined for the same conditions. With the new cell, for the first time the SHG signal and the SP for flat surfaces have been simultaneousl…

Sum-frequency generationSecond-harmonic generation02 engineering and technology010402 general chemistry021001 nanoscience & nanotechnology01 natural sciencesSignalMolecular physicsStreaming current0104 chemical sciencesSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsBiomaterialsElectrokinetic phenomenaColloid and Surface ChemistryFlow velocityPoint of zero charge0210 nano-technologyPolarization (electrochemistry)Journal of colloid and interface science
researchProduct

Thermal, electric and spin transport in superconductor/ferromagnetic-insulator structures

2019

A ferromagnetic insulator (FI) attached to a conventional superconductor (S) changes drastically the properties of the latter. Specifically, the exchange field at the FI/S interface leads to a splitting of the superconducting density of states. If S is a superconducting film, thinner than the superconducting coherence length, the modification of the density of states occurs over the whole sample. The co-existence of the exchange splitting and superconducting correlations in S/FI structures leads to striking transport phenomena that are of interest for applications in thermoelectricity, superconducting spintronics and radiation sensors. Here we review the most recent progress in understandin…

Superconducting coherence length---FOS: Physical sciencesInsulator (electricity)02 engineering and technology01 natural sciencesSuperconductivity (cond-mat.supr-con)Condensed Matter::Superconductivity0103 physical sciencesMesoscale and Nanoscale Physics (cond-mat.mes-hall)SuperconductivityPhysicsCondensed Matter - Materials Science010304 chemical physicsCondensed matter physicsSpintronicsCondensed Matter - Mesoscale and Nanoscale PhysicsCondensed Matter - SuperconductivityMaterials Science (cond-mat.mtrl-sci)Surfaces and InterfacesGeneral Chemistry021001 nanoscience & nanotechnologyCondensed Matter Physics3. Good healthSurfaces Coatings and FilmsConventional superconductorFerromagnetismDensity of states0210 nano-technologyTransport phenomenaProgress in Surface Science
researchProduct

First heavy ion beam tests with a superconducting multigap CH cavity

2018

Physical review accelerators and beams 21(2), 020102 (2018). doi:10.1103/PhysRevAccelBeams.21.020102

SuperconductivityPhysicsNuclear and High Energy PhysicsPhysics and Astronomy (miscellaneous)Mass-to-charge ratio010308 nuclear & particles physicsSurfaces and InterfacesInjector53001 natural sciencesLinear particle acceleratorlaw.inventionIonNuclear physicsAccelerationlaw0103 physical scienceslcsh:QC770-798Physics::Accelerator PhysicsContinuous wavelcsh:Nuclear and particle physics. Atomic energy. Radioactivityddc:530010306 general physicsBeam (structure)Physical Review Accelerators and Beams
researchProduct

Observable Variables in Thermoelectric Phenomena

2002

New transport equations for the thermoelectric phenomena have been deduced. All of the variables in this formulation are observable quantities. The limitations of the usual formulations, which work with nonobservable quantities, have been overcome. The electric potential can be measured by using auxiliary probes which connect the electronic conductor to a potentiometer. This observable electric potential depends on the nature of the probes but not on the room temperature where the potentiometer is placed. Also, we emphasize that absolute values for the thermoelectric power are in contradiction with the thermodynamic limitation of measuring electric potential differences in these systems. Th…

SuperconductivityWork (thermodynamics)ChemistryThermodynamicsObservableSurfaces Coatings and FilmsConductorQuantum electrodynamicsSeebeck coefficientThermoelectric effectMaterials ChemistryPotentiometerElectric potentialPhysical and Theoretical ChemistryThe Journal of Physical Chemistry B
researchProduct

Critical Micelle Density for the Self-Assembly of Block Copolymer Surfactants in Supercritical Carbon Dioxide

1999

The parameters which influence the self-assembly of molecules in solution include the temperature and solvent quality, and this study illustrates the use of these variables to regulate the degree of association of block copolymer amphiphiles in highly compressible supercritical carbon dioxide. Small-angle neutron scattering (SANS) has been used to examine the association behavior of a block copolymer containing a CO2-phobic moiety, poly(vinyl acetate), and a CO2-philic block, poly(1,1-dihydroperfluoro-octylacrylate). By adjustment of the density of the medium through pressure and temperature profiling, the self-assembly can be reversibly controlled from unimers to core−shell spherical micel…

Supercritical carbon dioxideMaterials scienceSurfaces and InterfacesNeutron scatteringCondensed Matter PhysicsMicelleSupercritical fluidSolventchemistry.chemical_compoundChemical engineeringchemistryAmphiphilePolymer chemistryElectrochemistryCopolymerVinyl acetateGeneral Materials ScienceSpectroscopyLangmuir
researchProduct